Merge branch 'for-usb-linus' of...

Merge branch 'for-usb-linus' of git+ssh://master.kernel.org/pub/scm/linux/kernel/git/sarah/xhci into usb-linus

* 'for-usb-linus' of git+ssh://master.kernel.org/pub/scm/linux/kernel/git/sarah/xhci:
  USB: xhci - fix interval calculation for FS isoc endpoints
  xhci: Disable MSI for some Fresco Logic hosts.
  xhci: Do not issue device reset when device is not setup
  xhci: Add defines for hardcoded slot states
  xhci: Bigendian fix for xhci_check_bandwidth()
  xhci: Bigendian fix for skip_isoc_td()

drivers/usb/host/xhci-dbg.c

@@ -438,13 +438,13 @@ char *xhci_get_slot_state(struct xhci_hcd *xhci,
 	struct xhci_slot_ctx *slot_ctx = xhci_get_slot_ctx(xhci, ctx);
 
 	switch (GET_SLOT_STATE(le32_to_cpu(slot_ctx->dev_state))) {
-	case 0:
+	case SLOT_STATE_ENABLED:
 		return "enabled/disabled";
-	case 1:
+	case SLOT_STATE_DEFAULT:
 		return "default";
-	case 2:
+	case SLOT_STATE_ADDRESSED:
 		return "addressed";
-	case 3:
+	case SLOT_STATE_CONFIGURED:
 		return "configured";
 	default:
 		return "reserved";

drivers/usb/host/xhci-mem.c

@@ -985,9 +985,19 @@ static unsigned int xhci_parse_exponent_interval(struct usb_device *udev,
 	interval = clamp_val(ep->desc.bInterval, 1, 16) - 1;
 	if (interval != ep->desc.bInterval - 1)
 		dev_warn(&udev->dev,
-			 "ep %#x - rounding interval to %d microframes\n",
+			 "ep %#x - rounding interval to %d %sframes\n",
 			 ep->desc.bEndpointAddress,
-			 1 << interval);
+			 1 << interval,
+			 udev->speed == USB_SPEED_FULL ? "" : "micro");
+
+	if (udev->speed == USB_SPEED_FULL) {
+		/*
+		 * Full speed isoc endpoints specify interval in frames,
+		 * not microframes. We are using microframes everywhere,
+		 * so adjust accordingly.
+		 */
+		interval += 3;	/* 1 frame = 2^3 uframes */
+	}
 
 	return interval;
 }

drivers/usb/host/xhci-pci.c

@@ -106,12 +106,22 @@ static int xhci_pci_setup(struct usb_hcd *hcd)
 
 	/* Look for vendor-specific quirks */
 	if (pdev->vendor == PCI_VENDOR_ID_FRESCO_LOGIC &&
-			pdev->device == PCI_DEVICE_ID_FRESCO_LOGIC_PDK &&
-			pdev->revision == 0x0) {
+			pdev->device == PCI_DEVICE_ID_FRESCO_LOGIC_PDK) {
+		if (pdev->revision == 0x0) {
 			xhci->quirks |= XHCI_RESET_EP_QUIRK;
 			xhci_dbg(xhci, "QUIRK: Fresco Logic xHC needs configure"
 					" endpoint cmd after reset endpoint\n");
+		}
+		/* Fresco Logic confirms: all revisions of this chip do not
+		 * support MSI, even though some of them claim to in their PCI
+		 * capabilities.
+		 */
+		xhci->quirks |= XHCI_BROKEN_MSI;
+		xhci_dbg(xhci, "QUIRK: Fresco Logic revision %u "
+				"has broken MSI implementation\n",
+				pdev->revision);
 	}
+
 	if (pdev->vendor == PCI_VENDOR_ID_NEC)
 		xhci->quirks |= XHCI_NEC_HOST;
 

drivers/usb/host/xhci-ring.c

@@ -1782,7 +1782,7 @@ static int skip_isoc_td(struct xhci_hcd *xhci, struct xhci_td *td,
 	struct usb_iso_packet_descriptor *frame;
 	int idx;
 
-	ep_ring = xhci_dma_to_transfer_ring(ep, event->buffer);
+	ep_ring = xhci_dma_to_transfer_ring(ep, le64_to_cpu(event->buffer));
 	urb_priv = td->urb->hcpriv;
 	idx = urb_priv->td_cnt;
 	frame = &td->urb->iso_frame_desc[idx];

drivers/usb/host/xhci.c

@@ -430,12 +430,19 @@ int xhci_run(struct usb_hcd *hcd)
 		free_irq(hcd->irq, hcd);
 	hcd->irq = -1;
 
+	/* Some Fresco Logic host controllers advertise MSI, but fail to
+	 * generate interrupts.  Don't even try to enable MSI.
+	 */
+	if (xhci->quirks & XHCI_BROKEN_MSI)
+		goto legacy_irq;
+
 	ret = xhci_setup_msix(xhci);
 	if (ret)
 		/* fall back to msi*/
 		ret = xhci_setup_msi(xhci);
 
 	if (ret) {
+legacy_irq:
 		/* fall back to legacy interrupt*/
 		ret = request_irq(pdev->irq, &usb_hcd_irq, IRQF_SHARED,
 					hcd->irq_descr, hcd);
@@ -1849,8 +1856,8 @@ int xhci_check_bandwidth(struct usb_hcd *hcd, struct usb_device *udev)
 
 	/* Free any rings that were dropped, but not changed. */
 	for (i = 1; i < 31; ++i) {
-		if ((ctrl_ctx->drop_flags & (1 << (i + 1))) &&
-				!(ctrl_ctx->add_flags & (1 << (i + 1))))
+		if ((le32_to_cpu(ctrl_ctx->drop_flags) & (1 << (i + 1))) &&
+		    !(le32_to_cpu(ctrl_ctx->add_flags) & (1 << (i + 1))))
 			xhci_free_or_cache_endpoint_ring(xhci, virt_dev, i);
 	}
 	xhci_zero_in_ctx(xhci, virt_dev);
@@ -2467,6 +2474,7 @@ int xhci_discover_or_reset_device(struct usb_hcd *hcd, struct usb_device *udev)
 	struct xhci_command *reset_device_cmd;
 	int timeleft;
 	int last_freed_endpoint;
+	struct xhci_slot_ctx *slot_ctx;
 
 	ret = xhci_check_args(hcd, udev, NULL, 0, false, __func__);
 	if (ret <= 0)
@@ -2499,6 +2507,12 @@ int xhci_discover_or_reset_device(struct usb_hcd *hcd, struct usb_device *udev)
 			return -EINVAL;
 	}
 
+	/* If device is not setup, there is no point in resetting it */
+	slot_ctx = xhci_get_slot_ctx(xhci, virt_dev->out_ctx);
+	if (GET_SLOT_STATE(le32_to_cpu(slot_ctx->dev_state)) ==
+						SLOT_STATE_DISABLED)
+		return 0;
+
 	xhci_dbg(xhci, "Resetting device with slot ID %u\n", slot_id);
 	/* Allocate the command structure that holds the struct completion.
 	 * Assume we're in process context, since the normal device reset

drivers/usb/host/xhci.h

@@ -560,6 +560,11 @@ struct xhci_slot_ctx {
 #define SLOT_STATE	(0x1f << 27)
 #define GET_SLOT_STATE(p)	(((p) & (0x1f << 27)) >> 27)
 
+#define SLOT_STATE_DISABLED	0
+#define SLOT_STATE_ENABLED	SLOT_STATE_DISABLED
+#define SLOT_STATE_DEFAULT	1
+#define SLOT_STATE_ADDRESSED	2
+#define SLOT_STATE_CONFIGURED	3
 
 /**
  * struct xhci_ep_ctx
@@ -1302,6 +1307,7 @@ struct xhci_hcd {
  * commands.
  */
 #define XHCI_EP_LIMIT_QUIRK	(1 << 5)
+#define XHCI_BROKEN_MSI		(1 << 6)
 	unsigned int		num_active_eps;
 	unsigned int		limit_active_eps;
 	/* There are two roothubs to keep track of bus suspend info for */