igb: support BCM54616 PHY

The management port on an Edgecore AS7712-32 switch uses an igb MAC, but
it uses a BCM54616 PHY. Without a patch like this, loading the igb
module produces dmesg output like this:

[    3.439125] igb: Copyright (c) 2007-2014 Intel Corporation.
[    3.439866] igb: probe of 0000:00:14.0 failed with error -2
Signed-off-by: John W Linville <linville@tuxdriver.com>
Cc: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/igb/e1000_82575.c

@@ -340,6 +340,9 @@ static s32 igb_init_phy_params_82575(struct e1000_hw *hw)
 		phy->ops.set_d3_lplu_state = igb_set_d3_lplu_state_82580;
 		phy->ops.force_speed_duplex = igb_phy_force_speed_duplex_m88;
 		break;
+	case BCM54616_E_PHY_ID:
+		phy->type = e1000_phy_bcm54616;
+		break;
 	default:
 		ret_val = -E1000_ERR_PHY;
 		goto out;
@@ -1659,6 +1662,9 @@ static s32 igb_setup_copper_link_82575(struct e1000_hw *hw)
 	case e1000_phy_82580:
 		ret_val = igb_copper_link_setup_82580(hw);
 		break;
+	case e1000_phy_bcm54616:
+		ret_val = 0;
+		break;
 	default:
 		ret_val = -E1000_ERR_PHY;
 		break;

drivers/net/ethernet/intel/igb/e1000_defines.h

@@ -889,6 +889,7 @@
 #define I210_I_PHY_ID        0x01410C00
 #define M88E1543_E_PHY_ID    0x01410EA0
 #define M88E1512_E_PHY_ID    0x01410DD0
+#define BCM54616_E_PHY_ID    0x03625D10
 
 /* M88E1000 Specific Registers */
 #define M88E1000_PHY_SPEC_CTRL     0x10  /* PHY Specific Control Register */

drivers/net/ethernet/intel/igb/e1000_hw.h

@@ -128,6 +128,7 @@ enum e1000_phy_type {
 	e1000_phy_ife,
 	e1000_phy_82580,
 	e1000_phy_i210,
+	e1000_phy_bcm54616,
 };
 
 enum e1000_bus_type {