x86/boot: Add xloadflags bits to check for 5-level paging support

The current kernel supports 5-level paging mode, and supports dynamically
choosing the paging mode during bootup depending on the kernel image,
hardware and kernel parameter settings. This flexibility brings several
issues to kexec/kdump:

1) Dynamic switching between paging modes requires support in the target
   kernel. This means kexec from a 5-level paging kernel into a kernel
   which does not support mode switching is not possible. So the loader
   needs to be able to analyze the supported paging modes of the kexec
   target kernel.

2) If running on a 5-level paging kernel and the kexec target kernel is a
   4-level paging kernel, the target immage cannot be loaded above the 64TB
   address space limit. But the kexec loader searches for a load area from
   top to bottom which would eventually put the target kernel above 64TB
   when the machine has large enough RAM size. So the loader needs to be
   able to analyze the paging mode of the target kernel to load it at a
   suitable spot in the address space.

Solution:

Add two bits XLF_5LEVEL and XLF_5LEVEL_ENABLED:

 - Bit XLF_5LEVEL indicates whether 5-level paging mode switching support
   is available. (Issue #1)

 - Bit XLF_5LEVEL_ENABLED indicates whether the kernel was compiled with
   full 5-level paging support (CONFIG_X86_5LEVEL=y). (Issue #2)

The loader will use these bits to verify whether the target kernel is
suitable to be kexec'ed to from a 5-level paging kernel and to determine
the constraints of the target kernel load address.

The flags will be used by the kernel kexec subsystem and the userspace
kexec tools.

[ tglx: Massaged changelog ]
Signed-off-by: Baoquan He <bhe@redhat.com>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Acked-by: Kirill A. Shutemov <kirill.shutemov@linux.intel.com>
Cc: bp@alien8.de
Cc: hpa@zytor.com
Cc: dyoung@redhat.com
Link: https://lkml.kernel.org/r/20190524073810.24298-2-bhe@redhat.com

arch/x86/boot/header.S

@@ -419,7 +419,17 @@ xloadflags:
 # define XLF4 0
 #endif
 
-			.word XLF0 | XLF1 | XLF23 | XLF4
+#ifdef CONFIG_X86_64
+#ifdef CONFIG_X86_5LEVEL
+#define XLF56 (XLF_5LEVEL|XLF_5LEVEL_ENABLED)
+#else
+#define XLF56 XLF_5LEVEL
+#endif
+#else
+#define XLF56 0
+#endif
+
+			.word XLF0 | XLF1 | XLF23 | XLF4 | XLF56
 
 cmdline_size:   .long   COMMAND_LINE_SIZE-1     #length of the command line,
                                                 #added with boot protocol

arch/x86/include/uapi/asm/bootparam.h

@@ -29,6 +29,8 @@
 #define XLF_EFI_HANDOVER_32		(1<<2)
 #define XLF_EFI_HANDOVER_64		(1<<3)
 #define XLF_EFI_KEXEC			(1<<4)
+#define XLF_5LEVEL			(1<<5)
+#define XLF_5LEVEL_ENABLED		(1<<6)
 
 #ifndef __ASSEMBLY__