drm/i915: Sanitize BIOS debugging bits from PIPECONF

Quoting the BSpec from time immemorial:

  PIPEACONF, bits 28:27: Frame Start Delay (Debug)

  Used to delay the frame start signal that is sent to the display planes.
  Care must be taken to insure that there are enough lines during VBLANK
  to support this setting.

An instance of the BIOS leaving these bits set was found in the wild,
where it caused our modesetting to go all squiffy and skewiff.

Bugzilla: https://bugs.freedesktop.org/show_bug.cgi?id=47271Reported-and-tested-by: Eva Wang <evawang@linpus.com>
Bugzilla: https://bugzilla.kernel.org/show_bug.cgi?id=43012Reported-and-tested-by: Carl Richell <carl@system76.com>
Cc: stable@kernel.org
Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>

drivers/gpu/drm/i915/i915_reg.h

@@ -2385,6 +2385,7 @@
 #define   PIPECONF_DISABLE	0
 #define   PIPECONF_DOUBLE_WIDE	(1<<30)
 #define   I965_PIPECONF_ACTIVE	(1<<30)
+#define   PIPECONF_FRAME_START_DELAY_MASK (3<<27)
 #define   PIPECONF_SINGLE_WIDE	0
 #define   PIPECONF_PIPE_UNLOCKED 0
 #define   PIPECONF_PIPE_LOCKED	(1<<25)

drivers/gpu/drm/i915/intel_display.c

@@ -7580,6 +7580,12 @@ static void intel_sanitize_modesetting(struct drm_device *dev,
 	struct drm_i915_private *dev_priv = dev->dev_private;
 	u32 reg, val;
 
+	/* Clear any frame start delays used for debugging left by the BIOS */
+	for_each_pipe(pipe) {
+		reg = PIPECONF(pipe);
+		I915_WRITE(reg, I915_READ(reg) & ~PIPECONF_FRAME_START_DELAY_MASK);
+	}
+
 	if (HAS_PCH_SPLIT(dev))
 		return;