Commit f6603ff2 authored by Sujith Manoharan's avatar Sujith Manoharan Committed by Kalle Valo

ath10k: Fix DMA burst size

A value of zero indicates that 128B is the maximum
DMA request size for read/writes. But PCI cards based
on AR9880 can support 256B, so enable this for
the 10.2 firmware.
Signed-off-by: default avatarSujith Manoharan <c_manoha@qca.qualcomm.com>
Signed-off-by: default avatarKalle Valo <kvalo@qca.qualcomm.com>
parent 350b193e
......@@ -183,6 +183,9 @@ struct ath10k_pktlog_hdr {
#define TARGET_10X_NUM_MSDU_DESC (1024 + 400)
#define TARGET_10X_MAX_FRAG_ENTRIES 0
/* 10.2 parameters */
#define TARGET_10_2_DMA_BURST_SIZE 1
/* Target specific defines for WMI-TLV firmware */
#define TARGET_TLV_NUM_VDEVS 3
#define TARGET_TLV_NUM_STATIONS 32
......
......@@ -3744,7 +3744,7 @@ static struct sk_buff *ath10k_wmi_10_2_op_gen_init(struct ath10k *ar)
config.mcast2ucast_mode = __cpu_to_le32(TARGET_10X_MCAST2UCAST_MODE);
config.tx_dbg_log_size = __cpu_to_le32(TARGET_10X_TX_DBG_LOG_SIZE);
config.num_wds_entries = __cpu_to_le32(TARGET_10X_NUM_WDS_ENTRIES);
config.dma_burst_size = __cpu_to_le32(TARGET_10X_DMA_BURST_SIZE);
config.dma_burst_size = __cpu_to_le32(TARGET_10_2_DMA_BURST_SIZE);
config.mac_aggr_delim = __cpu_to_le32(TARGET_10X_MAC_AGGR_DELIM);
val = TARGET_10X_RX_SKIP_DEFRAG_TIMEOUT_DUP_DETECTION_CHECK;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment