[PATCH] uml: fixlet for arch_prctl_skas

Fix it a bit (after some cross checking with "man arch_prctl"). There were:
*) typos FS/GS and back
*) FS in place of FS_BASE (and the same for GS)
*) the procedure used put_user on &addr, where addr was the parameter (i.e.
changed its param with put_user, completely useless) rather than interpreting
addr as a pointer, as requested in this case (see the man page).
Signed-off-by: Paolo 'Blaisorblade' Giarrusso <blaisorblade@yahoo.it>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

arch/um/sys-x86_64/syscalls.c

@@ -133,23 +133,27 @@ static long arch_prctl_tt(int code, unsigned long addr)
 
 #ifdef CONFIG_MODE_SKAS
 
+/* XXX: Must also call arch_prctl in the host, beside saving the segment bases! */
 static long arch_prctl_skas(int code, unsigned long addr)
 {
 	long ret = 0;
 
 	switch(code){
-	case ARCH_SET_GS:
-		current->thread.regs.regs.skas.regs[GS_BASE / sizeof(unsigned long)] = addr;
-		break;
 	case ARCH_SET_FS:
 		current->thread.regs.regs.skas.regs[FS_BASE / sizeof(unsigned long)] = addr;
 		break;
+	case ARCH_SET_GS:
+		current->thread.regs.regs.skas.regs[GS_BASE / sizeof(unsigned long)] = addr;
+		break;
 	case ARCH_GET_FS:
-		ret = put_user(current->thread.regs.regs.skas.regs[GS / sizeof(unsigned long)], &addr);
+		ret = put_user(current->thread.regs.regs.skas.
+				regs[FS_BASE / sizeof(unsigned long)],
+				(unsigned long __user *)addr);
 	        break;
 	case ARCH_GET_GS:
-		ret = put_user(current->thread.regs.regs.skas.regs[FS / sizeof(unsigned \
-long)], &addr);
+		ret = put_user(current->thread.regs.regs.skas.
+				regs[GS_BASE / sizeof(unsigned long)],
+				(unsigned long __user *)addr);
 	        break;
 	default:
 		ret = -EINVAL;