Commit fc8f5ade authored by Thomas Petazzoni's avatar Thomas Petazzoni

net: mvmdio: new Marvell MDIO driver

This patch adds a separate driver for the MDIO interface of the
Marvell Ethernet controllers. There are two reasons to have a separate
driver rather than including it inside the MAC driver itself:

 *) The MDIO interface is shared by all Ethernet ports, so a driver
    must guarantee non-concurrent accesses to this MDIO interface. The
    most logical way is to have a separate driver that handles this
    single MDIO interface, used by all Ethernet ports.

 *) The MDIO interface is the same between the existing mv643xx_eth
    driver and the new mvneta driver. Even though it is for now only
    used by the mvneta driver, it will in the future be used by the
    mv643xx_eth driver as well.
Signed-off-by: default avatarThomas Petazzoni <thomas.petazzoni@free-electrons.com>
Acked-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 77b67063
* Marvell MDIO Ethernet Controller interface
The Ethernet controllers of the Marvel Kirkwood, Dove, Orion5x,
MV78xx0, Armada 370 and Armada XP have an identical unit that provides
an interface with the MDIO bus. This driver handles this MDIO
interface.
Required properties:
- compatible: "marvell,orion-mdio"
- reg: address and length of the SMI register
The child nodes of the MDIO driver are the individual PHY devices
connected to this MDIO bus. They must have a "reg" property given the
PHY address on the MDIO bus.
Example at the SoC level:
mdio {
#address-cells = <1>;
#size-cells = <0>;
compatible = "marvell,orion-mdio";
reg = <0xd0072004 0x4>;
};
And at the board level:
mdio {
phy0: ethernet-phy@0 {
reg = <0>;
};
phy1: ethernet-phy@1 {
reg = <1>;
};
}
......@@ -31,6 +31,17 @@ config MV643XX_ETH
Some boards that use the Discovery chipset are the Momenco
Ocelot C and Jaguar ATX and Pegasos II.
config MVMDIO
tristate "Marvell MDIO interface support"
---help---
This driver supports the MDIO interface found in the network
interface units of the Marvell EBU SoCs (Kirkwood, Orion5x,
Dove, Armada 370 and Armada XP).
For now, this driver is only needed for the MVNETA driver
(used on Armada 370 and XP), but it could be used in the
future by the MV643XX_ETH driver.
config PXA168_ETH
tristate "Marvell pxa168 ethernet support"
depends on CPU_PXA168
......
......@@ -3,6 +3,7 @@
#
obj-$(CONFIG_MV643XX_ETH) += mv643xx_eth.o
obj-$(CONFIG_MVMDIO) += mvmdio.o
obj-$(CONFIG_PXA168_ETH) += pxa168_eth.o
obj-$(CONFIG_SKGE) += skge.o
obj-$(CONFIG_SKY2) += sky2.o
/*
* Driver for the MDIO interface of Marvell network interfaces.
*
* Since the MDIO interface of Marvell network interfaces is shared
* between all network interfaces, having a single driver allows to
* handle concurrent accesses properly (you may have four Ethernet
* ports, but they in fact share the same SMI interface to access the
* MDIO bus). Moreover, this MDIO interface code is similar between
* the mv643xx_eth driver and the mvneta driver. For now, it is only
* used by the mvneta driver, but it could later be used by the
* mv643xx_eth driver as well.
*
* Copyright (C) 2012 Marvell
*
* Thomas Petazzoni <thomas.petazzoni@free-electrons.com>
*
* This file is licensed under the terms of the GNU General Public
* License version 2. This program is licensed "as is" without any
* warranty of any kind, whether express or implied.
*/
#include <linux/init.h>
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/mutex.h>
#include <linux/phy.h>
#include <linux/of_address.h>
#include <linux/of_mdio.h>
#include <linux/platform_device.h>
#include <asm/delay.h>
#define MVMDIO_SMI_DATA_SHIFT 0
#define MVMDIO_SMI_PHY_ADDR_SHIFT 16
#define MVMDIO_SMI_PHY_REG_SHIFT 21
#define MVMDIO_SMI_READ_OPERATION BIT(26)
#define MVMDIO_SMI_WRITE_OPERATION 0
#define MVMDIO_SMI_READ_VALID BIT(27)
#define MVMDIO_SMI_BUSY BIT(28)
struct orion_mdio_dev {
struct mutex lock;
void __iomem *smireg;
};
/*
* Wait for the SMI unit to be ready for another operation
*/
static int orion_mdio_wait_ready(struct mii_bus *bus)
{
struct orion_mdio_dev *dev = bus->priv;
int count;
u32 val;
count = 0;
while (1) {
val = readl(dev->smireg);
if (!(val & MVMDIO_SMI_BUSY))
break;
if (count > 100) {
dev_err(bus->parent, "Timeout: SMI busy for too long\n");
return -ETIMEDOUT;
}
udelay(10);
count++;
}
return 0;
}
static int orion_mdio_read(struct mii_bus *bus, int mii_id,
int regnum)
{
struct orion_mdio_dev *dev = bus->priv;
int count;
u32 val;
int ret;
mutex_lock(&dev->lock);
ret = orion_mdio_wait_ready(bus);
if (ret < 0) {
mutex_unlock(&dev->lock);
return ret;
}
writel(((mii_id << MVMDIO_SMI_PHY_ADDR_SHIFT) |
(regnum << MVMDIO_SMI_PHY_REG_SHIFT) |
MVMDIO_SMI_READ_OPERATION),
dev->smireg);
/* Wait for the value to become available */
count = 0;
while (1) {
val = readl(dev->smireg);
if (val & MVMDIO_SMI_READ_VALID)
break;
if (count > 100) {
dev_err(bus->parent, "Timeout when reading PHY\n");
mutex_unlock(&dev->lock);
return -ETIMEDOUT;
}
udelay(10);
count++;
}
mutex_unlock(&dev->lock);
return val & 0xFFFF;
}
static int orion_mdio_write(struct mii_bus *bus, int mii_id,
int regnum, u16 value)
{
struct orion_mdio_dev *dev = bus->priv;
int ret;
mutex_lock(&dev->lock);
ret = orion_mdio_wait_ready(bus);
if (ret < 0) {
mutex_unlock(&dev->lock);
return ret;
}
writel(((mii_id << MVMDIO_SMI_PHY_ADDR_SHIFT) |
(regnum << MVMDIO_SMI_PHY_REG_SHIFT) |
MVMDIO_SMI_WRITE_OPERATION |
(value << MVMDIO_SMI_DATA_SHIFT)),
dev->smireg);
mutex_unlock(&dev->lock);
return 0;
}
static int orion_mdio_reset(struct mii_bus *bus)
{
return 0;
}
static int __devinit orion_mdio_probe(struct platform_device *pdev)
{
struct device_node *np = pdev->dev.of_node;
struct mii_bus *bus;
struct orion_mdio_dev *dev;
int i, ret;
bus = mdiobus_alloc_size(sizeof(struct orion_mdio_dev));
if (!bus) {
dev_err(&pdev->dev, "Cannot allocate MDIO bus\n");
return -ENOMEM;
}
bus->name = "orion_mdio_bus";
bus->read = orion_mdio_read;
bus->write = orion_mdio_write;
bus->reset = orion_mdio_reset;
snprintf(bus->id, MII_BUS_ID_SIZE, "%s-mii",
dev_name(&pdev->dev));
bus->parent = &pdev->dev;
bus->irq = kmalloc(sizeof(int) * PHY_MAX_ADDR, GFP_KERNEL);
if (!bus->irq) {
dev_err(&pdev->dev, "Cannot allocate PHY IRQ array\n");
mdiobus_free(bus);
return -ENOMEM;
}
for (i = 0; i < PHY_MAX_ADDR; i++)
bus->irq[i] = PHY_POLL;
dev = bus->priv;
dev->smireg = of_iomap(pdev->dev.of_node, 0);
if (!dev->smireg) {
dev_err(&pdev->dev, "No SMI register address given in DT\n");
kfree(bus->irq);
mdiobus_free(bus);
return -ENODEV;
}
mutex_init(&dev->lock);
ret = of_mdiobus_register(bus, np);
if (ret < 0) {
dev_err(&pdev->dev, "Cannot register MDIO bus (%d)\n", ret);
iounmap(dev->smireg);
kfree(bus->irq);
mdiobus_free(bus);
return ret;
}
platform_set_drvdata(pdev, bus);
return 0;
}
static int __devexit orion_mdio_remove(struct platform_device *pdev)
{
struct mii_bus *bus = platform_get_drvdata(pdev);
mdiobus_unregister(bus);
kfree(bus->irq);
mdiobus_free(bus);
return 0;
}
static const struct of_device_id orion_mdio_match[] = {
{ .compatible = "marvell,orion-mdio" },
{ }
};
MODULE_DEVICE_TABLE(of, orion_mdio_match);
static struct platform_driver orion_mdio_driver = {
.probe = orion_mdio_probe,
.remove = __devexit_p(orion_mdio_remove),
.driver = {
.name = "orion-mdio",
.of_match_table = orion_mdio_match,
},
};
module_platform_driver(orion_mdio_driver);
MODULE_DESCRIPTION("Marvell MDIO interface driver");
MODULE_AUTHOR("Thomas Petazzoni <thomas.petazzoni@free-electrons.com>");
MODULE_LICENSE("GPL");
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment