Commit fda9abcf authored by Michael Buesch's avatar Michael Buesch Committed by David S. Miller

[B43]: Support for turning the radio off from software.

This adds support for turning the radio off in software.
That's useful in environments, where you don't want the RF
to radiate any signals, but don't want to bring the interface down.

Cc: Larry Finger <larry.finger@lwfinger.net>
Signed-off-by: default avatarMichael Buesch <mb@bu3sch.de>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 6a724d68
......@@ -459,7 +459,6 @@ struct b43_phy {
u16 radio_ver; /* Radio version */
u8 radio_rev; /* Radio revision */
bool radio_on; /* Radio switched on/off */
bool locked; /* Only used in b43_phy_{un}lock() */
bool dyn_tssi_tbl; /* tssi2dbm is kmalloc()ed. */
......@@ -468,6 +467,16 @@ struct b43_phy {
bool aci_wlan_automatic;
bool aci_hw_rssi;
/* Radio switched on/off */
bool radio_on;
struct {
/* Values saved when turning the radio off.
* They are needed when turning it on again. */
bool valid;
u16 rfover;
u16 rfoverval;
} radio_off_context;
u16 minlowsig[2];
u16 minlowsigpos[2];
......
......@@ -2874,6 +2874,21 @@ static int b43_dev_config(struct ieee80211_hw *hw, struct ieee80211_conf *conf)
if (b43_is_mode(wl, IEEE80211_IF_TYPE_AP))
b43_set_beacon_int(dev, conf->beacon_int);
if (!!conf->radio_enabled != phy->radio_on) {
if (conf->radio_enabled) {
b43_radio_turn_on(dev);
b43info(dev->wl, "Radio turned on by software\n");
if (!dev->radio_hw_enable) {
b43info(dev->wl, "The hardware RF-kill button "
"still turns the radio physically off. "
"Press the button to turn it on.\n");
}
} else {
b43_radio_turn_off(dev);
b43info(dev->wl, "Radio turned off by software\n");
}
}
spin_lock_irqsave(&wl->irq_lock, flags);
b43_interrupt_enable(dev, savedirqs);
mmiowb();
......@@ -3218,6 +3233,8 @@ static void setup_struct_phy_for_init(struct b43_wldev *dev,
phy->aci_wlan_automatic = 0;
phy->aci_hw_rssi = 0;
phy->radio_off_context.valid = 0;
lo = phy->lo_control;
if (lo) {
memset(lo, 0, sizeof(*(phy->lo_control)));
......
......@@ -1205,10 +1205,7 @@ static void b43_phy_initb2(struct b43_wldev *dev)
val -= 0x0202;
}
b43_phy_write(dev, 0x03E4, 0x3000);
if (phy->channel == 0xFF)
b43_radio_selectchannel(dev, B43_DEFAULT_CHANNEL_BG, 0);
else
b43_radio_selectchannel(dev, phy->channel, 0);
b43_radio_selectchannel(dev, phy->channel, 0);
if (phy->radio_ver != 0x2050) {
b43_radio_write16(dev, 0x0075, 0x0080);
b43_radio_write16(dev, 0x0079, 0x0081);
......@@ -1256,10 +1253,7 @@ static void b43_phy_initb4(struct b43_wldev *dev)
val -= 0x0202;
}
b43_phy_write(dev, 0x03E4, 0x3000);
if (phy->channel == 0xFF)
b43_radio_selectchannel(dev, B43_DEFAULT_CHANNEL_BG, 0);
else
b43_radio_selectchannel(dev, phy->channel, 0);
b43_radio_selectchannel(dev, phy->channel, 0);
if (phy->radio_ver != 0x2050) {
b43_radio_write16(dev, 0x0075, 0x0080);
b43_radio_write16(dev, 0x0079, 0x0081);
......@@ -4110,6 +4104,20 @@ int b43_radio_selectchannel(struct b43_wldev *dev,
u16 freq;
u16 channelcookie;
if (channel == 0xFF) {
switch (phy->type) {
case B43_PHYTYPE_A:
channel = B43_DEFAULT_CHANNEL_A;
break;
case B43_PHYTYPE_B:
case B43_PHYTYPE_G:
channel = B43_DEFAULT_CHANNEL_BG;
break;
default:
B43_WARN_ON(1);
}
}
/* First we set the channel radio code to prevent the
* firmware from sending ghost packets.
*/
......@@ -4302,6 +4310,7 @@ void b43_radio_turn_on(struct b43_wldev *dev)
{
struct b43_phy *phy = &dev->phy;
int err;
u8 channel;
might_sleep();
......@@ -4321,14 +4330,23 @@ void b43_radio_turn_on(struct b43_wldev *dev)
b43_phy_write(dev, 0x0015, 0x8000);
b43_phy_write(dev, 0x0015, 0xCC00);
b43_phy_write(dev, 0x0015, (phy->gmode ? 0x00C0 : 0x0000));
if (phy->radio_off_context.valid) {
/* Restore the RFover values. */
b43_phy_write(dev, B43_PHY_RFOVER,
phy->radio_off_context.rfover);
b43_phy_write(dev, B43_PHY_RFOVERVAL,
phy->radio_off_context.rfoverval);
phy->radio_off_context.valid = 0;
}
channel = phy->channel;
err = b43_radio_selectchannel(dev, B43_DEFAULT_CHANNEL_BG, 1);
err |= b43_radio_selectchannel(dev, channel, 0);
B43_WARN_ON(err);
break;
default:
B43_WARN_ON(1);
}
phy->radio_on = 1;
b43dbg(dev->wl, "Radio turned on\n");
}
void b43_radio_turn_off(struct b43_wldev *dev)
......@@ -4342,10 +4360,16 @@ void b43_radio_turn_off(struct b43_wldev *dev)
b43_phy_write(dev, 0x0011, b43_phy_read(dev, 0x0011) | 0x0008);
}
if (phy->type == B43_PHYTYPE_G && dev->dev->id.revision >= 5) {
b43_phy_write(dev, 0x0811, b43_phy_read(dev, 0x0811) | 0x008C);
b43_phy_write(dev, 0x0812, b43_phy_read(dev, 0x0812) & 0xFF73);
u16 rfover, rfoverval;
rfover = b43_phy_read(dev, B43_PHY_RFOVER);
rfoverval = b43_phy_read(dev, B43_PHY_RFOVERVAL);
phy->radio_off_context.rfover = rfover;
phy->radio_off_context.rfoverval = rfoverval;
phy->radio_off_context.valid = 1;
b43_phy_write(dev, B43_PHY_RFOVER, rfover | 0x008C);
b43_phy_write(dev, B43_PHY_RFOVERVAL, rfoverval & 0xFF73);
} else
b43_phy_write(dev, 0x0015, 0xAA00);
phy->radio_on = 0;
b43dbg(dev->wl, "Radio turned off\n");
}
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment