mmc: sdhci_am654: Fix conditions for enabling dll

The clock > CLOCK_TOO_SLOW_HZ condition gating phy configuration
is only required because dll should not be enabled at too low a
clock frequency or too low timing. Make sure that this condition
only gates dll enablement.
Signed-off-by: Faiz Abbas <faiz_abbas@ti.com>
Link: https://lore.kernel.org/r/20200619125801.9530-5-faiz_abbas@ti.comSigned-off-by: Ulf Hansson <ulf.hansson@linaro.org>

drivers/mmc/host/sdhci_am654.c

@@ -204,34 +204,32 @@ static void sdhci_am654_set_clock(struct sdhci_host *host, unsigned int clock)
 
 	sdhci_set_clock(host, clock);
 
-	if (clock > CLOCK_TOO_SLOW_HZ) {
-		/* Setup DLL Output TAP delay */
-		if (sdhci_am654->legacy_otapdly)
-			otap_del_sel = sdhci_am654->otap_del_sel[0];
-		else
-			otap_del_sel = sdhci_am654->otap_del_sel[timing];
+	/* Setup DLL Output TAP delay */
+	if (sdhci_am654->legacy_otapdly)
+		otap_del_sel = sdhci_am654->otap_del_sel[0];
+	else
+		otap_del_sel = sdhci_am654->otap_del_sel[timing];
 
-		otap_del_ena = (timing > MMC_TIMING_UHS_SDR25) ? 1 : 0;
+	otap_del_ena = (timing > MMC_TIMING_UHS_SDR25) ? 1 : 0;
 
-		mask = OTAPDLYENA_MASK | OTAPDLYSEL_MASK;
-		val = (otap_del_ena << OTAPDLYENA_SHIFT) |
-		      (otap_del_sel << OTAPDLYSEL_SHIFT);
+	mask = OTAPDLYENA_MASK | OTAPDLYSEL_MASK;
+	val = (otap_del_ena << OTAPDLYENA_SHIFT) |
+	      (otap_del_sel << OTAPDLYSEL_SHIFT);
 
-		/* Write to STRBSEL for HS400 speed mode */
-		if (timing == MMC_TIMING_MMC_HS400) {
-			if (sdhci_am654->flags & STRBSEL_4_BIT)
-				mask |= STRBSEL_4BIT_MASK;
-			else
-				mask |= STRBSEL_8BIT_MASK;
+	/* Write to STRBSEL for HS400 speed mode */
+	if (timing == MMC_TIMING_MMC_HS400) {
+		if (sdhci_am654->flags & STRBSEL_4_BIT)
+			mask |= STRBSEL_4BIT_MASK;
+		else
+			mask |= STRBSEL_8BIT_MASK;
 
-			val |= sdhci_am654->strb_sel << STRBSEL_SHIFT;
-		}
+		val |= sdhci_am654->strb_sel << STRBSEL_SHIFT;
+	}
 
-		regmap_update_bits(sdhci_am654->base, PHY_CTRL4, mask, val);
+	regmap_update_bits(sdhci_am654->base, PHY_CTRL4, mask, val);
 
-		if (timing > MMC_TIMING_UHS_SDR25)
-			sdhci_am654_setup_dll(host, clock);
-	}
+	if (timing > MMC_TIMING_UHS_SDR25 && clock > CLOCK_TOO_SLOW_HZ)
+		sdhci_am654_setup_dll(host, clock);
 }
 
 static void sdhci_j721e_4bit_set_clock(struct sdhci_host *host,