Otherwise with too much stuff enabled in the kernel config
we can end up with an unaligned trap table.
Signed-off-by: David S. Miller <davem@davemloft.net>

SBUS flash driver needs it.

Noticed by Fabbione.
Signed-off-by: David S. Miller <davem@davemloft.net>

Niagara helps us find a ancient bug in the sparc64 port :-)

The ASI_* values are plain constant defines, thus signed 32-bit
on sparc64.  To put shift this into the regs->tstate value we were
doing or'ing "(ASI_PNF << 24)" into there.

ASI_PNF is 0x82 and shifted left by 24 makes that topmost bit the
sign bit in a 32-bit value.  This would get sign extended to 64-bits
and thus corrupt the top-half of the reg->tstate value.

This never caused problems in pre-Niagara cpus because the only thing
up there were the condition code values.  But Niagara has the global
register level field, and this all 1's value is illegal there so
Niagara gives an illegal instruction trap due to this bug.

I'm pretty sure this bug is about as old as the sparc64 port itself.

This also points out that we weren't setting ASI_PNF for 32-bit tasks.
We should, so fix that while we're here.
Signed-off-by: David S. Miller <davem@davemloft.net>

If we take a window fault, on SUN4V set %gl to zero before we
turn PSTATE_IE back on in %pstate.  Otherwise if we take an
interrupt we'll end up with corrupt register state.
Signed-off-by: David S. Miller <davem@davemloft.net>

It can map all of the linear kernel mappings with zero TSB hash
conflicts for systems with 16GB or less ram.  In such cases, on
SUN4V, once we load up this TSB the first time with all the
mappings, we never take a linear kernel mapping TLB miss ever
again, the hypervisor handles them all.
Signed-off-by: David S. Miller <davem@davemloft.net>

We use a bitmap, one bit for every 256MB of memory.  If the
bit is set we can use a 256MB PTE for linear mappings, else
we have to use a 4MB PTE.

SUN4V support is there, and we can very easily add support
for Panther cpu 256MB PTEs in the future.
Signed-off-by: David S. Miller <davem@davemloft.net>

We have to turn off the "polling nrflag" bit when we sleep
the cpu like this, so that we'll get a cross-cpu interrupt
to wake the processor up from the yield.

We also have to disable PSTATE_IE in %pstate around the yield
call and recheck need_resched() in order to avoid any races.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

Set, but never used.

We used to use this for dynamic IRQ retargetting, but that
code died a long time ago.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

They were getting truncated to 32-bit and this is very bad
when your MMU fault status area is in physical memory above
4GB on SUN4V.
Signed-off-by: David S. Miller <davem@davemloft.net>

The math-emu code only expects unfinished fpop traps when
emulating FPU sqrt instructions on pre-Niagara chips.
On Niagara we can get unimplemented fpop, so handle that.
Signed-off-by: David S. Miller <davem@davemloft.net>

Because we play this trick where we use ttyS? in increasing minor
numbers for different sunfoo.c drivers, we have to inform the TTY
layer of this.

Do so by setting the tty->name_base appropriately.

Probably there should be a generic way to do this in the serial core,
but for now...
Signed-off-by: David S. Miller <davem@davemloft.net>

Should be "Dax" not "Iax".
Signed-off-by: David S. Miller <davem@davemloft.net>

By simply changing the do-while loop into a plain
while loop.
Signed-off-by: David S. Miller <davem@davemloft.net>

I forgot to remove the one in pci_4v_map_sg() during the
iommu batching commit.
Signed-off-by: David S. Miller <davem@davemloft.net>

Actually make use of the 'limit' we compute.
Signed-off-by: David S. Miller <davem@davemloft.net>

It's extremely noisy and causes much grief on slow
consoles with large numbers of cpus.

We'll have to provide this some saner way in order
to re-enable this.
Signed-off-by: David S. Miller <davem@davemloft.net>

Use a batching queue system for IOMMU mapping setup,
with a page sized batch.
Signed-off-by: David S. Miller <davem@davemloft.net>

We're about to seriously die in these cases so it is important
that the messages make it to the console.
Signed-off-by: David S. Miller <davem@davemloft.net>

Another case where we have to force ourselves into global register
level one.  Also make sure the arguments passed to sun4v_do_mna() are
correct.

This area actually needs some more work, for example spill fixup is
not necessarily going to do the right thing for this case.
Signed-off-by: David S. Miller <davem@davemloft.net>

Just like kvmap_dtlb_longpath we have to force the
global register level to one in order to mimick the
PSTATE_MG --> PSTATE_AG trasition done on SUN4U.
Signed-off-by: David S. Miller <davem@davemloft.net>

Caller takes the lock already.

Also, fixup the poll loop in sunhv_break_ctl().  Just
like in console write, we udelay(2) and use a loop
limit of 1000000 iterations.
Signed-off-by: David S. Miller <davem@davemloft.net>

So that it will show up as /dev/ttyS0.  Otherwise things like
installers will try to run on whatever serial port gets probed
first.
Signed-off-by: David S. Miller <davem@davemloft.net>

For drivers/media/*, noticed by Fabbione.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Fabio M. Di Nitto <fabbione@ubuntu.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

The SUN4V convention with non-shared TSBs is that the context
bit of the TAG is clear.  So we have to choose an "invalid"
bit and initialize new TSBs appropriately.  Otherwise a zero
TAG looks "valid".

Make sure, for the window fixup cases, that we use the right
global registers and that we don't potentially trample on
the live global registers in etrap/rtrap handling (%g2 and
%g6) and that we put the missing virtual address properly
in %g5.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

1) Add error return checking for TLB load hypervisor
   calls.

2) Don't fallthru to dtlb tsb miss handler from itlb tsb
   miss handler, oops.

3) On window fixups, propagate fault information to fixup
   handler correctly.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

It must be ready when we take over the trap table.
Signed-off-by: David S. Miller <davem@davemloft.net>

This gives more consistent bogomips and delay() semantics,
especially on sun4v.  It gives weird looking values though...
Signed-off-by: David S. Miller <davem@davemloft.net>

It should be 1, not 0.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

It's 0x9 not 0xb.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

We need to use the real hardware processor ID when
targetting interrupts, not the "define to 0" thing
the uniprocessor build gives us.

Also, fill in the Node-ID and Agent-ID fields properly
on sun4u/Safari.
Signed-off-by: David S. Miller <davem@davemloft.net>