- 05 Dec, 2009 40 commits
-
-
Andy Walls authored
Change logic to check for various chip or core families to inline functions. Checks for specific chips should be made against the state->id field now. This is in preparation for chip/core specific code for setting up PLLs for the CX2388[578] family of cores, that all run with different crystal frequencies. Signed-off-by:
Andy Walls <awalls@radix.net> Signed-off-by:
Mauro Carvalho Chehab <mchehab@redhat.com>
-
Andy Walls authored
Add improved logic to detect the exact CX2388[578] A/V core that is being probed. Also cleaned up detection and logging for CX2310[12], CX2583[67], and CX2584[0123] cores and chips. Also added code to identify a CX2388[578] A/V decoder core that is not responding properly. Typical symptoms include registers 0x00-0xff responding properly but all other registers returning the same value (0x13 and 0x5 have been observed). This state will cause proper detection of '885 vs. '887 vs. '888 to fail and the chip won't respond to get configured properly anyway. I have no method of reseting the core to a working state at this time; but I didn't try too hard to work one out either. The problem likely only occurs in development. I suspect configuring the SYS PLL VCO to oscillate too slowly (286.3 MHz?) before post divide may be the root cause, when encountered. Signed-off-by:
-
Andy Walls authored
This change adds a skeletal implementation of a v4l2_subdevice to provide encapsulation and abstraction of the CX23888's integrated consumer infrared controller. This change also instantiates the cx23888_ir subdev for the HVR-1850 which has IR hardware physically wired up to a CX23888. The cx23888_ir subdev code is being written with long-term objectives to: 1. port it to the cx25840 module for the CX2584x, CX2583x, CX23885, & CX231xx IR controllers 2. possibly port it to the cx18 module for the CX23418 IR controller 3. have the IR subdevice accessed abstractly in the cx23885 module, so the driver can ignore the difference between the CX23885 and CX23888. Signed-off-by:
-
Andy Walls authored
This changes corrects the ioctl() operations for both the CX2388[578] analog video and MPEG video device nodes to properly and consistently support VIDIOC_G_CHIP_IDENT, VIDIOC_DBG_G_REGISTER and VIDIOC_DBG_S_REGISTER ioctl()s. This caused some ioctl() support routines to be broken out into a separate source file. Now v4l2-dbg can be used to manipulate CX2388[578] and CX23417 registers including the CX2388[57] functions handled by the cx25840 module. This was done in anticipation of developing a new v4l2_subdev for the integrated IR controller of the CX23888. Signed-off-by:
-
Andy Walls authored
Add identifiers for CX2388[578] chips, CX2310[012] chips, integrated A/V decoders cores, integrated IR controller core, and the CX23417 MPEG encoder. The cx23885 module and cx25840 module will use these identifiers in upcoming changes. Signed-off-by:
-
Devin Heitmueller authored
The board support has been validated by the user, so get rid of the warning that shows up on board load. Signed-off-by:
Devin Heitmueller <dheitmueller@kernellabs.com> Signed-off-by:
-
Devin Heitmueller authored
Dmitri's patch for the Behold X7 didn't use the #define I had setup for XC5000_RADIO_FM1, so cut over to using that instead of "1". Signed-off-by:
-
Beholder Intl. Ltd. Dmitry Belimov authored
Add support for the digital side of the Behold X7 Signed-off-by:
Beholder Intl. Ltd. Dmitry Belimov <d.belimov@gmail.com> Signed-off-by:
-
Uroš Vampl authored
Make analog audio, dvb and the remote work on a Terratec Cinergy Hybrid XS (em2882). Note by djh: Thanks go out fo Andrej Suligoi for his contribution in providing and testing pretty much the exact same patch as provided by Uros. Between the two of them, they got all the core functionality working for the device. Cc: Andrej Suligoi <suligoi@gmail.com> Signed-off-by:
Uroš Vampl <mobile.leecher@gmail.com> Signed-off-by:
-
Devin Heitmueller authored
Seems that the reference design used for the KWorld 2800d switched from the em2860 to em2862, so we need to add the new USB id (and the i2c hash remains so all we need is the default em2862 id. Thanks to Ian Young for reporting the issue and testing the fix. Cc: Ian Young <ian@duffrecords.com> Signed-off-by:
-
Devin Heitmueller authored
Remove hard-coded definition of the xc5000 FM radio input, making it a parameter passed in when doing the attach call. Signed-off-by:
-
Beholder Intl. Ltd. Dmitry Belimov authored
Add FM radio for the xc5000 silicon tuner chip. Signed-off-by:
-
David Ellingsworth authored
Set radio frequency only upon success. Signed-off-by:
David Ellingsworth <david@identd.dyndns.org> Acked-by:
Alexey Klimov <klimov.linux@gmail.com> Signed-off-by:
Douglas Schilling Landgraf <dougsland@redhat.com> Signed-off-by:
-
David Ellingsworth authored
Simplify device warnings. Signed-off-by:
-
David Ellingsworth authored
Preserve radio state during suspend/resume. Signed-off-by:
-
David Ellingsworth authored
Fix behavior of set_stereo function. Signed-off-by:
-
David Ellingsworth authored
Ensure the radio is initialized to a consistent state. Signed-off-by:
-
David Ellingsworth authored
Remove device initialization from open/close. Signed-off-by:
-
David Ellingsworth authored
Fix portential use after free. Signed-off-by:
-
David Ellingsworth authored
Remove device removed indicator Signed-off-by:
-
David Ellingsworth authored
Simplify locking in ioctl callbacks. Signed-off-by:
-
David Ellingsworth authored
Simplify access to amradio_device. Signed-off-by:
-
David Ellingsworth authored
Remove unnecessary local variable. Signed-off-by:
-
David Ellingsworth authored
Simplify error paths in usb probe callback. Signed-off-by:
-
David Ellingsworth authored
simplify video_device allocation Signed-off-by:
-
David Ellingsworth authored
Implement proper locking Signed-off-by:
-
Antti Palosaari authored
Looks like eeprom IR mode byte value 0x04 means there is remote which should be polled. Patch enables polling also in case of 0x04. Signed-off-by:
Antti Palosaari <crope@iki.fi> Signed-off-by:
-
Antti Palosaari authored
Support for MSI DIGIVOX mini III remote. Thanks to Aleksandr V. Piskunov <aleksandr.v.piskunov@gmail.com> Thanks to Roman <lists@hasnoname.de> Cc: Aleksandr V. Piskunov <aleksandr.v.piskunov@gmail.com> Cc: Roman <lists@hasnoname.de> Signed-off-by:
-
Antti Palosaari authored
Add missing LeadTek Y04G0051 remote buttons. Thanks to Matthew Skinner <matt@pcmus.com> Cc: Matthew Skinner <matt@pcmus.com> Signed-off-by:
-
Antti Palosaari authored
Signed-off-by:
-
Antti Palosaari authored
Add USB ID 1b80:c161 for KWorld PlusTV DVB-T PCI Pro Card (DVB-T PC160-T). Thanks to Andrew Cruickshank <atcrank@gmail.com> for reporting this. Cc: Andrew Cruickshank <atcrank@gmail.com> Signed-off-by:
-
S?rgio Fortier authored
Patch for EvolutePC TvWay+ USB ISDB-Tb fullseg device support. Signed-off-by:
S?rgio C Fortier <sergiofortier@yahoo.com.br> Signed-off-by:
Patrick Boettcher <pboettcher@kernellabs.com> Signed-off-by:
-
Olivier Grenie authored
Update the dib7000p: The status is HAS_LOCK only if the demod is able to decode the TPS. Sometimes, there is a TPS data lock, even if the demod is not able to decode it (ex: no RF signal). For the STK7770P: correct value for the charge pump Signed-off-by:
Olivier Grenie <olivier.grenie@dibcom.fr> Signed-off-by:
-
Olivier Grenie authored
dib7000p/dib8000: added pid filtering dib8000: the SNR is in 10th of dB (not in dB) dib7000p and dib8000: added the pid filtering. This feature is enabled by module option (dvb-usb module). Signed-off-by:
-
Igor M. Liplianin authored
Signed-off-by:
Igor M. Liplianin <liplianin@netup.ru> Signed-off-by:
-
Mauro Carvalho Chehab authored
Signed-off-by: -
Mauro Carvalho Chehab authored
This IR uses NEC protocol. In order to use, dvb_usb_dib0700_ir_proto=0 should be used. Cc: Patrick Boettcher <pb@linuxtv.org> Signed-off-by: -
Mauro Carvalho Chehab authored
Currently, dvb_usb_dib0700_ir_proto is supported only with firmwares older than 1.2. Adds support for it also with the newer firmware. This is needed in order to support PixelView SBTVD IR. Cc: Patrick Boettcher <pb@linuxtv.org> Signed-off-by: -
Marek Vasut authored
Signed-off-by:
Marek Vasut <marek.vasut@gmail.com> Signed-off-by:
Guennadi Liakhovetski <g.liakhovetski@gmx.de> Signed-off-by:
-
Linus Torvalds authored
Merge branch 'tracing-core-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip * 'tracing-core-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip: (40 commits) tracing: Separate raw syscall from syscall tracer ring-buffer-benchmark: Add parameters to set produce/consumer priorities tracing, function tracer: Clean up strstrip() usage ring-buffer benchmark: Run producer/consumer threads at nice +19 tracing: Remove the stale include/trace/power.h tracing: Only print objcopy version warning once from recordmcount tracing: Prevent build warning: 'ftrace_graph_buf' defined but not used ring-buffer: Move access to commit_page up into function used tracing: do not disable interrupts for trace_clock_local ring-buffer: Add multiple iterations between benchmark timestamps kprobes: Sanitize struct kretprobe_instance allocations tracing: Fix to use __always_unused attribute compiler: Introduce __always_unused tracing: Exit with error if a weak function is used in recordmcount.pl tracing: Move conditional into update_funcs() in recordmcount.pl tracing: Add regex for weak functions in recordmcount.pl tracing: Move mcount section search to front of loop in recordmcount.pl tracing: Fix objcopy revision check in recordmcount.pl tracing: Check absolute path of input file in recordmcount.pl tracing: Correct the check for number of arguments in recordmcount.pl ...
-
