- 03 Apr, 2014 40 commits
-
-
Jingoo Han authored
Use SIMPLE_DEV_PM_OPS macro in order to make the code simpler. Signed-off-by:
Jingoo Han <jg1.han@samsung.com> Signed-off-by:
Andrew Morton <akpm@linux-foundation.org> Signed-off-by:
Linus Torvalds <torvalds@linux-foundation.org>
-
Jingoo Han authored
Use SIMPLE_DEV_PM_OPS macro in order to make the code simpler. Signed-off-by:
-
Mika Westerberg authored
CONFIG_PM will be set also if only CONFIG_PM_RUNTIME is set which causes the compiler to emit following warning: drivers/rtc/rtc-cmos.c:845:12: warning: =E2=80=98cmos_resume=E2=80=99 defined but not used [-Wunused-function] Fix this by using CONFIG_PM_SLEEP instead of CONFIG_PM and removing it from the driver pm ops as this has been taken care by SIMPLE_DEV_PM_OPS() already. Signed-off-by:
Mika Westerberg <mika.westerberg@linux.intel.com> Signed-off-by:
-
Bharat Bhushan authored
It's possible to have RTC irq shared with other device (e.g. t4240qds board shares ds3232irq with phy one). Handle this in driver. Signed-off-by:
Bharat Bhushan <Bharat.Bhushan@freescale.com> Cc: Scott Wood <scottwood@freescale.com> Signed-off-by:
-
Maxime Ripard authored
Switch the device tree to the new compatibles introduced in the RTC drivers to have a common pattern accross all Allwinner SoCs. Signed-off-by:
Maxime Ripard <maxime.ripard@free-electrons.com> Signed-off-by:
-
Maxime Ripard authored
The Allwinner A10 compatibles were following a slightly different compatible patterns than the rest of the SoCs for historical reasons. Change the compatibles to match the other pattern in the RTC driver for consistency. Signed-off-by:
-
Alexander Shiyan authored
Remove unnecessary locks when reading the time and make the read operation until the values of day matched between reading the seconds, it will make the mc13xxx_rtc_read_time() procedure more readable. Additionally, patch introduced a "seconds in a day" definition. Signed-off-by:
Alexander Shiyan <shc_work@mail.ru> Cc: Uwe Kleine-König <u.kleine-koenig@pengutronix.de> Cc: Sascha Hauer <kernel@pengutronix.de> Signed-off-by:
-
Alexander Shiyan authored
Datasheet says: "When the VSRTC voltage drops to the range of 0.9 - 0.8V, the RTCPORB reset signal is generated and the contents of the RTC will be reset. <skip>. To inform the processor that the contents of the RTC are no longer valid due to the reset, a timer reset interrupt function is implemented with the RTCRSTI bit." This patch makes the RTC valid by default until RTCRST interrupt occurs. Signed-off-by:
-
Alexander Shiyan authored
1Hz interrupt is never unmasked, so no interrupts appears. This patch fix this issue. Signed-off-by:
-
Alexander Shiyan authored
This patch removes excess layer for alarm_irq_enable() function. Signed-off-by:
-
Alexander Shiyan authored
Interrupts can appear after request_irq and interrupt handlers can use the RTC device, but currently we register RTC after IRQs. This patch changes this order and simplify error path a bit. Signed-off-by:
-
Alexander Shiyan authored
Since we no longer allow building without hotplug, the mc13xxx_rtc_remove() function is always present and we should not use __exit_p() to refer to it. Signed-off-by:
-
Simon Guinot authored
Add alarm support for the Microchip RTC devices MCP794xx. Note that two programmable alarms are provided by the chip but only one is used by the driver. Signed-off-by:
Simon Guinot <simon.guinot@sequanux.org> Cc: Jason Cooper <jason@lakedaemon.net> Cc: Andrew Lunn <andrew@lunn.ch> Cc: Gregory Clement <gregory.clement@free-electrons.com> Cc: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com> Signed-off-by:
-
Simon Guinot authored
In order to allow the creation of the sysfs attribute wakealarm, this patch moves the device_set_wakeup_capable() call above the RTC device registration. Signed-off-by:
-
Xianglong Du authored
RTC settings will be lost if power supply is cut off after hibernation finished, but the current "restore" function does not restore RTC related settings, this causes rtc_read_time failure and kernel panic: rtc rtc0: **** DPM device timeout **** Stack trace: unwind_backtrace+0x0/0xf4 show_stack+0x10/0x14 dpm_wd_handler+0x24/0x28 call_timer_fn.isra.33+0x24/0x88 run_timer_softirq+0x178/0x1f0 __do_softirq+0x120/0x200 do_softirq+0x54/0x5c irq_exit+0x9c/0xd0 handle_IRQ+0x44/0x90 __irq_svc+0x40/0x70 _raw_spin_unlock_irqrestore+0x10/0x48 sirfsoc_rtc_iobrg_readl+0x34/0x3c sirfsoc_rtc_read_time+0x24/0x48 __rtc_read_time.isra.3+0x48/0x5c rtc_read_time+0x30/0x44 rtc_resume.part.9+0x20/0x104 rtc_resume+0x5c/0x64 dpm_run_callback.isra.4+0x2c/0x74 device_resume+0x9c/0x144 dpm_resume+0x100/0x224 hibernation_snapshot+0x170/0x398 hibernate+0x13c/0x1d8 state_store+0xb4/0xb8 kobj_attr_store+0x14/0x20 sysfs_write_file+0x160/0x190 vfs_write+0xb4/0x194 SyS_write+0x3c/0x78 this patch uses SIMPLE_DEV_PM_OPS() to make restore() execute the existing resume() function which will restore the set of RTC. Signed-off-by:Xianglong Du <Xianglong.Du@csr.com> Signed-off-by:
Barry Song <Baohua.Song@csr.com> Cc: Grant Likely <grant.likely@linaro.org> Cc: Rob Herring <robh+dt@kernel.org> Signed-off-by:
-
Anthony Olech authored
Remove redundant irq field in private rtc structure. Signed-off-by:
Anthony Olech <anthony.olech.opensource@diasemi.com> Acked-by:
David Dajun Chen <david.chen@diasemi.com> Signed-off-by:
-
Sachin Kamat authored
linux/rtc.h was included twice. Signed-off-by:
Sachin Kamat <sachin.kamat@linaro.org> Signed-off-by:
-
Jingoo Han authored
Use devm_ioremap_resource() in order to make the code simpler, and move 'struct resource *mem' from 'struct jz4740_rtc' to jz4740_rtc_probe() because the 'mem' variable is used only in jz4740_rtc_probe(). Also the redundant return value check of platform_get_resource() is removed, because the value is checked by devm_ioremap_resource(). Signed-off-by:
-
Jingoo Han authored
Use devm_ioremap_resource() in order to make the code simpler, and move 'struct resource *res' from 'struct vt8500_rtc' to vt8500_rtc_probe() because the 'res' variable is used only in vt8500_rtc_probe(). Signed-off-by:
-
Jingoo Han authored
Use devm_ioremap_resource() in order to make the code simpler, and remove redundant return value check of platform_get_resource() because the value is checked by devm_ioremap_resource(). Signed-off-by:
-
Jingoo Han authored
Use devm_ioremap_resource() in order to make the code simpler, and remove redundant return value check of platform_get_resource() because the value is checked by devm_ioremap_resource(). Signed-off-by:
Linus Walleij <linus.walleij@linaro.org> Signed-off-by:
-
Jingoo Han authored
The site-specific OOM messages are unnecessary, because they duplicate the MM subsystem generic OOM message. Signed-off-by:
Viresh Kumar <viresh.kumar@linaro.org> Signed-off-by:
-
Jingoo Han authored
The site-specific OOM messages are unnecessary, because they duplicate the MM subsystem generic OOM message. Signed-off-by:
-
Jingoo Han authored
The site-specific OOM messages are unnecessary, because they duplicate the MM subsystem generic OOM message. Signed-off-by:
-
Jingoo Han authored
The site-specific OOM messages are unnecessary, because they duplicate the MM subsystem generic OOM message. Signed-off-by:
-
Jingoo Han authored
The site-specific OOM messages are unnecessary, because they duplicate the MM subsystem generic OOM message. Signed-off-by:
-
Jingoo Han authored
The site-specific OOM messages are unnecessary, because they duplicate the MM subsystem generic OOM message. Signed-off-by:
-
Jingoo Han authored
The site-specific OOM messages are unnecessary, because they duplicate the MM subsystem generic OOM message. Signed-off-by:
-
Jingoo Han authored
The site-specific OOM messages are unnecessary, because they duplicate the MM subsystem generic OOM message. Signed-off-by:
-
Jingoo Han authored
The site-specific OOM messages are unnecessary, because they duplicate the MM subsystem generic OOM message. Signed-off-by:
-
Jingoo Han authored
The site-specific OOM messages are unnecessary, because they duplicate the MM subsystem generic OOM message. Signed-off-by:
Hans-Christian Egtvedt <egtvedt@samfundet.no> Signed-off-by:
-
Fabio Estevam authored
clk_prepare_enable() may fail, so let's check its return value and propagate it in the case of error. Signed-off-by:
Fabio Estevam <fabio.estevam@freescale.com> Signed-off-by:
-
Alessandro Zummo authored
RTC drivers must not return an error after device registration. [akpm@linux-foundation.org: coding-style fixes] Signed-off-by:
Alessandro Zummo <a.zummo@towertech.it> Reported-by:
Ales Novak <alnovak@suse.cz> Cc: Alexander Shiyan <shc_work@mail.ru> Cc: Atsushi Nemoto <anemo@mba.ocn.ne.jp> Cc: Jiri Kosina <jkosina@suse.cz> Cc: Srikanth Srinivasan <srikanth.srinivasan@freescale.com> Cc: Lee Jones <lee.jones@linaro.org> Cc: Sascha Hauer <s.hauer@pengutronix.de> Cc: Joonsoo Kim <iamjoonsoo.kim@lge.com> Signed-off-by:
-
chishanmingshen authored
Signed-off-by:
chishanmingshen <chishanmingshen@gmail.com> Signed-off-by:
-
Luis Henriques authored
A missing 'break' statement in bm_status_write() results in a user program receiving '3' when doing the following: write(fd, "-1", 2); Signed-off-by:
Luis Henriques <luis.henriques@canonical.com> Alexander Viro <viro@zeniv.linux.org.uk> Signed-off-by:
-
Fabian Frederick authored
init_inodecache is only called by __init init_efs_fs. Signed-off-by:
Fabian Frederick <fabf@skynet.be> Signed-off-by:
-
Joe Perches authored
This test prevents code from being aligned around the : for easy visual counting of bitfield lengths. ie: int foo : 1, int bar : 2, int foobar :29; should be acceptable so remove the test. Signed-off-by:
Joe Perches <joe@perches.com> Suggested-by:
Dan Carpenter <dan.carpenter@oracle.com> Signed-off-by:
-
Joe Perches authored
Currently the parenthesis alignment test works only on misalignments of if statements like if (foo(bar, baz) Expand the test to find misalignments like: static inline int foo(int bar, int baz) and foo(bar, baz); and foo = bar(baz, qux); Expand the $Inline keyword for __inline and __inline__ too. Add $Inline to $Declare so it also matches "static inline <foo>". These checks are only performed with --strict. Signed-off-by:
-
Christopher Covington authored
A commit hook for the Gerrit code review server [1] inserts change identifiers so Gerrit can track patches through multiple revisions. These identifiers are noise in the context of the upstream kernel. (Many Gerrit servers are private. Even given a public instance, given only a Change-Id, one must guess which server a change was tracked on. Patches submitted to the Linux kernel mailing lists should be able to stand on their own. If it's truly useful to reference code review on a Gerrit server, a URL is a much clearer way to do so.) Thus, issue an error when a Change-Id line is encountered before the Signed-off-by. 1. https://gerrit.googlesource.com/gerrit/+/master/gerrit-server/src/main/resources/com/google/gerrit/server/tools/root/hooks/commit-msgSigned-off-by:
Christopher Covington <cov@codeaurora.org> Cc: Joe Perches <joe@perches.com> Cc: Andy Whitcroft <apw@shadowen.org> Signed-off-by:
-
Andrew Morton authored
Revert commit 7e4915e7 ("checkpatch: add warning of future __GFP_NOFAIL use"). There are no plans to remove __GFP_NOFAIL. __GFP_NOFAIL exists to a) centralise the retry-allocation-for-ever operation into the core allocator, which is the appropriate implementation site and b) permit us to identify code sites which aren't handling memory exhaustion appropriately. Cc: David Rientjes <rientjes@google.com> Cc: Joe Perches <joe@perches.com> Cc: Theodore Ts'o <tytso@mit.edu> Signed-off-by:
-
