- 27 Jul, 2010 40 commits
-
-
Andrew Vasquez authored
[SCSI] qla2xxx: For ISP 23xx, select user specified login timeout value if greater than minuimum value(4 secs). Signed-off-by:
Giridhar Malavali <giridhar.malavali@qlogic.com> Signed-off-by:
James Bottomley <James.Bottomley@suse.de>
-
Giridhar Malavali authored
Signed-off-by:
-
Giridhar Malavali authored
Signed-off-by:
-
Arun Easi authored
Signed-off-by:
-
Lalit Chandivade authored
Driver was not unprotecting correctly, use correct bits to unprotect the flash on ISP 82xx. Signed-off-by:
-
Santosh Vernekar authored
Outstanding mailbox commands, have no way to recover on f/w hung, and we timeout on waiting for mbx response. This in turn affects the recovery process as follows: - We might already be in dpc while waiting for mbx to complete, so recovery for that pci function will never get invoked. Reset Timeout (10 sec) is far less than mbx timeout (30 sec). - Other mbx cmds will get stuck due to serial mbx access. Solution is to identify fw-hung scenario and handle outstanding mbx commands to have an early-exit instead of waiting for response. Other mbx commands waiting for access will also do an early-exit if fw-hung is still applicable. Signed-off-by:
-
Lalit Chandivade authored
After topology change ISP is reset and VPs are re-enabled. If the topology is not fabric, VPs could falsely get enabled. Signed-off-by:
-
Harish Zunjarrao authored
Used bootloder address from FLT while loading FW from flash as well. Signed-off-by:
-
Andrew Vasquez authored
In case of both target and initiator capabilities reported by fc port, the fc port port capability is made mutualy exclusive with priority given for target capabilities. Signed-off-by:
-
Sarang Radke authored
Signed-off-by:
-
Giridhar Malavali authored
Signed-off-by:
Andrew Vasquez <andrew.vasquez@qlogic.com> Signed-off-by:
-
Andrew Vasquez authored
* hold the hardware_lock throughout the duration of ctx-sp timeout handling -- could result in use-after-free oops. * retry a timed-out login-request. * done() routines are called with the hardware-lock held, issue qla2x00_mark_device_lost() with proper 'defer' flag. * FCP2 capabilities are only relevant to target devices. Signed-off-by:
-
Giridhar Malavali authored
Hold a reference to the srb (sp) while aborting an I/O -- as the I/O can/will complete from within the interrupt-context. Signed-off-by:
-
Giridhar Malavali authored
The TMFs used for pre-24xx ISPs incorrectly assumed 'cpu' tag data could be valid. These chips have no multi-q/cpu-affinity support. This corrects an oops seen on ISP23xx parts. Signed-off-by:
-
Andrew Vasquez authored
This helps to correlate submission/completion messages during triaging. Signed-off-by:
-
Giridhar Malavali authored
The CRB drive active register is cleared when driver is unloaded or when driver enters failed state. Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
Stephen M. Cameron <scameron@beardog.cce.hp.com> Signed-off-by:
-
Stephen M. Cameron authored
We have 32 (MAXSGENTRIES) scatter gather elements embedded in the command. With all these, the total command size is about 576 bytes. However, the last entry in the block fetch table is 35. (the block fetch table contains the number of 16-byte chunks the firmware needs to fetch for a given number of scatter gather elements.) 35 * 16 = 560 bytes, which isn't enough. It needs to be 36. (36 * 16 == 576) or, MAXSGENTRIES + 4. (plus 4 because there's a bunch of stuff at the front of the command before the first scatter gather element that takes up 4 * 16 bytes.) Without this fix, the controller may have to perform two DMA operations to fetch the command since the first one may not get the whole thing. Signed-off-by:
Don Brace <brace@beardog.cce.hp.com> Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
before trying to enter simple mode transport method. Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
and delete duplicated comment Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
Stephen M. Cameron authored
Signed-off-by:
-
