- 19 Sep, 2009 40 commits
-
-
Michael Krufky authored
Signed-off-by:
Michael Krufky <mkrufky@kernellabs.com> Signed-off-by:
Mauro Carvalho Chehab <mchehab@redhat.com>
-
Michael Krufky authored
Signed-off-by:
-
Michael Krufky authored
Add support for NXP TDA18271 as a standalone tuner, allowing the use of analog demodulators other than the Philips/NXP TDA829x. Signed-off-by:
-
Antti Palosaari authored
Signed-off-by:
Antti Palosaari <crope@iki.fi> Signed-off-by:
-
Antti Palosaari authored
Signed-off-by:
-
Antti Palosaari authored
increase BULK transfer size from 512 to 8192 to increase wakeups Signed-off-by:
-
Abylay Ospan authored
Signed-off-by:
Abylay Ospan <aospan@netup.ru> Signed-off-by:
-
Abylay Ospan authored
The card uses the same cx23885 gpio lines for two adapters. In case of there is several cards in system we must implement gpio mutex per cx23885 chip. Signed-off-by:
-
Olivier Lorin authored
- add the Genesys Logic 05e3:0503 and 05e3:f191 webcam Signed-off-by:
Olivier Lorin <o.lorin@laposte.net> Signed-off-by:
Jean-Francois Moine <moinejf@free.fr> Signed-off-by:
-
Jean-Francois Moine authored
Signed-off-by:
-
Antti Palosaari authored
Support for Reddo DVB-C USB TV Box device. Remote is not working yet. Thanks to Benjamin Larsson <banan@ludd.ltu.se> Cc: Benjamin Larsson <banan@ludd.ltu.se> Signed-off-by:
-
Antti Palosaari authored
add Philips CU1216L NIM Signed-off-by:
-
Hans Verkuil authored
The VIDIOC_G_STD ioctl may not be present in the case of radio receivers. In that case G_STD will return an error. The v4l1-compat layer should not attempt to propagate that error to the caller, instead it should be ignored. Signed-off-by:
Hans Verkuil <hverkuil@xs4all.nl> Signed-off-by:
-
Steven Toth authored
SAA7164: Add support for a new HVR-2250 hardware revision Signed-off-by:
Steven Toth <stoth@kernellabs.com> Signed-off-by:
-
Steven Toth authored
SAA7164: Ensure the HVR-2200 second tuner is configured in slave mode. Signed-off-by:
-
Steven Toth authored
SAA7164: Minor i2c assignment cleanup Signed-off-by:
-
Steven Toth authored
SAA7164: Remove meaningless if'0 code Signed-off-by:
-
Steven Toth authored
Ensure that by default all tuners are set correctly to master/slave mode. For all HVR2250's, ensure slave based tuners are caliberated during attach to avoid locking problems on tuner# above channel 91. HVR2200 tuner attach time to be reviewed in a future patch. Signed-off-by:
-
Steven Toth authored
SAA7164: Removed spurious debug Signed-off-by:
-
Steven Toth authored
In some cases we're seeing large timeouts on commands. I'm changing the implementation so that the deferred worker checks the PCI bus for any messages and signals the waiting caller accordingly. The previous mechanism was too unreliable. Signed-off-by:
-
Steven Toth authored
Signed-off-by:
-
Steven Toth authored
The firmware typically responds in < 50ms and, via the interrupts and deferred work queue the caller (blocked in the driver) is signalled very efficiently. In a highly stressed system this can take many multiples of seconds. So, we need a larger maximum timeout for busy systems. Signed-off-by:
-
Steven Toth authored
Cleanup a printk and output two helpful driver params in debug mode. Signed-off-by:
-
Steven Toth authored
Signed-off-by:
-
Steven Toth authored
Signed-off-by:
-
Steven Toth authored
Signed-off-by:
-
Steven Toth authored
Signed-off-by:
-
Steven Toth authored
Signed-off-by:
-
Steven Toth authored
Signed-off-by:
-
Steven Toth authored
Signed-off-by:
-
Steven Toth authored
Signed-off-by:
-
Steven Toth authored
It's timing out and aborting firmware load too quickly on some platforms, this increases the upper limit. Signed-off-by:
-
Steven Toth authored
Signed-off-by:
-
Steven Toth authored
SAA7164: Email address change Signed-off-by:
-
Steven Toth authored
SAA7164: Adjust I/F's to the TDA10048 enabling DVB-T lock Signed-off-by:
-
Steven Toth authored
SAA7164: Fix some 32/64bit compile time warnings Signed-off-by:
-
Steven Toth authored
This patch adds support for all of the known shipping Hauppauge HVR-2200 and HVR-2250 boards. Digital TV ATSC/QAM and DVB-T is enabled at this time. Both tuners are supported. Volatiles and typedefs need rework, the rest is coding style compliant. Signed-off-by:
-
Steven Toth authored
Add the SAA7164 I2C bus identifier Signed-off-by:
-
Mauro Carvalho Chehab authored
That was weird: on some distros, we need to remove <reference> tag for it to work. Signed-off-by: -
Mauro Carvalho Chehab authored
Signed-off-by:
-
