- 30 Nov, 2009 29 commits
-
-
Rudy Matela authored
Added a space separating some if keywords from the following parenthesis to conform to the CodingStyle. Signed-off-by:
Rudy Matela <rudy.matela@gmail.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Rudy Matela authored
Added a space separating some keywords (if/while) from the following parenthesis to conform to the CodingStyle. Signed-off-by:
-
Amit Kumar Salecha authored
Patch "fix memory initialization:5d521fd3" didn't got merge. Signed-off-by:
Amit Kumar Salecha <amit.salecha@qlogic.com> Signed-off-by:
-
Ben Hutchings authored
This driver has been mostly rewritten since Michael Brown's initial work, so swap the order of the authors. Signed-off-by:
Ben Hutchings <bhutchings@solarflare.com> Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
This integrates support for the SFC9000 family of 10G Ethernet controllers and LAN-on-motherboard chips, starting with the SFL9021 'Siena' and SFC9020 'Bethpage'. Credit for this code is largely due to my colleagues at Solarflare: Guido Barzini Steve Hodgson Kieran Mansley Matthew Slattery Neil Turton Signed-off-by:
-
Ben Hutchings authored
This adds support for the SFC9000 family of 10G Ethernet controllers and LAN-on-motherboard chips, starting with the SFL9021 'Siena' and SFC9020 'Bethpage'. The SFC9000 family is based on the SFC4000 'Falcon' architecture, but with some significant changes: - Two ports are associated with two independent PCI functions (except SFC9010) - Integrated 10GBASE-T PHY(s) (SFL9021/9022) - MAC, PHY and board peripherals are managed by firmware - Driver does not require board-specific code - Firmware supports wake-on-LAN and lights-out management through NC-SI - IPv6 checksum offload and RSS - Filtering by MAC address and VLAN (not included in this code) - PCI SR-IOV (not included in this code) Credit for this code is largely due to my colleagues at Solarflare: Guido Barzini Steve Hodgson Kieran Mansley Matthew Slattery Neil Turton Signed-off-by:
-
Steve Hodgson authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
nic.h is no longer specific to Falcon. Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
In new NICs flash is managed by firmware and we will use high-level operations on partitions rather than direct SPI commands. Add support for multiple MTD partitions per flash device and remove the direct link between MTD and SPI devices. Maintain a list of MTD partitions in struct efx_nic. Signed-off-by:
-
Ben Hutchings authored
New NICs have firmware managing the PHY, and we will discover the PHY capabilities at run-time. Replace the static data with probe() and test_name() operations. Signed-off-by:
-
Ben Hutchings authored
New NICs and PHYs support a wider variety of loopback modes. Signed-off-by:
-
Ben Hutchings authored
falcon_probe_nic_variant() does a lot less than it used to, and a lot less than it claims to. Fold the remainder into its caller. Signed-off-by:
-
Denis Kirjanov authored
Signed-off-by:
Denis Kirjanov <kirjanov@gmail.com> Signed-off-by:
-
Joe Perches authored
Not including net/atm/ Compiled tested x86 allyesconfig only Added a > 80 column line or two, which I ignored. Existing checkpatch plaints willfully, cheerfully ignored. Signed-off-by:
Joe Perches <joe@perches.com> Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Refactor efx_reset_down() and efx_reset_up() accordingly. Signed-off-by:
-
Ben Hutchings authored
Wake-on-LAN is a stub for Falcon, but will be implemented fully for new NICs. Signed-off-by:
-
Steve Hodgson authored
Use the efx_nic_type::monitor operation or event handling as appropriate. Signed-off-by:
-
Ben Hutchings authored
Refactor PHY, MAC and NIC configuration operations so that the existing link configuration can be re-pushed with: efx->phy_op->reconfigure(efx); efx->mac_op->reconfigure(efx); and a new configuration with: efx->nic_op->reconfigure_port(efx); (plus locking and error-checking). We have not held the link settings in software (aside from flow control), and have relied on asking the hardware what they are. This is a problem because in some cases the hardware may no longer be in a state to tell us. In particular, if an entire multi-port board is reset through one port, the driver bindings to other ports have no chance to save settings before recovering. We only actually need to keep track of the autonegotiation settings, so add an ethtool advertising mask to struct efx_nic, initialise it in PHY init and update it as necessary. Remove now-unneeded uses of efx_phy_op::{get,set}_settings() and struct ethtool_cmd. Much of this was done by Steve Hodgson <shodgson@solarflare.com>. Signed-off-by: -
Ben Hutchings authored
This is preparation for adding differing implementations for new NICs. Signed-off-by:
-
Ben Hutchings authored
Pause frame generation is gated by both RX_XOFF_MAC_EN and an enable bit in each MAC. RX_XOFF_MAC_EN bit always reads back as 0 so we need to set it correctly every time we modify RX_CFG_REG. Simplify this by always setting it to 1 and only changing the enable bits in the MACs. Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
This register only needs to be written after reset, not each time we enable interrupts. Signed-off-by:
-
- 29 Nov, 2009 11 commits
-
-
Eric Dumazet authored
pktgen threads are bound to given CPU, we can allocate memory for these threads in a NUMA aware way. After a pktgen session on two threads, we can check flows memory was allocated on right node, instead of a not related one. # grep pktgen_thread_write /proc/vmallocinfo 0xffffc90007204000-0xffffc90007385000 1576960 pktgen_thread_write+0x3a4/0x6b0 [pktgen] pages=384 vmalloc N0=384 0xffffc90007386000-0xffffc90007507000 1576960 pktgen_thread_write+0x3a4/0x6b0 [pktgen] pages=384 vmalloc N1=384 Signed-off-by:
Eric Dumazet <eric.dumazet@gmail.com> Signed-off-by:
-
David S. Miller authored
Conflicts: drivers/ieee802154/fakehard.c drivers/net/e1000e/ich8lan.c drivers/net/e1000e/phy.c drivers/net/netxen/netxen_nic_init.c drivers/net/wireless/ath/ath9k/main.c
-
PJ Waskiewicz authored
This patch extends the ethtool interface to display what PHY is currently connected to a NIC. The results can be viewed in ethtool ethX output. Signed-off-by:
Peter P Waskiewicz Jr <peter.p.waskiewicz.jr@intel.com> Signed-off-by:
Jeff Kirsher <jeffrey.t.kirsher@intel.com> Signed-off-by:
-
PJ Waskiewicz authored
This patch allows a base driver to specify Direct Attach as the type of port through the ethtool interface. Signed-off-by:
-
Shannon Nelson authored
This fixes an issue when clearing out the RAR entries. If RAR[0] is the only address in use, don't clear the others. Signed-off-by:
Shannon Nelson <shannon.nelson@intel.com> Signed-off-by:
-
Don Skidmore authored
82598 shouldn't try and access LINKS2 while configuring link and flow control. This is an 82599-only register. Signed-off-by:
Don Skidmore <donald.c.skidmore@intel.com> Signed-off-by:
-
PJ Waskiewicz authored
Flow Control autoneg should be disabled for certain adapters that don't support autonegotiation of Flow Control at 10 gigabit. These interfaces are the 10GBASE-T devices, CX4, and SFP+, all running at 10 gigabit only. 1 gigabit is fine. Signed-off-by:
-
Shannon Nelson authored
The driver was doing a divide by zero when adjusting tx-usecs. This patch removes the divide by zero code and changes the logic slightly to ignore tx-usecs in the case of shared TxRx vectors. Cc: Jesse Brandeburg <jesse.brandeburg@intel.com> Signed-off-by:
-
andrew hendry authored
Calls to x25_dev_get check for dev = NULL which was not set. It allowed x25 to set routes and ioctls on down interfaces. This caused oopses and refcnt problems on device_unregister. Signed-off-by:
Andrew Hendry <andrew.hendry@gmail.com> Signed-off-by:
-
andrew hendry authored
Adds error checking to x25_init. Signed-off-by:
-
andrew hendry authored
Moves the CONFIG_SYSCTL ifdefs in x25_init into header. Signed-off-by:
"Eric W. Biederman" <ebiederm@xmission.com> Signed-off-by:
-
