Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Also, make DDR latency configurable.
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Register number was incorrect in syscalls
that go via the restartblock (e.g, poll).
Signed-off-by: Edgar Iglesias <Edgar.Iglesias@axis.com>
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Add standard i2d-devices.
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Paths were not correct and pack_hex_byte() takes two arguments.
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Is after __bss_start, not __vmlinux_end
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Edgar Iglesias <Edgar.Iglesias@axis.com>
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Brings down the CPI from ~1.5 to ~1.1.
Signed-off-by: Edgar Iglesias <Edgar.Iglesias@axis.com>
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Edgar Iglesias <Edgar.Iglesias@axis.com>
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

The romfs should land after __init_end
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

We don't need to take the BKL here.
Also fixes compile error after last commit (smp_lock.h was not included)
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

copy_to_user()/copy_from_user() must not be used with spinlocks held.
Move locks inside each case so we have better control of when the locks
are held.

Also, since we use spinlocks, we don't need to hold the BKL, so remove it.
Reported-by: Kulikov Vasiliy <segooon@gmail.com>
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

All these files use the big kernel lock in a trivial
way to serialize their private file operations,
typically resulting from an earlier semi-automatic
pushdown from VFS.

None of these drivers appears to want to lock against
other code, and they all use the BKL as the top-level
lock in their file operations, meaning that there
is no lock-order inversion problem.

Consequently, we can remove the BKL completely,
replacing it with a per-file mutex in every case.
Using a scripted approach means we can avoid
typos.

file=$1
name=$2
if grep -q lock_kernel ${file} ; then
    if grep -q 'include.*linux.mutex.h' ${file} ; then
            sed -i '/include.*<linux\/smp_lock.h>/d' ${file}
    else
            sed -i 's/include.*<linux\/smp_lock.h>.*$/include <linux\/mutex.h>/g' ${file}
    fi
    sed -i ${file} \
        -e "/^#include.*linux.mutex.h/,$ {
                1,/^\(static\|int\|long\)/ {
                     /^\(static\|int\|long\)/istatic DEFINE_MUTEX(${name}_mutex);

} }"  \
    -e "s/\(un\)*lock_kernel\>[ ]*()/mutex_\1lock(\&${name}_mutex)/g" \
    -e '/[      ]*cycle_kernel_lock();/d'
else
    sed -i -e '/include.*\<smp_lock.h\>/d' ${file}  \
                -e '/cycle_kernel_lock()/d'
fi
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

From: Frederic Weisbecker <fweisbec@gmail.com>

Pushdown the bkl to the remaining drivers using the
deprecated .ioctl.
Signed-off-by: Frederic Weisbecker <fweisbec@gmail.com>
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>
Cc: Thomas Gleixner <tglx@linutronix.de>
Cc: John Kacur <jkacur@redhat.com>

As explained in commit 1c0fe6e3, we want to call the architecture independent
oom killer when getting an unexplained OOM from handle_mm_fault, rather than
simply killing current.
Signed-off-by: Nick Piggin <npiggin@suse.de>
Acked-by: David Rientjes <rientjes@google.com>
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>
Signed-off-by: Mikael Starvik <starvik@axis.com>

GENERIC_TIME was not functional for CRIS, giving random backward
time jumps.

For CRISv32 implement a new clocksource using the free running counter
and ditch the arch_gettimeoffset.

The random time jumps still existed, but turned out to be the write_seqlock
which was missing around our do_timer() call.

So switch over to GENERIC_TIME using the clocksource for CRISv32.

CRISv10 doesn't have the free running counter needed for the
clocksource trick, but we can still use GENERIC_TIME with
arch_gettimeoffset.

Unfortunately, there were problems in using the prescaler register
to timer0 for the gettimeoffset calculation, so it is now ignored,
making our resolution worse by the tune of 40usec (0.4%) worst case.

At the same time, clean up some formatting and use NSEC_PER_SEC
instead of 1000000000.
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>

Pass the correct end of the buffer to p9stat_read.
Signed-off-by: Latchesar Ionkov <lucho@ionkov.net>
Signed-off-by: Eric Van Hensbergen <ericvh@gmail.com>

When freeing a gpio that has not been exported, gpio_unexport() prints a
debug message when it should just fall through silently.

Example spurious message:

	gpio_unexport: gpio0 status -22
Signed-off-by: Jon Povey <jon.povey@racelogic.co.uk>
Cc: David Brownell <david-b@pacbell.net>
Acked-by: Uwe Kleine-K?nig <u.kleine-koenig@pengutronix.de>
Cc: Gregory Bean <gbean@codeaurora.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

The MPC85xx EDAC driver is missing module device aliases, so the driver
won't load automatically on boot.  This patch fixes the issue by adding
proper MODULE_DEVICE_TABLE() macros.
Signed-off-by: Anton Vorontsov <avorontsov@mvista.com>
Cc: Doug Thompson <dougthompson@xmission.com>
Cc: Peter Tyser <ptyser@xes-inc.com>
Cc: Dave Jiang <djiang@mvista.com>
Cc: Kumar Gala <galak@kernel.crashing.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

Fix the logic while writing new date/time to the chip.  The driver
incorrectly wrote back register values to different registers and even
with wrong mask.  The patch adds clearing of the VLF register, which
should be cleared if all date/time values are set.
Signed-off-by: Rudolf Marek <rudolf.marek@sysgo.com>
Acked-by: Wan ZongShun <mcuos.com@gmail.com>
Cc: Martyn Welch <martyn.welch@gefanuc.com>
Cc: Alessandro Zummo <a.zummo@towertech.it>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

The command

	echo "file ec.c +p" >/sys/kernel/debug/dynamic_debug/control

causes an oops.

Move the call to ddebug_remove_module() down into free_module().  In this
way it should be called from all error paths.  Currently, we are missing
the remove if the module init routine fails.
Signed-off-by: Jason Baron <jbaron@redhat.com>
Reported-by: Thomas Renninger <trenn@suse.de>
Tested-by: Thomas Renninger <trenn@suse.de>
Cc: <stable@kernel.org>		[2.6.32+]
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

* 'urgent' of git://git.kernel.org/pub/scm/linux/kernel/git/paulus/perf:
  perf, powerpc: Use perf_sample_data_init() for the FSL code

* git://git.infradead.org/users/cbou/battery-2.6.35:
  ds2782_battery: Rename get_current to fix build failure / name conflict

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6:
  s2io: fixing DBG_PRINT() macro
  ath9k: fix dma direction for map/unmap in ath_rx_tasklet
  net: dev_forward_skb should call nf_reset
  net sched: fix race in mirred device removal
  tun: avoid BUG, dump packet on GSO errors
  bonding: set device in RLB ARP packet handler
  wimax/i2400m: Add PID & VID for Intel WiMAX 6250
  ipv6: Don't add routes to ipv6 disabled interfaces.
  net: Fix skb_copy_expand() handling of ->csum_start
  net: Fix corruption of skb csum field in pskb_expand_head() of net/core/skbuff.c
  macvtap: Limit packet queue length
  ixgbe/igb: catch invalid VF settings
  bnx2x: Advance a module version
  bnx2x: Protect statistics ramrod and sequence number
  bnx2x: Protect a SM state change
  wireless: use netif_rx_ni in ieee80211_send_layer2_update

We should use perf_sample_data_init() to initialize struct
perf_sample_data.  As explained in the description of commit dc1d628a
("perf: Provide generic perf_sample_data initialization"), it is
possible for userspace to get the kernel to dereference data.raw,
so if it is not initialized, that means that unprivileged userspace
can possibly oops the kernel.  Using perf_sample_data_init makes sure
it gets initialized to NULL.

This conversion should have been included in commit dc1d628a, but it
got missed.
Signed-off-by: Peter Zijlstra <a.p.zijlstra@chello.nl>
Acked-by: Kumar Gala <kumar.gala@freescale.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

Merge branch 'x86-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip

* 'x86-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip:
  x86: Do not try to disable hpet if it hasn't been initialized before
  x86, i8259: Only register sysdev if we have a real 8259 PIC

Patch 9e39f7c5 changed the
DBG_PRINT() macro and the if clause was wrongly changed. It means
that currently all the DBG_PRINT are being printed, flooding the
kernel log buffer with things like:

s2io: eth6: Next block at: c0000000b9c90000
s2io: eth6: In Neterion Tx routine
Signed-off-by: Breno Leitao <leitao@linux.vnet.ibm.com>
Acked-by: Sreenivasa Honnur <Sreenivasa.Honnur@neterion.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

* 'fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/davej/cpufreq:
  [CPUFREQ] powernow-k8: Limit Pstate transition latency check
  [CPUFREQ] Fix PCC driver error path
  [CPUFREQ] fix double freeing in error path of pcc-cpufreq
  [CPUFREQ] pcc driver should check for pcch method before calling _OSC
  [CPUFREQ] fix memory leak in cpufreq_add_dev
  [CPUFREQ] revert "[CPUFREQ] remove rwsem lock from CPUFREQ_GOV_STOP call (second call site)"