Developing a driver for an Asus X205TA laptop I get these dmesg
errors:

 rt5645 i2c-10EC5648:00: ASoC: mux RT5650 IF1 ADC1 Swap Mux has no paths
 rt5645 i2c-10EC5648:00: ASoC: mux RT5650 IF1 ADC2 Swap Mux has no paths
 rt5645 i2c-10EC5648:00: ASoC: mux RT5650 IF1 ADC3 Swap Mux has no paths
 rt5645 i2c-10EC5648:00: ASoC: mux RT5650 IF1 ADC Mux has no paths
 rt5645 i2c-10EC5648:00: ASoC: mux RT5650 IF1 DAC1 L Mux has no paths
 rt5645 i2c-10EC5648:00: ASoC: mux RT5650 IF1 DAC1 R Mux has no paths
 rt5645 i2c-10EC5648:00: ASoC: mux RT5650 IF1 DAC2 L Mux has no paths
 rt5645 i2c-10EC5648:00: ASoC: mux RT5650 IF1 DAC2 R Mux has no paths

so, move these muxes to the rt5650_specific_dapm_widgets[] list.
Signed-off-by: Michele Curti <michele.curti@gmail.com>
Signed-off-by: Oder Chiou <oder_chiou@realtek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Since hp-detect is optional, use devm_gpiod_get_optional instead.
In additional, it should return error if devm_gpiod_get_optional fails.
Signed-off-by: Axel Lin <axel.lin@ingics.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Modify the RT5645 driver to parse platform data from device tree. This is
missing from previous patch in sound/soc/codecs/rt5645.c, that was present
in v3.
Signed-off-by: Bard Liao <bardliao@realtek.com>
Signed-off-by: Oder Chiou <oder_chiou@realtek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Move gpio to gpio_desc and use gpiod APIs in codec driver.
Signed-off-by: Bard Liao <bardliao@realtek.com>
Signed-off-by: Oder Chiou <oder_chiou@realtek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

ASoC: Updates for v4.2

The big thing this release has been Liam's addition of topology support
to the core.  We've also seen quite a bit of driver work and the
continuation of Lars' refactoring for component support.

 - Support for loading ASoC topology maps from firmware, intended to be
   used to allow self-describing DSP firmware images to be built which
   can map controls added by the DSP to userspace without the kernel
   needing to know about individual DSP firmwares.
 - Lots of refactoring to avoid direct access to snd_soc_codec where
   it's not needed supporting future refactoring.
 - Big refactoring and cleanup serieses for the Wolfson ADSP and TI
   TAS2552 drivers.
 - Support for TI TAS571x power amplifiers.
 - Support for Qualcomm APQ8016 and ZTE ZX296702 SoCs.
 - Support for x86 systems with RT5650 and Qualcomm Storm.

Modify the RT5645 driver to parse platform data from device tree.
Write a DT binding document to describe those properties.
Signed-off-by: Bard Liao <bardliao@realtek.com>
Signed-off-by: Oder Chiou <oder_chiou@realtek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Register RT5650_TDM_CTRL_4(0x7A) is readable and used for mixer
setting. It should be added in rt5645_readable_register function.
Signed-off-by: Bard Liao <bardliao@realtek.com>
Signed-off-by: Oder Chiou <oder_chiou@realtek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

rt5645_enable_push_button_irq uses snd_soc_dapm_*_unlocked
functions, so it needs to lock the required dapm mutex.
Signed-off-by: Nicolas Boichat <drinkcat@chromium.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

Merge remote-tracking branches 'asoc/topic/wm8994', 'asoc/topic/wm8996' and 'asoc/topic/zx' into asoc-next

Merge remote-tracking branches 'asoc/topic/topology', 'asoc/topic/twl6040', 'asoc/topic/wm5100', 'asoc/topic/wm8741' and 'asoc/topic/wm8960' into asoc-next

Merge remote-tracking branches 'asoc/topic/sta350', 'asoc/topic/tas2552', 'asoc/topic/tas3a227e' and 'asoc/topic/tas571x' into asoc-next

Merge remote-tracking branches 'asoc/topic/simple', 'asoc/topic/ssm2518', 'asoc/topic/ssm2602', 'asoc/topic/ssm4567' and 'asoc/topic/sta32x' into asoc-next

Merge remote-tracking branches 'asoc/topic/rt5677', 'asoc/topic/samsung' and 'asoc/topic/sgtl5000' into asoc-next

Merge remote-tracking branches 'asoc/topic/max98095', 'asoc/topic/omap', 'asoc/topic/pxa', 'asoc/topic/qcom' and 'asoc/topic/rcar' into asoc-next

Merge remote-tracking branches 'asoc/topic/gpiod-flags', 'asoc/topic/gtm601', 'asoc/topic/intel', 'asoc/topic/lm3857' and 'asoc/topic/max98090' into asoc-next

Merge remote-tracking branches 'asoc/topic/fsl', 'asoc/topic/fsl-sai', 'asoc/topic/fsl-spdif', 'asoc/topic/fsl-ssi' and 'asoc/topic/gpio-jack' into asoc-next

Merge remote-tracking branches 'asoc/topic/au1x', 'asoc/topic/bt-sco', 'asoc/topic/cs35l32' and 'asoc/topic/da7210' into asoc-next

Merge remote-tracking branches 'asoc/topic/adau1977', 'asoc/topic/adav80x', 'asoc/topic/arizona' and 'asoc/topic/atmel' into asoc-next

Merge remote-tracking branches 'asoc/topic/ac97', 'asoc/topic/ad1836', 'asoc/topic/ada1977', 'asoc/topic/adau1701' and 'asoc/topic/adau17x1' into asoc-next

Merge remote-tracking branches 'asoc/fix/wm8737', 'asoc/fix/wm8903' and 'asoc/fix/wm8955' into asoc-linus

Merge remote-tracking branches 'asoc/fix/arizona', 'asoc/fix/fmtbit', 'asoc/fix/max98925', 'asoc/fix/rcar' and 'asoc/fix/ux500' into asoc-linus

Instead of hard wiring the WCLK frequency at probe time do it runtime.
The hard wired 88_96KHz was not even setting the correct bits since it was
defined as (1 << 6) which will  change the I2S_OUT_SEL bit and will leave
the amplifier configured for 8KHz.
At the same time clean up and fix the CFG3 register bits.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Configure the word length based on the params_width of the stream.
Also configure the clock per frame value which is used when tas2552 is bus
master.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Certain sequence need to be followed in order to have smooth power up and
power down performance.
Execute this sequence via DAPM_POST widget.
Remove patching the RESERVED_0D register at probe time since it has to be
handled every time when we stop or start the amplifier.
In order to be able to execute the sequence at the correct time, the driver
need to request to ignore the pmdown time.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

The last parameter for DECLARE_TLV_DB_SCALE() is to tell if the gain will
be muted or not when it is set to raw 0. IN this case it is not muted.
The PGA_GAIN is in 0-4 bits in the register. Fix the offset in the
SOC_SINGLE_TLV() for this.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

The strings should be: 'static const char * const tas2552_input_texts[]'
SOC_DAPM_ENUM should have "Route" in place of xname and no need to have it
as an array.
Also align the parameters.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

TDM support is achieved using DSP transfer mode and setting a programmable
offset which specifies where data begins with respect to the frame sync.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Use names from the datasheet for the definitions.
Correct the data format definitions since they were not correct.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

DSP_A mode require one bit delay from the FS, DSP_B is without data delay.
When checking the requested format, also match the bit and fs inversion
flag along with the format since it is not possible to change inversion.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Instead of hard wiring the PLL_CLKIN and PDM_CLK to be sourced from BCLK add
proper clock configuration via the set_dai_sysclk callback.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Binding header file for clock input selection and configuration.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Prevents frequent panic on boot, if the irq handler rt5645_irq
gets called before the workqueue rt5645_jack_detect_work is
initialized.
Signed-off-by: Nicolas Boichat <drinkcat@chromium.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
Cc: stable@vger.kernel.org

sound/soc/zte/zx296702-i2s.c:428:3-8: No need to set .owner here. The core will do it.

 Remove .owner field if calls are used which set it automatically

Generated by: scripts/coccinelle/api/platform_no_drv_owner.cocci
Signed-off-by: Fengguang Wu <fengguang.wu@intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

MCLK is one of the possible source for the pll_clkin frequency. Make this
clear by renaming the variable.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>