Jesse Barnes provided the original version of this patch months ago, but
other changes kept conflicting with it, so it got deferred.  Greg Edwards
dug it out of obscurity just over a week ago, and almost immediately
another conflicting patch appeared (Bob Picco's memory-less nodes).

I've resolved the conflicts and got it running again.  CONFIG_SGI_TIOCX
is set to "y" in defconfig, which causes a Tiger to not boot (oops in
tiocx_init).  But that can be resolved later ... get this in now before it
gets stale again.
Signed-off-by: Tony Luck <tony.luck@intel.com>

I reworked how nodes with only CPUs are treated.  The patch below seems
simpler to me and has eliminated the complicated routine
reassign_cpu_only_nodes.  There isn't any longer the requirement
to modify ACPI NUMA information which was in large part the
complexity introduced in reassign_cpu_only_nodes. 

This patch will produce a different number of nodes. For example,
reassign_cpu_only_nodes would reduce two CPUonly nodes and one memory node
configuration to one memory+CPUs node configuration.  This patch
doesn't change the number of nodes which means the user will see three.  Two
nodes without memory and one node with all the memory.

While doing this patch, I noticed that early_nr_phys_cpus_node isn't serving
any useful purpose.  It is called once in find_pernode_space but the value
isn't used to computer pernode space.  
Signed-off-by: bob.picco <bob.picco@hp.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

Signed-off-by: Keith Owens <kaos@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

restore_sigcontext calls ia64_set_local_fpu_owner() which requires that
preempt be disabled.
Signed-off-by: Keith Owens <kaos@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

This patch fixes an issue with the PROM and a kernel running with
CONFIG_PREEMPT enabled.  When CONFIG_PREEMPT is enabled, the size of a
spinlock_t changes -- resulting in the PROM writing to an incorrect location.
Signed-off-by: Prarit Bhargava <prarit@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

This patch is the SGI hotplug driver and additional changes required for
the driver.  These modifications include changes to the SN io_init.c code
for memory management, the inclusion of new SAL calls to enable and disable
PCI slots, and a hotplug-style driver.
Signed-off-by: Prarit Bhargava <prarit@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

This patch is a rewrite of the code to check the PROM version.  The current
code has some deficiences in the way PROM comparisons were made.  The minimum
value of PROM that will boot has also been changed to 4.04.
Signed-off-by: Prarit Bhargava <prarit@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

The pci_find_next_bus function is listed as being exported to drivers.  It is
not EXPORT_SYMBOL'd.
Signed-off-by: Prarit Bhargava <prarit@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

This patch moves header files out of the arch/ia64/sn directories and into
include/asm-ia64/sn.  These files were being included by other subsystems
and should be under include/asm-ia64/sn.
Signed-off-by: Prarit Bhargava <prarit@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

This patch  fixes the SN IRQ code such that cpu affinity and
Hotplug can modify IRQ values.  The sn_irq_info structures are now locked
using a RCU lock mechanism to avoid lock contention in the lost interrupt
WAR code.
Signed-off-by: Prarit Bhargava <prarit@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

Just the declaration fix wasn't enough to fix things in bt78x.c
Signed-off-by: Dave Jones <davej@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This patch used to be in Andrew's tree before the NUMA slab allocator went
in. Either this patch or the NUMA slab allocator is needed in order for
kmalloc_node to work correctly.

pcibus_to_node may be used to generate the node information passed to
kmalloc_node. pcibus_to_node returns -1 if it was not able to determine
on which node a pcibus is located. For that case kmalloc_node must
work like kmalloc.
Signed-off-by: Christoph Lameter <christoph@lameter.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Missing forward declaration
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Here's a patch to fix the build issue when CONFIG_HOTPLUG is not enabled
in 2.6.13-rc2.
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

The membar changes made the size of __cheetah_flush_tlb_pending
grow by one instruction, but the boot-time code patching was
not updated to match.
Signed-off-by: David S. Miller <davem@davemloft.net>

The following renames arch_init, a kprobes function for performing any
architecture specific initialization, to arch_init_kprobes in order to
cleanup the namespace.

Also, this patch adds arch_init_kprobes to sparc64 to fix the sparc64 kprobes
build from the last return probe patch.
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Add explicit disabling of 440GP IRQ compatibility mode when configuring
440GX interrupt controller.  This helps when board firmware for some reason
uses this compatibility mode and leaves it enabled.  It breaks 440GX
interrupt code because it assumes native 440GX IRQ mode.  People seems to
be continuously bitten by this.
Signed-off-by: Eugene Surovegin <ebs@ebshome.net>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

As part of my timeofday rework, I've been looking at the NTP code and I
noticed that the PPC architecture is apparently misusing the NTP's
time_offset (it is a terrible name!) value as some form of timezone offset.

This could cause problems when time_offset changed by the NTP code.  This
patch changes the PPC code so it uses a more clear local variable:
timezone_offset.
Signed-off-by: John Stultz <johnstul@us.ibm.com>
Acked-by: Tom Rini <trini@kernel.crashing.org>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This patch adds the Freescale MPC86xADS board support.  The supported
devices are SMC UART and 10Mbit ethernet on SCC1.

The manual for the board says that it "is compatible with the MPC8xxFADS
for software point of view".  That's why this patch extends FADS instead of
introducing a new platform.

FEC is not supported as the "combined FCC/FEC ethernet driver" driver by
Pantelis Antoniou should replace the current FEC driver.
Signed-off-by: Gennadiy Kurtsman <gkurtsman@ru.mvista.com>
Signed-off-by: Andrei Konovalov <akonovalov@ru.mvista.com>
Acked-by: Tom Rini <trini@kernel.crashing.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Robert Olsson <Robert.Olsson@data.slu.se>
Signed-off-by: David S. Miller <davem@davemloft.net>

Congestion window recover after loss depends upon the fact
that if we have a full MSS sized frame at the head of the
send queue, we will send it.  TSO deferral can defeat the
ACK clocking necessary to exit cleanly from recovery.
Signed-off-by: David S. Miller <davem@davemloft.net>

Useful in combination with classful qdiscs to drop or
temporary disable certain flows, e.g. one could block
specific ds flows with dsmark.

Unlike the noop qdisc it can be controlled by the user and
statistic accounting is done.
Signed-off-by: Thomas Graf <tgraf@suug.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>

Make TSO segment transmit size decisions at send time not earlier.

The basic scheme is that we try to build as large a TSO frame as
possible when pulling in the user data, but the size of the TSO frame
output to the card is determined at transmit time.

This is guided by tp->xmit_size_goal.  It is always set to a multiple
of MSS and tells sendmsg/sendpage how large an SKB to try and build.

Later, tcp_write_xmit() and tcp_push_one() chop up the packet if
necessary and conditions warrant.  These routines can also decide to
"defer" in order to wait for more ACKs to arrive and thus allow larger
TSO frames to be emitted.

A general observation is that TSO elongates the pipe, thus requiring a
larger congestion window and larger buffering especially at the sender
side.  Therefore, it is important that applications 1) get a large
enough socket send buffer (this is accomplished by our dynamic send
buffer expansion code) 2) do large enough writes.
Signed-off-by: David S. Miller <davem@davemloft.net>

This makes it easier to understand, and allows easier
tweaking of the heuristic later on.
Signed-off-by: David S. Miller <davem@davemloft.net>

In tcp_clean_rtx_queue(), if the TSO packet is not even partially
acked, do not waste time calling tcp_tso_acked().
Signed-off-by: David S. Miller <davem@davemloft.net>

Everything stated there is out of data.  tcp_trim_skb()
does adjust the available socket send buffer space and
skb->truesize now.
Signed-off-by: David S. Miller <davem@davemloft.net>

Only put user data purely to pages when doing TSO.

The extra page allocations cause two problems:

1) Add the overhead of the page allocations themselves.
2) Make us do small user copies when we get to the end
   of the TCP socket cache page.

It is still beneficial to purely use pages for TSO,
so we will do it for that case.
Signed-off-by: David S. Miller <davem@davemloft.net>

tcp_snd_test() is run for every packet output by a single
call to tcp_write_xmit(), but this is not necessary.

For one, the congestion window space needs to only be
calculated one time, then used throughout the duration
of the loop.

This cleanup also makes experimenting with different TSO
packetization schemes much easier.
Signed-off-by: David S. Miller <davem@davemloft.net>

tcp_snd_test() does several different things, use inline
functions to express this more clearly.

1) It initializes the TSO count of SKB, if necessary.
2) It performs the Nagle test.
3) It makes sure the congestion window is adhered to.
4) It makes sure SKB fits into the send window.

This cleanup also sets things up so that things like the
available packets in the congestion window does not need
to be calculated multiple times by packet sending loops
such as tcp_write_xmit().
Signed-off-by: David S. Miller <davem@davemloft.net>

'nonagle' should be passed to the tcp_snd_test() function
as 'TCP_NAGLE_PUSH' if we are checking an SKB not at the
tail of the write_queue.  This is because Nagle does not
apply to such frames since we cannot possibly tack more
data onto them.

However, while doing this __tcp_push_pending_frames() makes
all of the packets in the write_queue use this modified
'nonagle' value.

Fix the bug and simplify this function by just calling
tcp_write_xmit() directly if sk_send_head is non-NULL.

As a result, we can now make tcp_data_snd_check() just call
tcp_push_pending_frames() instead of the specialized
__tcp_data_snd_check().
Signed-off-by: David S. Miller <davem@davemloft.net>

tcp_write_xmit() uses tcp_current_mss(), but some of it's callers,
namely __tcp_push_pending_frames(), already has this value available
already.

While we're here, fix the "cur_mss" argument to be "unsigned int"
instead of plain "unsigned".
Signed-off-by: David S. Miller <davem@davemloft.net>

Put the main basic block of work at the top-level of
tabbing, and mark the TCP_CLOSE test with unlikely().
Signed-off-by: David S. Miller <davem@davemloft.net>

The tcp_cwnd_validate() function should only be invoked
if we actually send some frames, yet __tcp_push_pending_frames()
will always invoke it.  tcp_write_xmit() does the call for us,
so the call here can simply be removed.

Also, tcp_write_xmit() can be marked static.
Signed-off-by: David S. Miller <davem@davemloft.net>

When we add any new packet to the TCP socket write queue,
we must call skb_header_release() on it in order for the
TSO sharing checks in the drivers to work.
Signed-off-by: David S. Miller <davem@davemloft.net>

It reimplements portions of tcp_snd_check(), so it
we move it to tcp_output.c we can consolidate it's
logic much easier in a later change.
Signed-off-by: David S. Miller <davem@davemloft.net>

This just moves the code into tcp_output.c, no code logic changes are
made by this patch.

Using this as a baseline, we can begin to untangle the mess of
comparisons for the Nagle test et al.  We will also be able to reduce
all of the redundant computation that occurs when outputting data
packets.
Signed-off-by: David S. Miller <davem@davemloft.net>