- 03 Apr, 2008 6 commits
-
-
René Bürgel authored
This gets the FEC ethernet driver working again on the lite5200 platform. The FEC driver is also compatible with the MPC5200, not only with the MPC5200B, so this adds a suitable entry to the driver's match list. Furthermore this adds the settings for the PHY in the dts file for the Lite5200. Note, that this is not exactly the same as in the Lite5200B, because the PHY is located at f0003000:01 for the 5200, and at :00 for the 5200B. This was tested on a Lite5200 and a Lite5200B, both booted a kernel via tftp and mounted the root via nfs successfully. Signed-off-by:
René Bürgel <r.buergel@unicontrol.de> Acked-by:
Grant Likely <grant.likely@secretlab.ca> Signed-off-by:
Paul Mackerras <paulus@samba.org>
-
Bartlomiej Sieka authored
DTS updates that fix booting problems on mpc5200-based boards: - change to ethernet reg property - addition of mdio and phy nodes - removal of pci node (Motion-Pro board) Other DTS updates: - update i2c device tree nodes - add lpb bus node and flash device (without partitions defined) - add rtc i2c nodes Signed-off-by:
Marian Balakowicz <m8@semihalf.com> Acked-by:
-
Maxim Shchetynin authored
Handling of the proc_dir_entry->count was changed in 2.6.24-rc5. After this change, the default value for pde->count is 1 and not 0 as before. Therefore, if we want to check whether our procfs file is already opened (already in use), we have to check if pde->count is greater than 2 rather than 1. Signed-off-by:
Maxim Shchetynin <maxim@de.ibm.com> Signed-off-by:
Jens Osterkamp <jens@de.ibm.com> Signed-off-by:
-
Benjamin Herrenschmidt authored
hash_page_sync() takes and releases the low level mmu hash lock in order to sync with other processors disposing of page tables. Because that lock can be needed to service hash misses triggered by interrupt handlers, taking it must be done with interrupts off. However, hash_page_sync() appears to be called with interrupts enabled, thus causing occasional deadlocks. We fix it by making sure hash_page_sync() masks interrupts while holding the lock. Signed-off-by:
Benjamin Herrenschmidt <benh@kernel.crashing.org> Signed-off-by:
-
Benjamin Herrenschmidt authored
A subtle bug sneaked into iSeries recently. On this platform, we must not normally clear MSR:EE (the hardware external interrupt enable) except for short periods of time. Taking an interrupt while soft-disabled doesn't cause us to clear it for example. The iSeries kernel expects to mostly run with MSR:EE enabled at all times except in a few exception entry/exit code paths. Thus local_irq_enable() doesn't check if it needs to hard-enable as it expects this to be unnecessary on iSeries. However, hard_irq_disable() _does_ cause MSR:EE to be cleared, including on iSeries. A call to it was recently added to the context switch code, thus causing interrupts to become disabled for a long periods of time, causing the iSeries watchdog to kick in under some circumstances and other nasty things. This patch fixes it by making local_irq_enable() properly re-enable MSR:EE on iSeries. It basically removes a return statement here to make iSeries use the same code path as everybody else. That does mean that we might occasionally get spurious decrementer interrupts but I don't think that matters. Another option would have been to make hard_irq_disable() a nop on iSeries but I didn't like it much, in case we have good reasons to hard-disable. Part of the patch is fixes to make sure the hard_enabled PACA field is properly set on iSeries as it used not to be before, since it was mostly unused. Signed-off-by:
-
Laurent Pinchart authored
A missing break statement in a switch caused cpm2_clk_setup() to initialize SCC2 instead of SCC1. Signed-off-by:
Laurent Pinchart <laurentp@cse-semaphore.com> Signed-off-by:
Kumar Gala <galak@kernel.crashing.org>
-
- 31 Mar, 2008 5 commits
-
-
Kumar Gala authored
The new rtc subsystem conflicts with genrtc so don't enable GENRTC if RTCLIB is enabled. Signed-off-by: -
Kumar Gala authored
Documentation/powerpc/booting-without-of.txt specifies the compatiables we should bind to for this driver (elo, eloplus). Use these instead of the extremely specific 'mpc8540' and 'mpc8349' compatiables. Acked-by:
Dan Williams <dan.j.williams@intel.com> Signed-off-by:
-
Kim Phillips authored
as prescribed in Documentation/powerpc/booting-without-of.txt. Signed-off-by:
Kim Phillips <kim.phillips@freescale.com> Acked-by:
Jeff Garzik <jeff@garzik.org> Signed-off-by:
-
Kim Phillips authored
Signed-off-by:
-
Anton Vorontsov authored
Due to chip constraint MPC837x USB DR module can only use ULPI and serial PHY interfaces. The patch fixes the wrong type in dts. This patch fixes USB malfunctioning on the MPC837xE-RDB boards. Similar patch has been already applied for the MDS boards: commit 28b95885 Author: Li Yang <leoli@freescale.com> Date: Thu Mar 6 18:42:26 2008 +0800 [POWERPC] 83xx: Fix wrong USB phy type in mpc837xmds dts Signed-off-by:
Anton Vorontsov <avorontsov@ru.mvista.com> Signed-off-by:
-
- 30 Mar, 2008 29 commits
-
-
Mark Lord authored
Mark Lord wrote: > > On boot, syslog is flooded with "uevent: unsupported action-string;" messages. .. > Mar 28 14:43:29 shrimp kernel: tty ptyqd: uevent: unsupported > action-string; this will be ignored in a future kernel version > Mar 28 14:43:29 shrimp kernel: tty ptyqe: uevent: unsupported > action-string; this will be ignored in a future kernel version > Mar 28 14:43:29 shrimp kernel: tty ptyqf: uevent: unsupported > action-string; this will be ignored in a future kernel version > Mar 28 14:43:29 shrimp kernel: tty ptyr0: uevent: unsupported > action-string; this will be ignored in a future kernel version .. These messages are a regression compared with 2.6.24, which did not flood the syslog with them. The actual underlying problem was introduced in 2.6.23, when somebody made the string parsing no longer accept nul-terminated strings as a valid input to store_uevent(). Eg. "add\0" was valid prior to 2.6.23, where the code regressed to require "add" without the '\0'. This patch fixes the 2.6.23 / 2.6.24 regressions, by having the code once again tolerate the trailing '\0', if present. According to GregKH, this mainly affects older Ubuntu systems, such as the one I have here that requires this fix. Signed-off-by:
Mark Lord <mlord@pobox.com> Signed-off-by:
Linus Torvalds <torvalds@linux-foundation.org>
-
Björn Steinbrink authored
When getting disconnected we need to release eventual grabs on the underlying input device as we also release the input device itself. Otherwise, we would try to release the grab when the client that requested it closes its handle, accessing the input device which might already be freed. Signed-off-by:
Björn Steinbrink <B.Steinbrink@gmx.de> Signed-off-by:
-
Adrian Bunk authored
I accidentally removed the module license from sound/oss/ac97_codec.c in commit 83bad1d7 ("scheduled OSS driver removal") Spotted by Roland <devzero@web.de>. Signed-off-by:
Adrian Bunk <bunk@kernel.org> Signed-off-by:
-
git://git.kernel.org/pub/scm/linux/kernel/git/airlied/drm-2.6Linus Torvalds authored
* 'drm-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/airlied/drm-2.6: drm: fix for non-coherent DMA PowerPC drm: radeon: fix sparse integer as NULL pointer warnings in radeon_mem.c drm/i915: fix oops on agp=off drm/r300: fix bug in r300 userspace hardware wait emission
-
git://git.kernel.org/pub/scm/linux/kernel/git/jgarzik/libata-devLinus Torvalds authored
* 'upstream-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jgarzik/libata-dev: libata: ATA_EHI_LPM should be ATA_EH_LPM pata_sil680: only enable MMIO on Cell blades
-
git://git.kernel.org/pub/scm/linux/kernel/git/bart/ide-2.6Linus Torvalds authored
* git://git.kernel.org/pub/scm/linux/kernel/git/bart/ide-2.6: ide: fix defining SUPPORT_VLB_SYNC Revert "ide: change master/slave IDENTIFY order"
-
Al Viro authored
Signed-off-by:
Al Viro <viro@zeniv.linux.org.uk> Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
a) every bitwise declaration will give a unique type; use typedefs. b) no need to bother with the stuff pointed to by iomem pointers, unless it's accessed directly. noderef will force us to use helpers anyway. Signed-off-by: -
Al Viro authored
Signed-off-by:
-
Al Viro authored
NB: remaining endianness warnings in the file are, AFAICS, real bugs. Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
aka if you see a force-cast, be very suspicious... Signed-off-by:
Frank Seidel <fseidel@suse.de> Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Signed-off-by:
Harvey Harrison <harvey.harrison@gmail.com> Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Acked-by:
-
Al Viro authored
Signed-off-by:
-
Al Viro authored
Signed-off-by:
-
