A big update to the ColdFire FEC ethernet driver.
This has been in the works for a while (and thus tested for
a while too). Fundamentally through there is 3 important
changes:

. support 528x and 527x device families
. allow for multiple FEC devices to be present (for example 2 on the 5274/5)
. support the Kendein 8721 PHY
Signed-off-by: Greg Ungerer <gerg@snapgear.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Move the PIT timer code from the 5282 specific platform directory
to the common ColdFire platform code directory (5307). Freescale
are using the PIT timer on other devices now (at least the 523x and
527x families), so put it near the other common timer code so they
can all use it easily.
Signed-off-by: Greg Ungerer <gerg@snapgear.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Sun tells me:

  For many years both Solaris x86 and Linux have used the same fdisk
  partition id of 0x82.  Solaris uses that identifier to allocate disk
  space which is then further subdivided by the Solaris VTOC (Volume
  Table of Contents) and Linux uses that id as the identifier for its
  swap partition.

  The new release of Solaris should be out early next year. Solaris
  will begin using a partition id of 0xbf.  We will continue to support
  the older partition id value of 0x82 for compatibility reasons.

  Solaris's fdisk program has been enhanced to allow system administrators
  to switch back and forth between the new and old identifier without any
  loss of data.

So, this may be useful to some people a few months from now.

Not surprisingly, the ext3 code crashes in the same way
the ext2 code does when dividing by zero.

I have directories full of typo corrections - don't know
whether you want them. Below some wierds.

Added the hp and 5xbsd flavors of ufstype.

Removed barrier - it is not an ext2 option.

Corrected the distinction between kernel-selected defaults and values
read from the filesystem.

Fixed some typos.  Shortened line length to 80.

This implements support for doing a HW synchronization of the CPU
timebases on SMP G5 machines.

 When the proper clock chips are found on i2c, they are used to stop the
timebase clock source during the synchronization process.  This replaces
the software sync algorithm we used so far and provides slightly more
precise results.
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

The code in pmac_low_i2c.c is a low level synchronous version of the i2c keywest
driver for use by platform code early during boot or during sleep/wakeup cycles
to communicate with some motherboard chips, typically clock chips.
It wasn't used on g5 until now, which is good because it wasn't 64 bits clean :)

This patch fixes it, and also remove the use of udelay() since it can be used for
synchronizing the HW timebase, and so must operate when it's frozen (and our
implementation of udelay uses that timebase).
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

Thanks to Kay Sievers for reporting this. 

Was caused by a change from Venkatesh Pallipadi as seen at:
  http://linux.bkbits.net:8080/linux-2.5/cset@41810e4aGZ0E5bn_hMb4JgIY5u90zASigned-off-by: Greg Kroah-Hartman <greg@kroah.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

EFI partitioning scheme was reading the last reported sector of the
block device to look for the alternate GPT header, before it had
confirmed that it should.  This causes problems for devices with the
following problems:  a) those who misreport their size (typically
off-by-one), and b) those who fail when asked to read a block
outside their range.

This patch moves the test for the Protective Master Boot Record (PMBR)
ahead of the tests for the Primary and Alternate GPT headers.  If the
PMBR is not valid, the disk is assumed to not be a GPT disk.  This can
be overridden with the 'gpt' kernel command line option.  If the
Primary GPT header is not valid, the Alternate GPT header is not
probed automatically unless the 'gpt' kernel command line option is
passed.  If the both the PMBR and Primary GPT header are valid, then
the Alternate GPT header at the end of the disk is probed.

Also re-enables CONFIG_EFI_PARTITION for all architectures.
Signed-off-by: Matt Domsch <Matt_Domsch@dell.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This fixes a problem introduced in the previous set of driver model
changes that has been seen by a lot of people (most notibly the greater
than 256 pty users, but others might also be hitting this without
realizing it.)

Also add a comment so we don't try to "fix" this again.
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

into intel.com:/home/lenb/src/26-latest-dev

into intel.com:/home/lenb/src/26-latest-dev

Signed-off-by: Len Brown <len.brown@intel.com>

into intel.com:/home/lenb/src/26-latest-dev

into ppc970.osdl.org:/home/torvalds/v2.6/linux

If you call drivers/md/dm-io.c:resize_pool on an empty pool and
mempool_create is unable to make the pool, the condition is not handled
correctly, resulting in an oops in mempool_destroy.

Trivial fix.

Minor changes required to port kprobes for sparc64.

- arch_prepare_kprobe() returns an integer.

- added arch_remove_kprobe().

- changes to access copy of original instruction, since kprobe_opcode_t
  insn[MAX_INSN_SIZE] is moved from struct kprobe to a struct
  arch_specific_insn.
Signed-off-by: Prasanna S Panchamukhi <prasanna@in.ibm.com>
Cc: "David S. Miller" <davem@davemloft.net>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

released the tasklist_lock.

Since it released the lock, the process lists may not
be valid any more, and we must repeat the loop rather than
continue with the next parent.

Use -EAGAIN to show this condition (separate from the
normal -EFAULT that may happen if rusage information could
not be copied to user space).

into kroah.com:/home/greg/linux/BK/i2c-2.6

Signed-off-by: Jean Delvare <khali@linux-fr.org>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

This patch integrates several fixes to the s3c2410 i2c
driver

Shannon Holland:

	- write IICCON in configuration code
	- add handling for s3c2410 i2c errata
	- fix clock rate divisor calculation

Ben Dooks:

	- s3c2440 detection
	- s3c2440 IICLC register setup
	- add __exit to the module exit
	- remove return from exit code
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
Signed-off-by: Shannon Holland <holland@loser.net>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

The patch below makes some needlessly global code under i2c/busses/
static.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

The patch adds a check at the beginning of i2c_del_adapter in case
someone attempts to remove an adapter that was never added in the first
place. This sounds like a good safety, as doing so will lead to an oops
at the moment. Also, I have a need for it in the latest version of my
i2c-amd756-s4882 patch. I need to remove the original adapter and
install the virtual ones instead, but I have no way to know if the
original adapter was succesfully added beforehand or not.
Signed-off-by: Jean Delvare <khali@linux-fr.org>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Justin Thiessen <jthiessen@penguincomputing.com>
Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

Signed-off-by: Greg Kroah-Hartman <greg@kroah.com>

into ppc970.osdl.org:/home/torvalds/v2.6/linux