Signed-off-by: Krzysztof Hałasa <khc@pm.waw.pl>

Merge branch 'iommu' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap-2.6.git into devel

Signed-off-by: Krzysztof Hałasa <khc@pm.waw.pl>

Signed-off-by: Krzysztof Hałasa <khc@pm.waw.pl>

Signed-off-by: Krzysztof Hałasa <khc@pm.waw.pl>

Signed-off-by: Krzysztof Hałasa <khc@pm.waw.pl>

Signed-off-by: Krzysztof Hałasa <khc@pm.waw.pl>

Signed-off-by: Krzysztof Hałasa <khc@pm.waw.pl>

Signed-off-by: Krzysztof Hałasa <khc@pm.waw.pl>

Conflicts:
	arch/arm/Kconfig
	arch/arm/Makefile

Currently "tidspbridge" driver uses its own mmu implementation and
will migrate to use this "omap iommu" eventually. This config is
provided to make this migration happen smoothly.
Signed-off-by: Hiroshi DOYU <Hiroshi.DOYU@nokia.com>

Signed-off-by: Hiroshi DOYU <Hiroshi.DOYU@nokia.com>

Signed-off-by: Hiroshi DOYU <Hiroshi.DOYU@nokia.com>

Signed-off-by: Krzysztof Hałasa <khc@pm.waw.pl>

This patch provides a device drivers, which has a omap iommu, with
address mapping APIs between device virtual address(iommu), physical
address and MPU virtual address.

There are 4 possible patterns for iommu virtual address(iova/da) mapping.

    |iova/			  mapping		iommu_		page
    | da	pa	va	(d)-(p)-(v)		function	type
  ---------------------------------------------------------------------------
  1 | c		c	c	 1 - 1 - 1	  _kmap() / _kunmap()	s
  2 | c		c,a	c	 1 - 1 - 1	_kmalloc()/ _kfree()	s
  3 | c		d	c	 1 - n - 1	  _vmap() / _vunmap()	s
  4 | c		d,a	c	 1 - n - 1	_vmalloc()/ _vfree()	n*

    'iova':	device iommu virtual address
    'da':	alias of 'iova'
    'pa':	physical address
    'va':	mpu virtual address

    'c':	contiguous memory area
    'd':	dicontiguous memory area
    'a':	anonymous memory allocation
    '()':	optional feature

    'n':	a normal page(4KB) size is used.
    's':	multiple iommu superpage(16MB, 1MB, 64KB, 4KB) size is used.

    '*':	not yet, but feasible.
Signed-off-by: Hiroshi DOYU <Hiroshi.DOYU@nokia.com>

Signed-off-by: Hiroshi DOYU <Hiroshi.DOYU@nokia.com>

The i.MX31 PDK consists of several boards, one of them is a debug
board containing a CPLD which controls some debug leds, switch
buttons, an interrupt chip and an Ethernet controller.
This patch adds support for detecting if the PDK board is present
(during boot) and adds the interrupt chip to the kernel.
Signed-off-by: Magnus Lilja <lilja.magnus@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

Without this patch we end up with a log message like
"mx3_sdc_fb mx3_sdc_fb: mx3fb: fb registered". That's two fb
too much for my taste.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

Restructure UART pin setup in preparation for adding other pins
in later patches.
Signed-off-by: Magnus Lilja <lilja.magnus@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

From ff1fd9d7015d9b9ad3e0df2016d0415e2719747c Mon Sep 17 00:00:00 2001
From: Alberto Panizzo <maramaopercheseimorto@gmail.com>
Date: Fri, 15 May 2009 17:21:21 +0200
Subject: [PATCH] Make sure ipg_per_clk is generated by ipg_clk and not usb_pll
Signed-off-by: Alberto Panizzo <maramaopercheseimorto@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

Signed-off-by: Magnus Lilja <lilja.magnus@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jbarnes/pci-2.6:
  PCI MSI: Fix MSI-X with NIU cards
  PCI: Fix pci-e port driver slot_reset bad default return value

* git://git.kernel.org/pub/scm/linux/kernel/git/holtmann/bluetooth-2.6:
  Bluetooth: Don't trigger disconnect timeout for security mode 3 pairing
  Bluetooth: Don't use hci_acl_connect_cancel() for incoming connections
  Bluetooth: Fix wrong module refcount when connection setup fails

Another case of me handling the fallout from Davem's unfortunate
addiction to shuffleboard.

Won't anybody think of the children? Join the anti-shuffleboard league
today!

* 'drm-intel-next' of git://git.kernel.org/pub/scm/linux/kernel/git/anholt/drm-intel:
  drm/i915: Add new GET_PIPE_FROM_CRTC_ID ioctl.
  drm/i915: Set HDMI hot plug interrupt enable for only the output in question.
  drm/i915: Include 965GME pci ID in IS_I965GM(dev) to match UMS.
  drm/i915: Use the GM45 VGA hotplug workaround on G45 as well.
  drm/i915: ignore LVDS on intel graphics systems that lie about having it
  drm/i915: sanity check IER at wait_request time
  drm/i915: workaround IGD i2c bus issue in kernel side (v2)
  drm/i915: Don't allow binding objects into the last page of the aperture.
  drm/i915: save/restore fence registers across suspend/resume
  drm/i915: x86 always has writeq. Add I915_READ64 for symmetry.

* 'upstream-linus' of ssh://master.kernel.org/pub/scm/linux/kernel/git/jgarzik/libata-dev:
  libata: Media rotation rate and form factor heuristics
  libata: Report disk alignment and physical block size
  sata_fsl: Fix the command description of FSL SATA controller
  sata_fsl: Fix compile warnings
  [libata] sata_sx4: fixup interrupt handling
  [libata] sata_sx4: convert to new exception handling methods

* git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless-2.6:
  iwlwifi: fix device id registration for 6000 series 2x2 devices
  ath5k: update channel in sw state after stopping RX and TX
  rtl8187: use DMA-aware buffers with usb_control_msg
  mac80211: avoid NULL ptr deref when finding max_rates in PID and minstrel
  airo: airo_get_encode{,ext} potential buffer overflow

Pulled directly by Linus because Davem is off playing shuffle-board at
some Alaskan cruise, and the NULL ptr deref issue hits people and should
get merged sooner rather than later.

David - make us proud on the shuffle-board tournament!

This patch provides new heuristics for parsing both the form factor and
media rotation rate ATA IDENFITY words.

The reported ATA version must be 7 or greater and the device must return
values defined as valid in the standard.  Only then are the
characteristics reported to SCSI via the VPD B1 page.

This seems like a reasonable compromise to me considering that we have
been shipping several kernel releases that key off the rotation rate bit
without any version checking whatsoever.  With no complaints so far.
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

For disks with 4KB sectors, report the correct block size and alignment
when filling out the READ CAPACITY(16) response.

This patch is based upon code from Matthew Wilcox' 4KB ATA tree.  I
fixed the bug I reported a while back caused by ATA and SCSI using
different approaches to describing the alignment.
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

The bit 11 of command description is reserved bit in Freescale
SATA controller and needs to be set to '1'.  This is needed to
make sure the last write from the controller to the buffer
descriptor is seen before an interrupt is raised.
Signed-off-by: Dave Liu <daveliu@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

We we build with dma_addr_t as a 64-bit quantity we get:

drivers/ata/sata_fsl.c: In function 'sata_fsl_fill_sg':
drivers/ata/sata_fsl.c:340: warning: format '%x' expects type 'unsigned int', but argument 4 has type 'dma_addr_t'
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Issuing ATA_CMD_SET_FEATURES (0xef) times out because
pdc20621_interrupt ignores command completion since
ATA_TFLAG_POLLING flag is set.

This has already been fixed for sata_promise:

commit 51b94d2a
Author: Tejun Heo <htejun@gmail.com>
Date:   Fri Jun 8 13:46:55 2007 -0700

    sata_promise: use TF interface for polling NODATA commands

Also, this patch includes Mikael's original patches:

http://marc.info/?l=linux-ide&m=121135828227724&w=2
http://marc.info/?l=linux-ide&m=121144512109826&w=2Signed-off-by: Mikael Pettersson <mikpe@it.uu.se>
Signed-off-by: David Milburn <dmilburn@redhat.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

* 'for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tytso/ext4:
  ext4: Fix race in ext4_inode_info.i_cached_extent
  ext4: Clear the unwritten buffer_head flag after the extent is initialized
  ext4: Use a fake block number for delayed new buffer_head
  ext4: Fix sub-block zeroing for writes into preallocated extents

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound-2.6:
  ASoC: DaVinci EVM board support buildfixes
  ASoC: DaVinci I2S updates
  ASoC: davinci-pcm buildfixes
  ALSA: pcsp: fix printk format warning
  ALSA: riptide: postfix increment and off by one
  pxa2xx-ac97: fix reset gpio mode setting
  ASoC: soc-core: fix crash when removing not instantiated card

* 'for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jwessel/linux-2.6-kgdb:
  kgdb: gdb documentation fix
  kgdb,i386: use address that SP register points to in the exception frame
  sysrq, intel_fb: fix sysrq g collision

* 'for-linus' of git://git.kernel.dk/linux-2.6-block:
  Revert "mm: add /proc controls for pdflush threads"
  viocd: needs to depend on BLOCK
  block: fix the bio_vec array index out-of-bounds test

* 'merge' of git://git.kernel.org/pub/scm/linux/kernel/git/benh/powerpc:
  powerpc: Fix PCI ROM access
  powerpc/pseries: Really fix the oprofile CPU type on pseries
  serial/nwpserial: Fix wrong register read address and add interrupt acknowledge.
  powerpc/cell: Make ptcal more reliable
  powerpc: Allow mem=x cmdline to work with 4G+
  powerpc/mpic: Fix incorrect allocation of interrupt rev-map
  powerpc: Fix oprofile sampling of marked events on POWER7
  powerpc/iseries: Fix pci breakage due to bad dma_data initialization
  powerpc: Fix mktree build error on Mac OS X host
  powerpc/virtex: Fix duplicate level irq events.
  powerpc/virtex: Add uImage to the default images list
  powerpc/boot: add simpleImage.* to clean-files list
  powerpc/8xx: Update defconfigs
  powerpc/embedded6xx: Update defconfigs
  powerpc/86xx: Update defconfigs
  powerpc/85xx: Update defconfigs
  powerpc/83xx: Update defconfigs
  powerpc/fsl_soc: Remove mpc83xx_wdt_init, again