Signed-off-by: Vinod Koul <vinod.koul@intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

TLV size calculation was incorrectly calculated. Fix this according to
include/sound/tlv.h
Signed-off-by: Liam Girdwood <liam.r.girdwood@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Merge remote-tracking branches 'asoc/topic/wm8994', 'asoc/topic/wm8996' and 'asoc/topic/zx' into asoc-next

Merge remote-tracking branches 'asoc/topic/topology', 'asoc/topic/twl6040', 'asoc/topic/wm5100', 'asoc/topic/wm8741' and 'asoc/topic/wm8960' into asoc-next

Merge remote-tracking branches 'asoc/topic/sta350', 'asoc/topic/tas2552', 'asoc/topic/tas3a227e' and 'asoc/topic/tas571x' into asoc-next

Merge remote-tracking branches 'asoc/topic/simple', 'asoc/topic/ssm2518', 'asoc/topic/ssm2602', 'asoc/topic/ssm4567' and 'asoc/topic/sta32x' into asoc-next

Merge remote-tracking branches 'asoc/topic/rt5677', 'asoc/topic/samsung' and 'asoc/topic/sgtl5000' into asoc-next

Merge remote-tracking branches 'asoc/topic/max98095', 'asoc/topic/omap', 'asoc/topic/pxa', 'asoc/topic/qcom' and 'asoc/topic/rcar' into asoc-next

Merge remote-tracking branches 'asoc/topic/gpiod-flags', 'asoc/topic/gtm601', 'asoc/topic/intel', 'asoc/topic/lm3857' and 'asoc/topic/max98090' into asoc-next

Merge remote-tracking branches 'asoc/topic/fsl', 'asoc/topic/fsl-sai', 'asoc/topic/fsl-spdif', 'asoc/topic/fsl-ssi' and 'asoc/topic/gpio-jack' into asoc-next

Merge remote-tracking branches 'asoc/topic/au1x', 'asoc/topic/bt-sco', 'asoc/topic/cs35l32' and 'asoc/topic/da7210' into asoc-next

Merge remote-tracking branches 'asoc/topic/adau1977', 'asoc/topic/adav80x', 'asoc/topic/arizona' and 'asoc/topic/atmel' into asoc-next

Merge remote-tracking branches 'asoc/topic/ac97', 'asoc/topic/ad1836', 'asoc/topic/ada1977', 'asoc/topic/adau1701' and 'asoc/topic/adau17x1' into asoc-next

Merge remote-tracking branches 'asoc/fix/wm8737', 'asoc/fix/wm8903' and 'asoc/fix/wm8955' into asoc-linus

Merge remote-tracking branches 'asoc/fix/arizona', 'asoc/fix/fmtbit', 'asoc/fix/max98925', 'asoc/fix/rcar' and 'asoc/fix/ux500' into asoc-linus

Instead of hard wiring the WCLK frequency at probe time do it runtime.
The hard wired 88_96KHz was not even setting the correct bits since it was
defined as (1 << 6) which will  change the I2S_OUT_SEL bit and will leave
the amplifier configured for 8KHz.
At the same time clean up and fix the CFG3 register bits.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Configure the word length based on the params_width of the stream.
Also configure the clock per frame value which is used when tas2552 is bus
master.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Certain sequence need to be followed in order to have smooth power up and
power down performance.
Execute this sequence via DAPM_POST widget.
Remove patching the RESERVED_0D register at probe time since it has to be
handled every time when we stop or start the amplifier.
In order to be able to execute the sequence at the correct time, the driver
need to request to ignore the pmdown time.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

The last parameter for DECLARE_TLV_DB_SCALE() is to tell if the gain will
be muted or not when it is set to raw 0. IN this case it is not muted.
The PGA_GAIN is in 0-4 bits in the register. Fix the offset in the
SOC_SINGLE_TLV() for this.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

The strings should be: 'static const char * const tas2552_input_texts[]'
SOC_DAPM_ENUM should have "Route" in place of xname and no need to have it
as an array.
Also align the parameters.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

TDM support is achieved using DSP transfer mode and setting a programmable
offset which specifies where data begins with respect to the frame sync.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Use names from the datasheet for the definitions.
Correct the data format definitions since they were not correct.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

DSP_A mode require one bit delay from the FS, DSP_B is without data delay.
When checking the requested format, also match the bit and fs inversion
flag along with the format since it is not possible to change inversion.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Instead of hard wiring the PLL_CLKIN and PDM_CLK to be sourced from BCLK add
proper clock configuration via the set_dai_sysclk callback.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Binding header file for clock input selection and configuration.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Prevents frequent panic on boot, if the irq handler rt5645_irq
gets called before the workqueue rt5645_jack_detect_work is
initialized.
Signed-off-by: Nicolas Boichat <drinkcat@chromium.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
Cc: stable@vger.kernel.org

sound/soc/zte/zx296702-i2s.c:428:3-8: No need to set .owner here. The core will do it.

 Remove .owner field if calls are used which set it automatically

Generated by: scripts/coccinelle/api/platform_no_drv_owner.cocci
Signed-off-by: Fengguang Wu <fengguang.wu@intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

MCLK is one of the possible source for the pll_clkin frequency. Make this
clear by renaming the variable.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

The function name and parameters of:
tas2552_sw_shutdown(struct tas2552_data *tas_data, int sw_shutdown)

implies that if sw_shutdown is 1 we should be entering to the software
shutdown mode.

The code can be simplified as well within the function.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Initialize the cfg1_reg to 0 and set the mute bit only when it is needed.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

Remove the _MASK postfix of the bit definitions, collect the CFG1 bit
definition in one place and correct the bit shifts at the same time.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

The PDM clock can be selected via bit0-1.
PDM_DATA_ES bit is at bit2.

The code were trying to select BCLK as PDM reference clock but instead
it was selecting PLL and set the DATA_ES bit to 1.
Selecting the PLL output as reference clock as default does make sense,
but the driver should not change the PDM data edge.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

SOC_DAPM_SINGLE("Playback AMP", ..) should not be under kcontrols. It
causes kernel crash (NULL pointer) when the mixers are listed.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Cc: stable@vger.kernel.org

If the card is not part of any card the tas_data->codec is NULL since it is
set only during snd_soc_codec_driver.probe, which is not yet called.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Cc: stable@vger.kernel.org