- 06 Jan, 2015 24 commits
-
-
Marc Yang authored
Workqueue needs to be flushed early when removing card, otherwise soft lockup issue may happen because main_process is triggered by interrupt while card is being removed. Signed-off-by:
Marc Yang <yangyang@marvell.com> Signed-off-by:
Cathy Luo <cluo@marvell.com> Signed-off-by:
Amitkumar Karwar <akarwar@marvell.com> Signed-off-by:
Kalle Valo <kvalo@codeaurora.org>
-
Amitkumar Karwar authored
This flag is never set but checked at two places. We will get rid of this code. Signed-off-by:
-
Avinash Patil authored
This patch adds support to get number of BA streams supported information from FW. Some newer chips(e.g. 8897 series) support 4 BA streams for TX; so driver should not disallow BA stream setup just after 2 streams have been established. Signed-off-by:
Avinash Patil <patila@marvell.com> Signed-off-by:
-
Xinming Hu authored
This patch adds support for DMA alignment of 64 bytes for TX packets. Signed-off-by:
Xinming Hu <huxm@marvell.com> Signed-off-by:
-
Xinming Hu authored
This patch fixes memory corruption reported by community developer. "Memory corruption occurs in mwifiex_ret_802_11_key_material_v1() when a short command response is received without a key length causing non initialised memory to be interpreted as the key length resulting in a memcpy() overwriting the part of the driver's private data structure beyond the key area." For v1 key material API firmwares, there is no need to send command to delete WEP key. WEP encryption/decryption is controlled by mac_control command. This patch avoids sending key material command in del_key case. Reported-by:
Martin Fuzzey <mfuzzey@parkeon.com> Signed-off-by:
-
Avinash Patil authored
Enable the endian checks by default. Signed-off-by:
-
Arend van Spriel authored
This patch adds support for the bcm43340 and bcm43341 wireless chipsets. These two chipsets are identical from wireless parts perspective. As such they use the same firmware image. Cc: Samuel Ortiz <sameo@linux.intel.com> Cc: Rob Herring <rob.herring@linaro.org> Signed-off-by:
John Stultz <john.stultz@linaro.org> [arend@broadcom.com: squash to single commit, remove 43341 chipid] Reviewed-by:
Pieter-Paul Giesberts <pieterpg@broadcom.com> Reviewed-by:
Hante Meuleman <meuleman@broadcom.com> Signed-off-by:
Arend van Spriel <arend@broadcom.com> Signed-off-by:
-
Avinash Patil authored
This patch adds module parameter for auto deepsleep configuration. By default, module_param is 0 and auto deep sleep is enabled. If mwifiex driver is loaded with disable_auto_ds=1, deep sleep configuration would not be downloaded to FW and FW would not enter deepsleep upon initializing. Signed-off-by:
-
Xinming Hu authored
This patch saves sdio registers value before firmware dump, this can be used to find out reason for FW dump. Signed-off-by:
-
Xinming Hu authored
This patch adds support to dump driver information to a file when firmware dump happens. This information can be used to root casue FW crash. Signed-off-by:
-
Xinming Hu authored
mwifiex_debug_info also need be save to file when firmware dump happens. Move its dump implementation function to commmon utilility file, thus it can be reused in firmware dump function. Signed-off-by:
-
Xinming Hu authored
Move mwifiex_pm_wakeup_card_complete handler to source file. Signed-off-by:
-
Xinming Hu authored
This patch add a new debugfs item histogram used for reporting rx data packet statitics(rx rate, snr, noise floor, signal strenth) to userspace. Signed-off-by:
-
Xinming Hu authored
This patch add receive beacon count and miss beacon count statistics in debugfs getlog item. Signed-off-by:
-
Xinming Hu authored
This patch add provision to show TDLS peer table in debugfs file. Signed-off-by:
-
Wolfram Sang authored
This platform_driver does not need to set an owner, it will be populated by the driver core. Signed-off-by:
Wolfram Sang <wsa@the-dreams.de> Signed-off-by:
-
Arend van Spriel authored
When the driver gets beacon info containing a country IE from user-space upon .start_ap() callback, it will enable regulatory 802.11d support. Reviewed-by:
-
Hante Meuleman authored
Use cfg80211 change_station to signal the completion of 802.1x to firmware. This allows FW to take appropriate actions. Reviewed-by:
-
Arend van Spriel authored
When user-space uses a valid ISO-3166-1 country code for its regulatory domain selection, the driver will try to configure the firmware to use the same. Reviewed-by:
-
Hante Meuleman authored
When there is no room in the ring for rxbufpost an error is logged, however this happens quite frequently and can be considered normal and is certainly recoverable. This patch changes the erorr into a normal msgbuf log. Reviewed-by:
-
Hante Meuleman authored
When a device is configured for AP mode and it is configured for WEP then the keys are plumbed first, followed by AP configuration. During configuration a down command is given to the firmware which will clear the configured keys. This patch reprograms the WEP keys after AP has been brought up. Reviewed-by:
-
Arend van Spriel authored
The source file chip.c contained some duplicate defines and some unused ones. Removing them. Reviewed-by:
-
Hante Meuleman authored
The physical addresses being used by pcie and msgbuf were using a cast to long, which incorrectly caused it to limit the address to 32bit. Now explicit u64 is used where needed. Reviewed-by:
-
Kalle Valo authored
Merge tag 'iwlwifi-next-for-kalle-2014-12-30' of https://git.kernel.org/pub/scm/linux/kernel/git/iwlwifi/iwlwifi-next * more work on d0i3 power state * enhancements to the firmware debugging infrastructure * support for 2 concurrent channel contexts * fixes / cleanups in the rate control * general cleanups
-
- 02 Jan, 2015 16 commits
-
-
David S. Miller authored
Richard Cochran says: ==================== Fixing the "Time Counter fixes and improvements" For this series I had only tested the build with ARCH=x86 and arm, but others like sparc64, microblaze, powerpc, and s390 will fail because they somehow don't indirectly include clocksource.h for the drivers in question. This series fixes the build issues reported by: kbuild test robot <fengguang.wu@intel.com> ==================== Signed-off-by:David S. Miller <davem@davemloft.net>
-
Richard Cochran authored
The timecounter/cyclecounter code has moved, so users need the new include. Signed-off-by:
Richard Cochran <richardcochran@gmail.com> Signed-off-by:
-
Richard Cochran authored
This driver uses the function, clocksource_khz2mult, and so it really must include clocksource.h. Signed-off-by:
-
Richard Cochran authored
Signed-off-by:
-
Richard Cochran authored
Signed-off-by:
-
Richard Cochran authored
Signed-off-by:
-
Richard Cochran authored
Signed-off-by:
-
Richard Cochran authored
There is no need for users of the timecounter/cyclecounter code to include clocksource.h just for a single macro. Signed-off-by:
-
Pravin B Shelar authored
OVS development is moved to netdev mailing list. Update tree and list in MAINTAINERS file. Signed-off-by:
Pravin B Shelar <pshelar@nicira.com> Signed-off-by:
-
David S. Miller authored
Merge tag 'wireless-drivers-next-for-davem-2015-01-02' of git://git.kernel.org/pub/scm/linux/kernel/git/kvalo/wireless-drivers-next Changes: * ath9k: enable Transmit Power Control (TPC) for ar9003 chips * rtlwifi: cleanup and updates from the vendor driver * rsi: fix memory leak related to firmware image * ath: parameter fix for FCC DFS pattern Signed-off-by:
-
Rickard Strandqvist authored
Removes some functions that are not used anywhere: enic_dev_enable2_done() enic_dev_enable2() enic_dev_deinit_done() enic_dev_init_prov2() enic_vnic_dev_deinit() This was partially found by using a static code analysis program called cppcheck. Signed-off-by:
Rickard Strandqvist <rickard_strandqvist@spectrumdigital.se> Signed-off-by:
-
Rickard Strandqvist authored
Removes some functions that are not used anywhere: Read_hfc32() Write_hfc32() Write_hfc16() This was partially found by using a static code analysis program called cppcheck. Signed-off-by:
-
Rickard Strandqvist authored
Remove the function smt_ifconfig() that is not used anywhere. This was partially found by using a static code analysis program called cppcheck. Signed-off-by:
-
Rickard Strandqvist authored
Removes some functions that are not used anywhere: dbgi_rd_rsp3() dbgi_wr_addr3() This was partially found by using a static code analysis program called cppcheck. Signed-off-by:
-
Florian Westphal authored
Not needed, only four cases: - kfree_skb (or one of its aliases). Don't need to zero, memory will be freed. - kfree_skb_partial and head was stolen: memory will be freed. - skb_morph: The skb header fields (including tc ones) will be copied over from the 'to-be-morphed' skb right after skb_release_head_state returns. - skb_segment: Same as before, all the skb header fields are copied over from the original skb right away. Signed-off-by:
Florian Westphal <fw@strlen.de> Signed-off-by:
-
David S. Miller authored
Merge branch 'for-upstream' of git://git.kernel.org/pub/scm/linux/kernel/git/bluetooth/bluetooth-next Johan Hedberg say: ==================== pull request: bluetooth-next 2014-12-31 Here's the first batch of bluetooth patches for 3.20. - Cleanups & fixes to ieee802154 drivers - Fix synchronization of mgmt commands with respective HCI commands - Add self-tests for LE pairing crypto functionality - Remove 'BlueFritz!' specific handling from core using a new quirk flag - Public address configuration support for ath3012 - Refactor debugfs support into a dedicated file - Initial support for LE Data Length Extension feature from Bluetooth 4.2 Please let me know if there are any issues pulling. Thanks. ==================== Signed-off-by:
-
