1/ Personalities only know about raid_disks devices.
   Some might be not in_sync and so cannot be read from,
   but must be written to.
	- change MD_SB_DISKS to ->raid_disks
	- add tests for .write_only

2/ rdev->raid_disk is now -1 for spares.  desc_nr is maintained
   by analyse_sbs and sync_sbs.

3/ spare_inactive method is subsumed into hot_remove_disk
   spare_writable is subsumed into hot_add_disk.
   hot_add_disk decides which slot a new device will hold.

4/ spare_active now finds all non-in_sync devices and marks them
   in_sync.

5/ faulty devices are removed by the md recovery thread as soon
   as they are idle.  Any spares that are available are then added.

This is equivalent to ->rdev != NULL, so it isn't needed.

This will allow us to know, in the event of a device failure, when the
device is completely unused and so can be disconnected from the
array.  Currently this isn't a problem as drives aren't normally disconnect
until after a repacement has been rebuilt, which is a LONG TIME, but that
will change shortly...

We always increment the count under a spinlock after checking that
it hasn't been disconnected already (rdev!= NULL).
We disconnect under the same spinlock after checking that the
count is zero.

This simplifies the error handlers slighty, but allows for even more
simplification later.

Holding the rdev instead of the bdev does cause an extra
de-reference, but it is conceptually cleaner and will allow
lots more tidying up.

->major_name is "const char *" so we need to sprintf into the kmalloced
space *before* assigning that space to ->major_name.

1/ Raid0 should not be accessing rdev->sb.

2/ Don't unlock rdev (which releases bdev) until after last use of bdev

3/ Fix typo in a printk ( = should be -)

4/ i should be dd_idx in compute_block

bufsiz is re-evaluated on recv if SK_CHNGBUF is set,
but recv will never be reached if the buffers are too small.
So we have to set to to something vaguely reasonable
at init time.

1/ connect requests would be get lost...
  As the comment at the top of svcsock.c says when discussing
  SK_CONN:
 *		after a set, svc_sock_enqueue must be called.

  We didn't and so lost conneciton requests.

2/ set the max accept backlog to a more reasonable number to cope
   with bursts of lots of connection requests.

__page_cache_release() needs to check PG_lru inside the lock, because
page reclaim may have taken the page off the LRU while this CPU waits
on the lock.

That's three bugs in a single twenty-line function.  So far.

This fixes some problems in vmalloc.c.  The two first parts of the diff
fix a spinlock being held if an error occurs in map_vm_area, and the
last part fixes the error path of __vmalloc.

but some files still did (and got the wrong results on UP).

Since they didn't actually _use_ the BKL anyway, remove the
include.

since it was generic.

Remove all architecture-specific <asm/smplock.h> files.

 - Use req->rq_received to determine the message length instead of
   assuming that it goes to the end of the page.

 - If the server returned an illegal record so that we cannot make
   progress by retrying the request on a fresh page, truncate the
   entire listing and return a syslog error.

 - Fix the check for whether or not the received message length has
   somehow been truncated: we need to use req->rq_received rather
   than the receive buffer length (req->rq_rlen).

 - Ensure that we set res->eof correctly. In particular, we need to
   clear it if we find ourselves attempting to recover from a
   truncated READ.

 - Don't set PageUptodate() on those pages that are the victim of
   message truncation.

 - cleanup #defines: I do not follow the rationale behind the
   odd line-wrapped defines at the beginning of the file.  If
   we have to use multiple lines, then we might as well do so
   cleanly and according to normal practice...

 - Remove a level of indirection: do not have spin_lock_foo
   use spin_lock - just explicitly call what is needed.

 - we do not need to define the spin_lock functions twice, once
   for CONFIG_PREEMPT and once for !CONFIG_PREEMPT.  Defining
   them once with the preempt macros will optimize away fine.

 - cleanup preempt.h too

 - other misc. cleanup, improved comments, reordering, etc.

This fixes the ptrace wait4() anomaly that can be observed in any
previous Linux kernel i could get my hands at.

If the parent still has other children (that are being traced by
somebody), we wait for them or return immediately without an error in
case of WNOHANG.

Finally, this chunk removes the references to the UFS & ROMFS
entries in struct superblock, leaving just ext3 and hpfs as
the only remaining fs's to be fixed up.

This one from Brian Gerst seperates UFS from
the struct superblock union.

This patch from Christoph Hellwig divorces ROMFS
from the struct superblock union, as has been done
to various other filesystems during 2.5

try_to_unmap() dies if the to-be-unmapped page has a non-NULL ->mapping.

But the preceding logic in shrink_cache() forgot about the
rarely-occurring pages which have buffers and no ->mapping.

I have a test_and_set_bit(PG_chainlock, page->flags) in page reclaim.
Which works fine on SMP.  But on uniprocessor, we made
pte_chain_unlock() a no-op, so all pages end up with PG_chainlock set.
refill_inactive() cannot move any pages onto the inactive list and the
machine dies.

The patch removes the test_and_set_bit optimisation in there and just
uses pte_chain_lock().  If we want that (dubious) optimisation back
then let's do it right and create pte_chain_trylock().

__page_cache_release() needs to recheck the page count inside the LRU
lock, because shrink_cache() may have found the page on the LRU and
incremented its refcount again.

Which is carefully documented over __pagevec_release().  Duh.

Here's a patch from Andrea's tree that uses IRQ_BALANCE_INTERVAL to
define how often interrupts are balanced, staying independent from HZ.

  It also makes sure that there _is_ a change to the configuration
before it actually writes it.  It reminds me of the mod_timer
optimization.

the attached patch updates a number of items:

 - adds cleanups suggested by Christoph Hellwig: needed unlikely()
   statements, a superfluous #define and line length problems.

 - splits up the global ptrace list into per-task ptrace lists. This was
   pretty straightforward, and this makes the worst-case exit() latency
   O(nr_children).

the per-task ptrace lists unearthed a bug that the previous code did not
take care of: tasks on the ptrace list have to be correctly reparented as
well. This patch passed my stresstests as well.

oh, setup.S. nasty indeed, bogus GDT limit.

This updates the CLONE_CLEARTID case to use futexes to make it easier
to wait for a thread exit.

glibc/pthreads had been updated to use the TID-futex, this removes an
extra system-call and it also simplifies the pthread_join() code.  The
pthreads testcode works just fine with the new kernel and does not work
with a kernel that does not do the futex wakeup, so it's working fine.

and the call trace instead.

This is the second part of "broken cfb* support in the 2.5.31-bk".  I
needed fbcon-cfb2 on one of my systems, and so I went through all
fbcon-* drivers and fixed them.

line_length, type, type_aux and visual were moved from display to
fb_info in last James Simmon's fbdev update.  Unfortunately lowlevel
support modules were not updated.

into home.transmeta.com:/home/torvalds/v2.5/linux

I want to find a way to get all those PageReserved tests out of
there, because they are very expensive.  But now is not the
time.

Make sure that the VC tty pointer is cleared when the tty is free'd.

into home.transmeta.com:/home/torvalds/v2.5/linux

into samba.org:/scratch/anton/linux-2.5_ppc64drivers

into home.transmeta.com:/home/torvalds/v2.5/linux