- 31 Jan, 2008 40 commits
-
-
Pavel Hofman authored
adding i2c busy wait before sending device address to prevent reading bogus data. Signed-off-by:
Pavel Hofman <dustin@seznam.cz> Signed-off-by:
Takashi Iwai <tiwai@suse.de> Signed-off-by:
Jaroslav Kysela <perex@perex.cz>
-
Rene Herman authored
This removes the pnp_resource_change use from the ALSA ISAPnP drivers. In 2.4 these were useful in providing an easy path to setting the resources, but in 2.6 they retain function as a layering violation only. This makes for a nice cleanup (-550 lines) of ALSA but moreover, ALSA is the only remaining user of pnp_init_resource_table(), pnp_resource_change() and pnp_manual_config_dev() (and, in fact, of 'struct pnp_resource_table') in the tree outide of drivers/pnp itself meaning it makes for more cleanup potential inside the PnP layer. Thomas Renninger acked their removal from that side, you did from the ALSA side (CC list just copied from that thread). Against current alsa-kernel HG. Many more potential cleanups in there, but this _only_ removes the pnp_resource_change code. Compile tested against current alsa-kernel HG and compile- and use-tested against 2.6.23.x (few offsets). Cc: Thomas Renninger <trenn@suse.de> Signed-off-by:
Rene Herman <rene.herman@gmail.com> Signed-off-by:
-
Julia Lawall authored
There should be a pci_dev_put when breaking out of a loop that iterates over calls to pci_get_device and similar functions. In this case, the return under the initial if needs a pci_dev_put in the same way that the return under the subsequent for loop has a pci_dev_put. This was fixed using the following semantic patch. // <smpl> @@ type T; identifier d; expression e; @@ T *d; ... while ((d = \(pci_get_device\|pci_get_device_reverse\|pci_get_subsys\|pci_get_class\)(..., d)) != NULL) {... when != pci_dev_put(d) when != e = d ( return d; | + pci_dev_put(d); ? return ...; ) ...} // </smpl> Signed-off-by:Julia Lawall <julia@diku.dk> Signed-off-by:
Andrew Morton <akpm@linux-foundation.org> Signed-off-by:
-
Takashi Iwai authored
The 'Word Clock Status' control on Delta 1010LT checks the CS8427 error register too strictly and almost always returns 1 (unlocked). It should check only the lock status bit. Signed-off-by:
-
Daniel Mack authored
Added support for Native Instrument's Kore controller 2. This device has no audio but MIDI, input devices and ALSA controllers only. Signed-off-by:
Daniel Mack <daniel@caiaq.de> Signed-off-by:
-
Ville Syrjala authored
Disable the simultaneous load feature for the line in and headphone out volume registers. This allows left and right volume levels to be controlled separately. Signed-off-by:
Ville Syrjala <syrjala@sci.fi> Signed-off-by:
-
Takashi Iwai authored
Added the missing call of snd_card_set_dev() in drivers/* Signed-off-by:
-
Joe Perches authored
Signed-off-by:
Joe Perches <joe@perches.com> Signed-off-by:
-
Takashi Iwai authored
Added the missing snd_card_set_dev() call. This will fix the incomplete sysfs entry for this card. Signed-off-by:
-
Takashi Iwai authored
Set a proper error code in the error path of i2sbus_attach_codec(). Signed-off-by:
-
Heikki Lindholm authored
The aoa driver is not specifying constraints on number of periods, and, it seems, it might end with a non-integer number, which it cannot deal with. Fix by adding a proper constraint. Signed-off-by:
Heikki Lindholm <holindho@cs.helsinki.fi> Signed-off-by:
-
Takashi Iwai authored
When MMAP time-stamp mode is given, it's supposed to update the time-stamp only at period boundary. However, it currently updates at each status call so this is just useless. The patch fixes this misbehavior. Also it fixes the wrong check of tstamp_mode (don't use bit-and for enum). Signed-off-by:
-
Takashi Iwai authored
Remove ifdef and fix Makefile for conditional builds. Signed-off-by:
-
Daniel Mack authored
- added support for all input controllers on Native Instrument's 'Kore controller'. - added ALSA controls to switch LEDs on 'RigKontrol 2', 'RigKontrol3', 'Audio Kontrol 1' and 'Kore controller'. - added ALSA controls to switch input mode, software lock and ground lift features on 'Audio 8 DJ'. Signed-off-by:
-
Dmitry Torokhov authored
Signed-off-by:
Dmitry Torokhov <dtor@mail.ru> Signed-off-by:
-
Dmitry Torokhov authored
- link input device with its parent so that it placed in proper spot in sysfs hierarchy - drivers that allow changing their keymaps should use private copy of the keymap so that one instance of a device does not affect another instance - it is preferred for drivers to properly set up input_dev->phys to help userspace locate devices - drivers should use usb_to_input_id(), or perform endianess conversion, themselves, otherwise ID is not correct on big-endian boxes - whitespace and formatting cleanup Acked-by:
-
Takashi Iwai authored
Fix indent of caiaq in Kconfig to the same level as others. Just a tidy up. Signed-off-by:
-
Takashi Iwai authored
The last patch for value range checks included a broken merge result. Now fixed properly. Signed-off-by:
-
Kamalesh Babulal authored
The kernel build fails, with following error CC sound/ppc/tumbler.o sound/ppc/tumbler.c: In function ‘snapper_get_capture_source’: sound/ppc/tumbler.c:812: error: ‘union <anonymous>’ has no member named ‘value’ sound/ppc/tumbler.c: In function ‘snapper_put_capture_source’: sound/ppc/tumbler.c:824: error: ‘union <anonymous>’ has no member named ‘enuemerated’ make[2]: *** [sound/ppc/tumbler.o] Error 1 make[1]: *** [sound/ppc] Error 2 make: *** [sound] Error 2 Signed-off-by:
Kamalesh Babulal <kamalesh@linx.vnet.ibm.com> Signed-off-by:
-
Takashi Iwai authored
Volume knob controls with STAC codecs seem to cause problems with some devices. Volumes change very slowly or silent suddenly. It's likely due to conflict between the software and the hardware volume knob setup. Since we'll have a virtual master control in future, it's safer to remove this control completely right now. Signed-off-by:
-
Takashi Iwai authored
Show more attributs of volume-knob widgets. Also don't put empty lines when no connection list is found. Signed-off-by:
-
Ingo Molnar authored
not sleeping for every codec read/write but doing a short udelay and a conditional reschedule has cut suspend+resume latency by about 1 second on my T60. Signed-off-by:
Ingo Molnar <mingo@elte.hu> Signed-off-by:
-
Wolke Liu authored
This patch is to add R6xx HDMI audio support. Meanwhile, the device ID in the previous patch is changed. I have checked the patch from Herton Ronaldo Krzesinski, it's right as our spec said. :) Signed-off-by:
Wolke Liu <Wolke.Liu@amd.com> Signed-off-by:
Andrea Zhang <Andrea.Zhang@amd.com> Signed-off-by:
-
Takashi Iwai authored
Use snd_ctl_boolean_mono_info callback to simplify. Signed-off-by:
-
Takashi Iwai authored
Check the value ranges in ctl put callbacks properly (in the rest drivers). Signed-off-by:
-
Takashi Iwai authored
Check the value ranges in ctl put callbacks properly in aoa drivers. Signed-off-by:
-
Takashi Iwai authored
Check the value ranges in ctl put callbacks properly in ak4xxx-adda driver. Signed-off-by:
-
Takashi Iwai authored
Check the value ranges in ctl put callbacks properly in snd-powermac driver. Signed-off-by:
-
Takashi Iwai authored
Check the value ranges in ctl put callbacks in vxpocket driver. Signed-off-by:
-
Takashi Iwai authored
Clean up ctl callbacks of SE-200PCI driver. Also make sure to check the value ranges. Signed-off-by:
-
Takashi Iwai authored
Check the value ranges in ctl put callbacks properly in the rest of PCI drivers. Signed-off-by:
-
Takashi Iwai authored
Check the value ranges in ctl put callbacks properly. Also fixed some coding style issues around that. Signed-off-by:
-
Takashi Iwai authored
Check the value ranges in ctl put callbacks properly. Also fixed the wrong access type to enum elements in aureon.c. Signed-off-by:
-
Takashi Iwai authored
Check the value ranges in ctl put callbacks properly so that invalid values won't be stored or written to registers. Signed-off-by:
-
Takashi Iwai authored
Check value ranges in ctl callbacks properly. This fixes the unexpected crash due to wrong value assignment. Also, remove invalid comments in the last patch. Signed-off-by:
-
Vladimir Barinov authored
This patch adds ALSA SoC support for TI TLV320AIC3X audio codecs. The features that are supported: o Capture/Playback/Bypass. o 16/20/24/32 bit audio. o 8k - 96k sample rates. o codec master only mode o DAPM. Signed-off-by:Vladimir Barinov <vbarinov@ru.mvista.com> Signed-off-by:
-
Julia Lawall authored
Continue is not needed at the bottom of a loop. The semantic patch implementing this change is as follows: @@ @@ for (...;...;...) { ... if (...) { ... - continue; } } Signed-off-by: -
Takashi Iwai authored
Added the missing model string for the new support of HP TC T5735. Signed-off-by:
-
Kailang Yang authored
Added the support of HP Thin Client T5735 [0x103c 0x302f] with ALC262 codec. Signed-off-by:
Kailang Yang <kailang@realtek.com.tw> Signed-off-by:
-
James Courtier-Dutton authored
Signed-off-by:
James Courtier-Dutton <James@superbug.co.uk> Signed-off-by:
-
