- 19 Oct, 2004 40 commits
-
-
Maximilian Attems authored
Signed-off-by:
Nishanth Aravamudan <nacc@us.ibm.com> Signed-off-by:
Maximilian Attems <janitor@sternwelten.at> Signed-off-by:
Andrew Morton <akpm@osdl.org> Signed-off-by:
Linus Torvalds <torvalds@osdl.org>
-
Maximilian Attems authored
Signed-off-by:
-
Maximilian Attems authored
Use msleep_interruptible() instead of schedule_timeout() under drivers/message. Signed-off-by:
-
Maximilian Attems authored
Signed-off-by:
-
Maximilian Attems authored
Removes definition of MS_TO_HZ() in favor of msecs_to_jiffies(). Signed-off-by:
-
Maximilian Attems authored
Replace MS_TO_HZ() with msecs_to_jiffies(). Signed-off-by:
-
Maximilian Attems authored
Kill KERNEL_VERSION duplicate. Funny that it insn't even used in here Signed-off-by:
Domen Puncer <domen@coderock.org> Signed-off-by:
-
Maximilian Attems authored
caught by Domen Puncer <domen@coderock.org> Signed-off-by:
-
Maximilian Attems authored
Signed-off-by:
-
Maximilian Attems authored
Signed-off-by:
-
Maximilian Attems authored
Signed-off-by:
-
Maximilian Attems authored
Replace lots of open-coded sleeps with msleep_interruptible() under drivers/char. Signed-off-by:
Rogier Wolff <R.E.Wolff@BitWizard.nl> Signed-off-by:
Christoph Lameter <christoph@lameter.com> Signed-off-by:
-
Maximilian Attems authored
Signed-off-by:
-
Maximilian Attems authored
Add set_current_state() before schedule_timeout() so a delay is achieved. Without the addition, schedule_timeout() returns immediately. Signed-off-by:
-
Maximilian Attems authored
Signed-off-by:
-
Maximilian Attems authored
Signed-off-by:
-
Maximilian Attems authored
Use msleep()/msleep_interruptible() [as appropriate] instead of schedule_timeout() to guarantee the task delays as expected. Signed-off-by:
-
Maximilian Attems authored
s/for/list_for_each/ Signed-off-by:
-
Maximilian Attems authored
Patches to remove some old ifdefs. remove most of the #include <linux/version.h> kill compat cruft like #define ahd_pci_set_dma_mask pci_set_dma_mask Signed-off-by:
-
Maximilian Attems authored
Patches to remove some old ifdefs. remove most of the #include <linux/version.h> kill compat cruft like #define ahd_pci_set_dma_mask pci_set_dma_mask Signed-off-by:
-
Maximilian Attems authored
remove unused #include <linux/version.h> Old ifdefs were removed that used it's definition. Signed-off-by:
-
Markus Lidel authored
- Single-bit bitfields should be unsigned. Quell sparse warnings for these. (from Randy Dunlap) Signed-off-by:
Randy Dunlap <rddunlap@osdl.org> Signed-off-by:
Markus Lidel <Markus.Lidel@shadowconnect.com> Signed-off-by:
-
Markus Lidel authored
- added new function i2o_msg_in_to_virt and i2o_msg_out_to_virt, to turn an I2O message to a virtual address (original from Alan Cox) - replaced readl with le32_to_cpu where it is not necessary (original from Alan Cox) Signed-off-by:
-
Markus Lidel authored
- added support for Promise I2O controllers, which need a different initialization sequence (original from Alan Cox) Signed-off-by:
-
Markus Lidel authored
- added KERN_* to printk where it was missing (original from Alan Cox) - removed unused code which was commented out already (original from Alan Cox) - make error messages more sane in i2o_block (original from Alan Cox) Signed-off-by:
-
William Lee Irwin III authored
The zaphod scheduler likes to call scheduler_tick() before time_init(). sparc32 oopses. Perhaps a scheduler bug, but this robustifies things. Signed-off-by:
-
William Lee Irwin III authored
I've been informed that /proc/profile livelocks some systems in the timer interrupt, usually at boot. The following patch attempts to amortize the atomic operations done on the profile buffer to address this stability concern. This patch has nothing to do with performance; kernels using periodic timer interrupts are under realtime constraints to complete whatever work they perform within timer interrupts before the next timer interrupt arrives lest they livelock, performing no work whatsoever apart from servicing timer interrupts. The latency of the cacheline bounce for prof_buffer contributes to the time spent in the timer interrupt, hence it must be amortized when remote access latencies or deviations from fair exclusive cacheline acquisition may cause cacheline bounces to take longer than the interval between timer ticks. What this patch does is to create a pair of per-cpu open-addressed hashtables indexed by profile buffer slot holding values representing the number of pending profile buffer hits for the profile buffer slot. When this hashtable overflows, one iterates over the hashtable accounting each of the pairs of profile buffer slots and hit counts to the global profile buffer. Zero is a legitimate profile buffer slot, so zero hit counts represent unused hashtable entries. The hashtable is furthermore protected from flush IPI's by interrupt disablement. In order to flush the pending profile hits for read_profile(), this patch flips betweeen the pairs of per-cpu profile buffer by signalling all cpus to flip via IPI at the time of read_profile(), followed by doing all the work to flush the profile hits from the older per-cpu buffers in the context of the caller of read_profile(), with exclusion provided by a semaphore ensuring that only one caller of profile_flip_buffers() may execute at a time, and using interrupt disablement to prevent buffer flip IPI's from altering the hashtables or flip state while an update is in progress. The flip state is per-cpu so that remote cpus need only disable interrupts locally for synchronization, which is both simple and busywait-free for remote cpus. The flip states all change in tandem when some cpu requests the hashtables be flipped, and the requester waits for the completion of smp_call_function() for notification that all cpus have finished flipping between their hashtables. The IPI handler merely toggles the flip state (which is an array index) between 0 and 1. This is expected to be a much stronger amortization than merely reducing the frequency of profile buffer access by a factor of the size of the hashtable because numerous hits may be held for each of its entries. This reduces what was before the patch a number of atomic increments equal to what after the patch becomes the sum of the hits held for each entry in the hashtable, to a number of atomic_add()'s equal to the number of entries in the per_cpu hashtable. This is nondeterministic, but as the profile hits tend to be concentrated in a very small number of profile buffer slots during any given timing interval, is likely to represent a very large number of atomic increments. This amortization of atomic increments does not depend on the hash function, only the sharp peakedness of the distribution of profile buffer hits. This algorithm has two advantages over full-size per-cpu profile buffers. The first is that the space footprint is much smaller. Per-cpu profile buffers would increase the space requirements by a factor of num_online_cpus(), where this algorithm only requires one page per cpu. The second is that reading the profile state is much faster, because the state that must be traversed is exactly the above space consumers, and the relative reduction in size concomitantly reduces the time required for a read operation. I also took the liberty of adding some commentary to the comments at the beginning of the file reflecting the major work done on profile.c in recent months and describing what the file implements. The reporters of this issue have verified that this resolves their timer interrupt livelock on 512x Altixen. In my own testing on 4x logical x86-64, this patch saw a rate of about 18 flushes per minute under load, or about one flush every 3 seconds, for about 38.4 atomic accesses to the profile buffer per second per cpu in one of the algorithm's worst cases, about 3.84% of the number of atomic profile buffer accesses per second per cpu as a normal kernel would commit. This represents a twenty-six-fold increase in the scalability on SMP systems with 4KB PAGE_SIZE, i.e. with a 4KB PAGE_SIZE, the number of atomic profile buffer accesses per second per cpu is reduced by a factor of 26, thereby increasing the number of cpus a system must have before it would experience a timer interrupt livelock by a factor of 26, with the proviso that cacheline bounces must take the same amount of time to service. This increase in the scalability of the kernel is expected to be much larger for ia64, which has a large PAGE_SIZE, because the distribution of profile buffer hits is so sharply peaked that doubling the hashtable size will much more than double the amortization factor. In fact, only 19 flushes were observed on a 64x Altix over an approximately 10 minute AIM7 run, and 1 flush on a 512x Altix over the course of an entire AIM7 run, for truly vast effective amortization factors. A prior version of this patch, which did not include the node-local hashtable allocation and bounded collision chains has been successfully tested on 64x and 512x ia64 vs 2.6.9-rc2, 8x ia64 vs. 2.6.9-rc2-mm1, 4x x86-64 vs. 2.6.9-rc2-mm1, and 6x sparc64 vs. 2.6.9-rc2-mm1. This patch minus the hashtable initialization fix has been successfully tested on 2x ppc64, 2x alpha, 8x ia64, 6x sparc64, and 4x x86-64, all vs. 2.6.9-rc2-mm1. This precise version of the patch has been successfully tested on 8x ia32 against 2.6.9-rc2-mm1 and 6x sparc64 vs. both 2.6.9-rc2-mm1 and 2.6.9-rc2-mm2. Signed-off-by:
-
James Morris authored
The patch below allows all types of filesystems to specify the fscreate mount option (which is used to specify the security context of the filesystem itself). This was previously only available for filesystems with full xattr security labeling, but is also potentially required for filesystems with e.g. psuedo xattr labeling such as devpts and tmpfs. An example of use is to specify at mount time the fs security context of a tmpfs filesystem, overriding the default specified in policy for that filesystem. This patch has been in the Fedora kernel for some weeks with no problems. Signed-off-by:
James Morris <jmorris@redhat.com> Signed-off-by:
Stephen Smalley <sds@epoch.ncsc.mil> Signed-off-by:
-
Andreas Gruenbacher authored
* ext[23]_xattr_list(): - Before inserting an xattr block into the cache, make sure that the block is not corrupted. The check got moved after inserting into the cache in the xattr consolidation patches, so corrupted blocks could become visible to cache users. - Take a variable out of the loop that calls the ->list handlers. * A few cosmetic changes. Signed-off-by:Andreas Gruenbacher <agruen@suse.de> Signed-off-by:
-
James Morris authored
This patch adds xattr support to tmpfs, and a security xattr handler. The purpose of this is to allow udev to be mounted on tmpfs, as used currently by Fedora. Original patch from: Luke Kenneth Casson Leighton <lkcl@lkcl.net>. Signed-off-by:
-
James Morris authored
This patch updates the devpts xattr handler code to the generic xattr API, also adds a GPL notice, author and copyright details. Signed-off-by:
-
James Morris authored
This patch converts ext2 xattr and acl code to the new generic xattr API. Signed-off-by:
-
James Morris authored
This patch converts the ext3 xattr and acl code to the generic xattr API. Signed-off-by:
-
James Morris authored
This patch replaces the dentry parameter with an inode in the LSM inode_{set|get|list}security hooks, in keeping with the ext2/ext3 code. dentries are not needed here. Signed-off-by: -
James Morris authored
This patch consolidates common xattr handling logic into the core fs code, with modifications suggested by Christoph Hellwig (hang off superblock, remove locking, use generic code as methods), for use by ext2, ext3 and devpts, as well as upcoming tmpfs xattr code. Signed-off-by:
-
Carlos Eduardo Medaglia Dyonisio authored
This patch fixes troubles when compiling some applications that include <linux/byteorder/little_endian.h>, like xmms. Signed-off-by:
-
Ulrich Drepper authored
The last change to alloc_layer in lib/idr.c unnecessarily complicates the code and depending on the definition of spin_unlock will cause worse code to be generated than necessary. The following patch should improve the situation. Signed-off-by:
Ulrich Drepper <drepper@redhat.com> Signed-off-by:
-
Haroldo Gamal authored
This patch fixes "Samba Bugzilla Bug 999". The last version (2.6.8.1) of smbfs kernel module do not honor uid, gid, file_mode and dir_mode supplied by user during mount. This bug is also logged as "Kernel Bug Tracker Bug 3330". To fully work, some modifications are needed to samba smbmount.c and smbmnt.c files. Those patches are available at Samba and Kernel Bug Tracker pages. After those patches, if the user do not supply any of the parameters above, the uid, gid, file_mode and dir_mode on the server will be used by the client. Signed-off-by:
-
Nick Piggin authored
Hugh and I both thought this would be generally useful. Signed-off-by:
Nick Piggin <nickpiggin@yahoo.com.au> Signed-off-by:
-
Nick Piggin authored
This taint didn't appear to be reported. Signed-off-by:
-
