Skip to content

L
linux
Switch branch/tag
  1. 31 Aug, 2016 1 commit
    • J.D. Schroeder's avatar
      ARM: dts: dra7: Fix clock data for gmac_gmii_ref_clk_div · dbb9c196
      J.D. Schroeder authored 
      This commit fixes the clock data inside the DRA7xx clocks device tree
structure for the gmac_gmii_ref_clk_div clock. This clock is actually
the GMAC_MAIN_CLK and has nothing to do with the register at address
0x4a0093d0. If CLKSEL_REF bit 24 inside of CM_GMAC_GMAC_CLKCTRL, is
set to 1 in order to use the GMAC_RMII_CLK instead of the
GMAC_RMII_HS_CLK, the kernel generates a clock divider warning:
    WARNING: CPU: 0 PID: 0 at drivers/clk/clk-divider.c:129 clk_divider_recalc_rate+0xa8/0xe0()
    gmac_gmii_ref_clk_div: Zero divisor and CLK_DIVIDER_ALLOW_ZERO not set

By properly configuring the gmac_gmii_ref_clk_div (GMAC_MAIN_CLK) to
have the parent of dpll_gmac_m2_ck always divided by 2 the warning is
resolved and the clock tree is fixed up.

Additionally, a new clock called rmii_50mhz_clk_mux is defined that
does utilize CM_GMAC_GMAC_CLKCTRL[24] CLKSEL_REF to configure the
source clock for the RMII_50MHZ_CLK.

Cc: Lokesh Vutla <lokeshvutla@ti.com>
Signed-off-by: default avatarJ.D. Schroeder <jay.schroeder@garmin.com>
Reviewed-by: default avatarTrenton Andres <trenton.andres@garmin.com>
Signed-off-by: default avatarGrygorii Strashko <grygorii.strashko@ti.com>
Acked-by: default avatarTero Kristo <t-kristo@ti.com>
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
      dbb9c196
  3. 30 Aug, 2016 2 commits
  5. 29 Aug, 2016 1 commit
  7. 26 Aug, 2016 11 commits
  9. 15 Aug, 2016 15 commits
  11. 08 Aug, 2016 1 commit
  13. 07 Aug, 2016 9 commits
    • Linus Torvalds's avatar
      Merge branch 'for-linus' of git://git.kernel.dk/linux-block · 857953d7
      Linus Torvalds authored 
      Pull more block fixes from Jens Axboe:
 "As mentioned in the pull the other day, a few more fixes for this
  round, all related to the bio op changes in this series.

  Two fixes, and then a cleanup, renaming bio->bi_rw to bio->bi_opf.  I
  wanted to do that change right after or right before -rc1, so that
  risk of conflict was reduced.  I just rebased the series on top of
  current master, and no new ->bi_rw usage has snuck in"

* 'for-linus' of git://git.kernel.dk/linux-block:
  block: rename bio bi_rw to bi_opf
  target: iblock_execute_sync_cache() should use bio_set_op_attrs()
  mm: make __swap_writepage() use bio_set_op_attrs()
  block/mm: make bdev_ops->rw_page() take a bool for read/write
      857953d7
    • Linus Torvalds's avatar
      Merge tag 'drm-for-v4.8-zpos' of git://people.freedesktop.org/~airlied/linux · 635a4ba1
      Linus Torvalds authored 
      Pull drm zpos property support from Dave Airlie:
 "This tree was waiting on some media stuff I hadn't had time to get a
  stable branchpoint off, so I just waited until it was all in your tree
  first.

  It's been around a bit on the list and shouldn't affect anything
  outside adding the generic API and moving some ARM drivers to using
  it"

* tag 'drm-for-v4.8-zpos' of git://people.freedesktop.org/~airlied/linux:
  drm: rcar: use generic code for managing zpos plane property
  drm/exynos: use generic code for managing zpos plane property
  drm: sti: use generic zpos for plane
  drm: add generic zpos property
      635a4ba1
    • Jens Axboe's avatar
      block: rename bio bi_rw to bi_opf · 1eff9d32
      Jens Axboe authored 
      Since commit 63a4cc24, bio->bi_rw contains flags in the lower
portion and the op code in the higher portions. This means that
old code that relies on manually setting bi_rw is most likely
going to be broken. Instead of letting that brokeness linger,
rename the member, to force old and out-of-tree code to break
at compile time instead of at runtime.

No intended functional changes in this commit.
Signed-off-by: default avatarJens Axboe <axboe@fb.com>
      1eff9d32
    • Jens Axboe's avatar
      target: iblock_execute_sync_cache() should use bio_set_op_attrs() · 31c64f78
      Jens Axboe authored 
      The original commit missed this function, it needs to mark it a
write flush.

Cc: Mike Christie <mchristi@redhat.com>
Fixes: e742fc32 ("target: use bio op accessors")
Signed-off-by: default avatarJens Axboe <axboe@fb.com>
      31c64f78
    • Jens Axboe's avatar
      mm: make __swap_writepage() use bio_set_op_attrs() · ba13e83e
      Jens Axboe authored 
      Cleaner than manipulating bio->bi_rw flags directly.
Signed-off-by: default avatarJens Axboe <axboe@fb.com>
      ba13e83e
    • Jens Axboe's avatar
      block/mm: make bdev_ops->rw_page() take a bool for read/write · c11f0c0b
      Jens Axboe authored 
      Commit abf54548 changed it from an 'rw' flags type to the
newer ops based interface, but now we're effectively leaking
some bdev internals to the rest of the kernel. Since we only
care about whether it's a read or a write at that level, just
pass in a bool 'is_write' parameter instead.

Then we can also move op_is_write() and friends back under
CONFIG_BLOCK protection.
Reviewed-by: default avatarMike Christie <mchristi@redhat.com>
Signed-off-by: default avatarJens Axboe <axboe@fb.com>
      c11f0c0b
    • Linus Torvalds's avatar
      Merge tag 'doc-4.8-fixes' of git://git.lwn.net/linux · 52ddb7e9
      Linus Torvalds authored 
      Pull documentation fixes from Jonathan Corbet:
 "Three fixes for the docs build, including removing an annoying warning
  on 'make help' if sphinx isn't present"

* tag 'doc-4.8-fixes' of git://git.lwn.net/linux:
  DocBook: use DOCBOOKS="" to ignore DocBooks instead of IGNORE_DOCBOOKS=1
  Documenation: update cgroup's document path
  Documentation/sphinx: do not warn about missing tools in 'make help'
      52ddb7e9
    • Linus Torvalds's avatar
      Merge tag 'binfmt-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jejb/binfmt_misc · e9d488c3
      Linus Torvalds authored 
      Pull binfmt_misc update from James Bottomley:
 "This update is to allow architecture emulation containers to function
  such that the emulation binary can be housed outside the container
  itself.  The container and fs parts both have acks from relevant
  experts.

  To use the new feature you have to add an F option to your binfmt_misc
  configuration"

From the docs:
 "The usual behaviour of binfmt_misc is to spawn the binary lazily when
  the misc format file is invoked.  However, this doesn't work very well
  in the face of mount namespaces and changeroots, so the F mode opens
  the binary as soon as the emulation is installed and uses the opened
  image to spawn the emulator, meaning it is always available once
  installed, regardless of how the environment changes"

* tag 'binfmt-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jejb/binfmt_misc:
  binfmt_misc: add F option description to documentation
  binfmt_misc: add persistent opened binary handler for containers
  fs: add filp_clone_open API
      e9d488c3
    • Eryu Guan's avatar
      fs: return EPERM on immutable inode · 337684a1
      Eryu Guan authored 
      In most cases, EPERM is returned on immutable inode, and there're only a
few places returning EACCES. I noticed this when running LTP on
overlayfs, setxattr03 failed due to unexpected EACCES on immutable
inode.

So converting all EACCES to EPERM on immutable inode.
Acked-by: default avatarDave Chinner <dchinner@redhat.com>
Signed-off-by: default avatarEryu Guan <guaneryu@gmail.com>
Signed-off-by: default avatarAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: default avatarLinus Torvalds <torvalds@linux-foundation.org>
      337684a1
GitLab Nexedi Edition | About GitLab | About Nexedi | 沪ICP备2021021310号-2 | 沪ICP备2021021310号-7