- 16 Apr, 2009 14 commits
-
-
Alexander Beregalov authored
Signed-off-by:
Alexander Beregalov <a.beregalov@gmail.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Alexander Beregalov authored
Signed-off-by:
-
Alexander Beregalov authored
Signed-off-by:
-
Alexander Beregalov authored
Signed-off-by:
-
Alexander Beregalov authored
Signed-off-by:
-
Alexander Beregalov authored
Signed-off-by:
-
Alexander Beregalov authored
Signed-off-by:
-
Alexander Beregalov authored
Signed-off-by:
-
Alexander Beregalov authored
Signed-off-by:
-
Alexander Beregalov authored
Signed-off-by:
-
Alexander Beregalov authored
Remove compat_net_dev_ops code and use struct net_device_ops instead of it. Signed-off-by:
-
Alexander Beregalov authored
Since all usb network drivers are already converted to net_device_ops this code is useless. Signed-off-by:
-
Alexander Beregalov authored
Since both ipw2100 and ipw2200 are already converted to new net_device_ops this code is useless. Signed-off-by:
-
Herbert Xu authored
It turns out that copying a 16-byte area at ~800k times a second can be really expensive :) This patch redesigns the frags GRO interface to avoid copying that area twice. The two disciples of the frags interface have been converted. Signed-off-by:
Herbert Xu <herbert@gondor.apana.org.au> Signed-off-by:
-
- 13 Apr, 2009 5 commits
-
-
Rafael J. Wysocki authored
The recent changes of the PCI PM core allow us to simplify the suspend and resume handling in a number of device drivers, since they don't need to carry out the general PCI PM operations, such as changing the power state of the device, during suspend and resume any more. Simplify the suspend and resume callbacks of r8169 using the observation that the PCI PM core can take care of some operations carried out by the driver. Additionally, make the shutdown callback of r8169 only put the device into a low power state if the system is going to be powered off (kexec is known to have problems with network adapters that are put into low power states on shutdown). This patch has been tested on MSI Wind U100. Signed-off-by:
Rafael J. Wysocki <rjw@sisk.pl> Tested-by:
Bruno Prémont <bonbons@linux-vserver.org> Signed-off-by:
-
Alexander Beregalov authored
Signed-off-by:
-
Larry Finger authored
The driver kaweth yields a -EBUSY error when starting, and a -ETIME error when shutting down. These errors are avoided, and the RX status is further checked for other potential errors. Signed-off-by:
Larry Finger <Larry.Finger@lwfinger.net> Signed-off-by:
-
Wei Yongjun authored
Remove pointless conditional before kfree_skb(). Signed-off-by:
Wei Yongjun <yjwei@cn.fujitsu.com> Signed-off-by:
-
Ajit Khaparde authored
- Enables Rx checksum feature by default. - Disables support for ipv6 tso. - Changes in Rx path to handle Rx completions with various checksum options. Signed-off-by:
Ajit Khaparde <ajitk@serverengines.com> Signed-off-by:
-
- 11 Apr, 2009 10 commits
-
-
Tony Breeds authored
GCC warns: drivers/net/ixgbe/ixgbe_main.c: In function 'ixgbe_sfp_config_module_task': drivers/net/ixgbe/ixgbe_main.c:3920: warning: suggest parantheses around operand of '!' or change '&' to '&&' or '!' to '~' Which I think is right. Bracket to remove ambiguity. Signed-off-by:
Tony Breeds <tony@bakeyournoodle.com> Signed-off-by:
Jeff Kirsher <jeffrey.t.kirsher@intel.com> Signed-off-by:
-
Peter P Waskiewicz Jr authored
Not all physical connection types are being correctly identified. This fixes that issue, and cleans up the logic to make it more maintainable. Also clean up the code for device capabilities from the EEPROM to support multiple SKUs of the same hardware. Bump the version to reflect all the updates since the 82599 merge. Signed-off-by:
Peter P Waskiewicz Jr <peter.p.waskiewicz.jr@intel.com> Signed-off-by:
-
PJ Waskiewicz authored
The orig_autoc variable tracks the original setting of the autonegotiate state prior to trying a new speed. The usage is inconsistent and not very maintainable. This patch updates the usage to make it more consistent. Signed-off-by:
-
PJ Waskiewicz authored
This patch does two things: 1) On 82599, the PHY is emedded in the MAC. On 82598, the SFP+ NIC has an external PHY. The reset in the SFP+ setup patch for 82598 is unnecessary on 82599, and adds extra dead time to device initialization. This removes that PHY reset for 82599 only. 2) On 82599, the SFP+ modules are multispeed fiber modules (10G/1G). We need to make sure to identify them properly for the remaining init sections to properly set them up. Signed-off-by:
-
PJ Waskiewicz authored
When PHY operations are determined, the PHY must be identified. This identification causes bus access, and should be contained within its own routines. This also helps the 82599 PHY init paths for both SFP+ and KX/KX4 devices to be easier to maintain. Signed-off-by:
-
PJ Waskiewicz authored
When flow control is disabled, an invalid low/high watermark configuration should not matter. Signed-off-by:
-
Don Skidmore authored
82599 supports 64 IVAR registers this patch adds a define to allow us to access them. Signed-off-by:
Don Skidmore <donald.c.skidmore@intel.com> Acked-by:
-
Don Skidmore authored
These defines allow for definition of target pool for packets that pass L2 filtering but didn't pass any of the pool filters. They are needed to reset the default pool. Signed-off-by:
-
Don Skidmore authored
IXGBE_MTQC_64VF was wrong and 32VF not defined at all. This patch corrects that. Signed-off-by:
-
PJ Waskiewicz authored
The discard pause frames bit was not enabled, so flow control frames could be passed up to the host. Enabled DPF to keep the frames off the stack. Signed-off-by:
-
- 10 Apr, 2009 11 commits
-
-
Kyle McMartin authored
Signed-off-by:
Kyle McMartin <kyle@redhat.com> Signed-off-by:
Andy Grover <andy.grover@oracle.com> Signed-off-by:
-
Dan Carpenter authored
rdma_create_id() doesn't return NULL, only ERR_PTR(). Found by smatch (http://repo.or.cz/w/smatch.git). Compile tested. regards, dan carpenter Signed-off-by:
Dan Carpenter <error27@gmail.com> Signed-off-by:
-
Dan Carpenter authored
rdma_create_id() returns ERR_PTR() not null. Found by smatch (http://repo.or.cz/w/smatch.git). Compile tested. regards, dan carpenter Signed-off-by:
-
Wei Yongjun authored
Use kmem_cache_zalloc instead of kmem_cache_alloc/memset. Signed-off-by:
-
Huang Weiyi authored
Remove unused #include <version.h> in net/rds/af_rds.c. Signed-off-by:
Huang Weiyi <weiyi.huang@gmail.com> Signed-off-by:
-
Andy Grover authored
Use the new function that is simpler and faster. Signed-off-by:
-
Andy Grover authored
The first message to a remote node should prompt a new connection. Even an RDMA op via CMSG. Therefore move CMSG parsing to after connection establishment. Signed-off-by:
-
Andy Grover authored
Putting the constant first is a supposed "best practice" that actually makes the code harder to read. Thanks to Roland Dreier for finding a bug in this "simple, obviously correct" patch. Signed-off-by:
-
Steve Wise authored
Fix hack that restricts the credit advertisement to 127. Signed-off-by:
Steve Wise <swise@opengridcomputing.com> Signed-off-by:
-
Steve Wise authored
The RDS_LL_SEND_FULL bit should be set when we stop transmitted due to flow control. Otherwise the send worker will keep trying as opposed to sleeping until we unthrottle. Saves CPU. Signed-off-by:
-
Andy Grover authored
Had some lingering instances of _iw_ variable names from when the listen code was centralized into rdma_transport.c Signed-off-by:
-
