Use the new lock initializers DEFINE_SPIN_LOCk and DEFINE_RW_LOCK
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Signed-off-by: David S. Miller <davem@davemloft.net>

into nuts.davemloft.net:/disk1/BK/net-2.6

Signed-off-by: Hideaki YOSHIFUJI <yoshfuji@linux-ipv6.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

into nuts.davemloft.net:/disk1/BK/tgraf-2.6

Signed-off-by: David S. Miller <davem@davemloft.net>

The netlink_post stuff Arjan removed was the only
user of this array.
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

do_tcp_sendpages() needs to do skb->truesize et al.
accounting just like tcp_sendmsg() does.

tcp_sendmsg() works by gradually adjusting these
accounting knobs as user data is copied into the
packet.

do_tcp_sendpages() works differently, when it allocates
a new SKB it optimistically adds in tp->mss_cache to
these values and then makes no adjustments at all as
pages are tacked onto the packet.

This does not work at all if tcp_sendmsg() queues a
packet onto the send queue, and then do_tcp_sendpages()
attaches pages onto the end of that SKB.  We are left
with a very inaccurate skb->truesize in that case.

Consequently, if we were building a TSO frame and it
gets partially ACK'd, then since skb->truesize is too
small tcp_trim_skb() will potentially underflow it's
value and all the accounting becomes corrupted.

This is usually seen as sk->sk_forward_alloc being
negative at socket destroy time, which triggers an
assertion check.
Signed-off-by: David S. Miller <davem@davemloft.net>

into nuts.davemloft.net:/disk1/BK/net-2.6

This patch fixes a problem I have been seeing since all the preempt
changes went in, which is that ppc64 SMP systems would livelock
randomly if preempt was enabled.

It turns out that what was happening was that one cpu was spinning in
spin_lock_irq (the version at line 215 of kernel/spinlock.c) madly
doing preempt_enable() and preempt_disable() calls.  The other cpu had
the lock and was trying to set the TIF_NEED_RESCHED flag for the task
running on the first cpu.  That is an atomic operation which has to be
retried if another cpu writes to the same cacheline between the load
and the store, which the other cpu was doing every time it did
preempt_enable() or preempt_disable().

I decided to move the thread_info flags field into the next cache
line, since it is the only field that would regularly be modified by
cpus other than the one running the task that owns the thread_info.
(OK possibly the `cpu' field would be on a rebalance; I don't know the
rebalancing code, but that should be pretty infrequent.)  Thus, moving
the flags field seems like a good idea generally as well as solving the
immediate problem.

For the record I am pretty unhappy with the code we use for spin_lock
et al. with preemption turned on (the BUILD_LOCK_OPS stuff in
spinlock.c).  For a start we do the atomic op (_raw_spin_trylock) each
time around the loop.  That is going to be generating a lot of
unnecessary bus (or fabric) traffic.  Instead, after we fail to get
the lock we should poll it with simple loads until we see that it is
clear and then retry the atomic op.  Assuming a reasonable cache
design, the loads won't generate any bus traffic until another cpu
writes to the cacheline containing the lock.

Secondly we have lost the __spin_yield call that we had on ppc64,
which is an important optimization when we are running under the
hypervisor.  I can't just put that in cpu_relax because I need to know
which (virtual) cpu is holding the lock, so that I can tell the
hypervisor which virtual cpu to give my time slice to.  That
information is stored in the lock variable, which is why __spin_yield
needs the address of the lock.
Signed-off-by: Paul Mackerras <paulus@samba.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This patch adds the PREEMPT_BKL config option for PPC64, shamelessly
stolen from the i386 version.  I have this turned on in the kernel on
my desktop G5 and it seems to be just fine.
Signed-off-by: Paul Mackerras <paulus@samba.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This patch enables the DEBUG_PREEMPT config option for PPC64.  I have
this turned on on my desktop G5 and it isn't finding any problems.
(It did find one problem, in flush_tlb_pending(), that I have just
sent a patch for.)

BTW, do we really need to restrict which architectures the config
option is available on?
Signed-off-by: Paul Mackerras <paulus@samba.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This patch mirrors the recent changes on x86 to call preempt_schedule
rather than schedule in the exception exit path, in the case where the
preempt_count is zero and the TIF_NEED_RESCHED bit is set.

I'm a little concerned that this means that we have a window where
interrupts are enabled and we are on our way into preempt_schedule,
but preempt_count is still zero.  Ingo's proposed preempt_schedule_irq
would fix this, and I think something like that should go in.
Signed-off-by: Paul Mackerras <paulus@samba.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

The preempt debug stuff found a place where we were using
smp_processor_id() without having preemption disabled, in
flush_tlb_pending.  This patch fixes it by using get_cpu_var and
put_cpu_var instead of the __get_cpu_var variant.
Signed-off-by: Paul Mackerras <paulus@samba.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

I stumbled across this the other day. The block layer only uses a single
memory pool for request allocation, so it's very possible for eg writes
to have allocated them all at any point in time. If that is the case and
the machine is low on memory, a reader attempting to allocate a request
and failing in blk_alloc_request() can get stuck for a long time since
no one is there to wake it up.

The solution is either to add the extra mempool so both reads and writes
have one, or attempt to handle the situation. I chose the latter, to
save the extra memory required for the additional mempool with
BLKDEV_MIN_RQ statically allocated requests per-queue.

If a read allocation fails and we have no readers in flight for this
queue, mark us rq-starved so that the next write being freed will wake
up the sleeping reader(s). Same situation would happen for writes as
well of course, it's just a lot more unlikely.
Signed-off-by: Jens Axboe <axboe@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

"ATA over Ethernet support" should not default to 'm', it doesn't make
any sense for a special case driver to do so.
Signed-off-by: Jens Axboe <axboe@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Use the new lock initializers DEFINE_SPIN_LOCK and DEFINE_RW_LOCK.
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>

Signed-off-by: Patrick McHardy <kaber@trash.net>

A recent trivial fixup in sys_getdents64 gives gcc-2.96 indigestion in
the form of an ICE.

While upgrading to a sane gcc would be the preferred solution, rewriting
the change as follows eliminates the error for those who cannot do so.
Signed-off-by: Adam Kropelin <akropel1@rochester.rr.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This broke since the recent MODULE_PARAM conversion on
architectures that don't have CONFIG_MTRR
Signed-off-by: Dave Jones <davej@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

into flint.arm.linux.org.uk:/usr/src/bk/linux-2.6-rmk

Patch from Nicolas Pitre

This patch adds support for all alignments to both endianness.

Signed-off-by: Nicolas Pitre 
Signed-off-by: Russell King

Patch from Nicolas Pitre

Now that MTD XIP support is merged this part is
not relevant anymore.

Signed-off-by: Nicolas Pitre
Signed-off-by: Russell King

Signed-off-by: Russell King

Patch from Ben Dooks

MAINTAINERS entries for currently supported Simtec Electronics
development boards.

Signed-off-by: Ben Dooks
Signed-off-by: Russell King

Patch from Catalin Marinas

The patch adds the "ax" attributes to the .sched.text section to
avoid a compiler warning.

Signed-off-by: Catalin Marinas
Signed-off-by: Russell King

Patch from Richard Purdie

The Sharp SL-C7xx Series (Corgi) has 3 devices connected to the SSP
interface each needing different configurations of the port.
This code provides the necessary access and locking so drivers can
access these components. It uses the functions provided by the PXA
SSP driver to access the port.
It also adds some machine specific GPIO definitions used by this
code and adds some comments to existing definitions.

Signed-off-by: Richard Purdie
Signed-off-by: Russell King

asm/processor.h doesn't use atomic operations nor types, so
there's no need to include asm/atomic.h.
Signed-off-by: Russell King <rmk@arm.linux.org.uk>

into ppc970.osdl.org:/home/torvalds/v2.6/linux

into ppc970.osdl.org:/home/torvalds/v2.6/linux

From: 	James.Smart@Emulex.Com

This patch adds 5 more FC transport host attributes in support of HBAAPI. 
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>

From: 	James.Smart@Emulex.Com

This patch deprecates the use of device_for_each_child() with stargets.
The reasoning behind this is due to issues regarding:
      Semaphores that device_for_each_child() takes
      Implicit assumptions that each child is an sdev device.

The patch adds a new helper function, starget_for_each_device(), and
replaces all previous uses of device_for_each_child().
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>

From: Jesse Barnes <jbarnes@engr.sgi.com>

There are a few spots in qla1280.c that don't need a full PCI write flush
to the device, but rather a simple write ordering guarantee.  This patch
changes some of the PIO reads that cause write flushes into mmiowb calls
instead, which is a lighter weight way of ensuring ordering.
Signed-off-by: Jeremy Higdon <jeremy@sgi.com>
Signed-off-by: Jesse Barnes <jbarnes@sgi.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>

From: Adrian Bunk <bunk@stusta.de>

The patch below kills kernel 2.2 #ifdef's from the SCSI aic7xxx driver.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>

This is really part of the earlier changeset from David to add the
new machine vector to support certain limited range DMA cards on
zx1.  I just forgot to run "bk new" before the commit, so the newly
added files weren't checked into BK.
Signed-off-by: David Mosberger-Tang <davidm@hpl.hp.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>

In ChangeSet 1.2370, 2005/01/11 17:41:32-08:00, tglx@linutronix.de wrote:
>
>         [PATCH] ppc: remove duplicate define
>        
>         The MMCR0_PMXE is already defined in reg.h...

Er, no it's not. But perhaps it should be...

Ingo presumably didn't notice that ppc64 already had a functional
_raw_read_trylock when he added the #define to use the generic
version.  This just removes the #define so we use the ppc64-specific
version again.
Signed-off-by: Paul Mackerras <paulus@samba.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Currently we only print the default io scheduler if the kernel chooses,
not if the user/bootloader has specified one. This patch saves the extra
line in dmesg but always notified of the default choice by appending
(default) to that line:

	..
	io scheduler noop registered
	io scheduler anticipatory registered
	io scheduler deadline registered
	io scheduler cfq registered (default)
	..

Patch originally from Srihari Vijayaraghavan, modified by me.
Signed-off-by: Jens Axboe <axboe@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>