- 05 Aug, 2009 19 commits
-
-
Benjamin LaHaise authored
wmb() is extremely heavy on x86. The semantics required in the driver are provided by mmiowb(), so use that and improve tx performance on P4 Xeons by 5-10%. Signed-off-by:
Benjamin LaHaise <ben.lahaise@neterion.com> Signed-off-by:
Sreenivasa Honnur <sreenivasa.honnur@neterion.com> Signed-off-by:
Ramkrishna Vepa <ram.vepa@neterion.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Benjamin LaHaise authored
This patch fixes a case in the transmit completion code which was resulting in pktgen hanging at the end of a run. The cause is due to the fact that the ->cb[] area of an skb cannot be used in a network driver's transmit path, as that area belongs to the network protocol. Pktgen hangs, as it sends out the same packet multiple times, and vxge's use of this area of the skb for a temporary list can only add the packet to the temporary list once (while it may be on the queue many times). The fix is to remove this abuse of skb->cb[]. Instead, skb pointers are placed into a temporary stack array, and then free outside of the tx lock. This retains the smp optimization of doing dev_kfree_skb() outside of the tx lock. Signed-off-by:
-
Benjamin LaHaise authored
The vxge driver will drop a packet in its transmit function if the number of TxDs available hits 0. Instead of doing that, simply stop the transmit queue when transmitting a packet with the last available TxD. Signed-off-by:
-
Lucy Liu authored
The skb priority to vlan-qos egress mapping that can be configured using set_egress_map with vconfig is overriden by the DCB code in the driver. This patch allows this existing mechanism to work and will increase the configuration flexibility of DCB mode on Linux. A hierarchy of configuration is: 1. Modifies the ixgbe_select_queue() routine for DCB mode to return the priority value from the VLAN tag. It will normally be zero, unless the egress priority map has modified it. This will get packets into the correct queue and result in the queue_mapping field being set correctly. 2. Any tc filter which modifies queue_mapping will be honored, as the filters are handled after the vlan egress map is handled. Signed-off-by:
Lucy Liu <lucy.liu@intel.com> Signed-off-by:
Jeff Kirsher <jeffrey.t.kirsher@intel.com> Signed-off-by:
-
sarveshwarb authored
This patch is a bug fix to avoid system going into a bad state when driver is loaded in context of kdump kernel. The patch fixes the issue by performing a soft reset of pci function at probe time. Signed-off-by:
sarveshwarb <sarveshwarb@serverengines.com> Signed-off-by:
-
Jan Engelhardt authored
This sockopt goes in line with SO_TYPE and SO_PROTOCOL. It makes it possible for userspace programs to pass around file descriptors — I am referring to arguments-to-functions, but it may even work for the fd passing over UNIX sockets — without needing to also pass the auxiliary information (PF_INET6/IPPROTO_TCP). Signed-off-by:
Jan Engelhardt <jengelh@medozas.de> Signed-off-by:
-
Jan Engelhardt authored
Similar to SO_TYPE returning the socket type, SO_PROTOCOL allows to retrieve the protocol used with a given socket. I am not quite sure why we have that-many copies of socket.h, and why the values are not the same on all arches either, but for where hex numbers dominate, I use 0x1029 for SO_PROTOCOL as that seems to be the next free unused number across a bunch of operating systems, or so Google results make me want to believe. SO_PROTOCOL for others just uses the next free Linux number, 38. Signed-off-by:
-
Dhananjay Phadke authored
Add support to handle aggregate packets from firmware. Local TCP flows are automatically identified by firmware based on the dest IP hash added by driver for local IP addresses. The packets are sent down on the jumbo rx ring. Signed-off-by:
Narender Kumar <narender.kumar@qlogic.com> Signed-off-by:
Dhananjay Phadke <dhananjay@netxen.com> Signed-off-by:
-
Dhananjay Phadke authored
Remove unnecessary offsetof calulations on these structures: netxen_board_info, netxen_user_old_info, netxen_new_user_info. The offsets into the flash are fixed, don't need to be calculated. Signed-off-by:
-
Dhananjay Phadke authored
Fix the calculation of remaining header length in TSO over vlan device case. This was inadvertently missed out in patch 028afe71 ("netxen: add vlan tx acceleration support"). Signed-off-by:
-
Florian Fainelli authored
Starting with version 0.5.1, cpmac is no longer broken. Signed-off-by:
Florian Fainelli <florian@openwrt.org> Signed-off-by:
-
Florian Fainelli authored
Signed-off-by:
-
Florian Fainelli authored
This patch slows down the MDIO_ALIVE busy waiting to let switches and PHY come up after reset. Previous loop was too quick for IC+175C and ADM6996C/L switches to come up. Signed-off-by:
-
Florian Fainelli authored
This patch adds support for fixed PHY connected in MII mode to cpmac. We allow external and dumb_switch module parameters to override the PHY detection process since they are always connected with MDIO bus identifier 0. This lets fixed PHYs to be detected correctly and be connected to the their corresponding MDIO bus identifier. Signed-off-by:
-
Florian Fainelli authored
This patch adds fixed PHY support for the two on-chip cpmac Ethernet adapters. Signed-off-by:
-
Florian Fainelli authored
This patch fixes the wrong MDIO bus identifier which was set to 0 unconditionaly, suitable for external switches while it is actually 1 for PHYs different than external switches which are autodetected. Signed-off-by:
-
Jan Engelhardt authored
String literals are constant, and usually, we can also tag the array of pointers const too, moving it to the .rodata section. Signed-off-by:
-
David S. Miller authored
Same as how Randy Dunlap fixed the ipv4 side of things. Signed-off-by: -
Randy Dunlap authored
Fix build errors when SYSCTLs are not enabled: (.init.text+0x5154): undefined reference to `net_ipv4_ctl_path' (.init.text+0x5176): undefined reference to `register_net_sysctl_table' xfrm4_policy.c:(.exit.text+0x573): undefined reference to `unregister_net_sysctl_table Signed-off-by:
Randy Dunlap <randy.dunlap@oracle.com> Signed-off-by:
-
- 03 Aug, 2009 2 commits
-
-
Eric Dumazet authored
Current neigh_periodic_timer() function is fired by timer IRQ, and scans one hash bucket each round (very litle work in fact) As we are supposed to scan whole hash table in 15 seconds, this means neigh_periodic_timer() can be fired very often. (depending on the number of concurrent hash entries we stored in this table) Converting this to a workqueue permits scanning whole table, minimizing icache pollution, and firing this work every 15 seconds, independantly of hash table size. This 15 seconds delay is not a hard number, as work is a deferrable one. Signed-off-by:
Eric Dumazet <eric.dumazet@gmail.com> Signed-off-by:
-
Hannes Eder authored
Since pr_err and friends are used instead of printk there is no point in keeping IP_VS_ERR and friends. Furthermore make use of '__func__' instead of hard coded function names. Signed-off-by:
Hannes Eder <heder@google.com> Acked-by:
Simon Horman <horms@verge.net.au> Signed-off-by:
-
- 02 Aug, 2009 19 commits
-
-
Steve Glendinning authored
The eeprom read & write commands currently check the E2P_CMD_LOADED_ bit is set before allowing any operations. This prevents any reading or writing unless a correctly programmed EEPROM is installed. This patch removes the check, so it is possible to program blank EEPROMS via ethtool. Signed-off-by:
Steve Glendinning <steve.glendinning@smsc.com> Signed-off-by:
-
Gerrit Renker authored
This renames away a variable clash: * ipv6_table[] is declared as a static global table; * ipv6_sysctl_net_init() uses ipv6_table to refer/destroy dynamic memory; * ipv6_sysctl_net_exit() also uses ipv6_table for the same purpose; * both the two last functions call kfree() on ipv6_table. Signed-off-by:
Gerrit Renker <gerrit@erg.abdn.ac.uk> Signed-off-by:
-
Julia Lawall authored
The kernel.h macro DIV_ROUND_CLOSEST performs the computation (x + d/2)/d but is perhaps more readable. The semantic patch that makes this change is as follows: (http://www.emn.fr/x-info/coccinelle/) // <smpl> @haskernel@ @@ #include <linux/kernel.h> @depends on haskernel@ expression x,__divisor; @@ - (((x) + ((__divisor) / 2)) / (__divisor)) + DIV_ROUND_CLOSEST(x,__divisor) // </smpl> Signed-off-by:
Julia Lawall <julia@diku.dk> Signed-off-by:
-
Julia Lawall authored
The kernel.h macro DIV_ROUND_CLOSEST performs the computation (x + d/2)/d but is perhaps more readable. The semantic patch that makes this change is as follows: (http://www.emn.fr/x-info/coccinelle/) // <smpl> @haskernel@ @@ #include <linux/kernel.h> @depends on haskernel@ expression x,__divisor; @@ - (((x) + ((__divisor) / 2)) / (__divisor)) + DIV_ROUND_CLOSEST(x,__divisor) // </smpl> Signed-off-by:
-
Divy Le Ray authored
Modify control register settings to accommodate the bridge's max read requset size. Signed-off-by:
Divy Le Ray <divy@chelsio.com> Signed-off-by:
-
Divy Le Ray authored
Fix a cut'n paste error in the AEL2020 twinax EDC file name Signed-off-by:
-
Dean Nelson authored
PCI drivers that implement the struct pci_error_handlers' error_detected callback should return PCI_ERS_RESULT_DISCONNECT if the state passed in is pci_channel_io_perm_failure. This patch fixes the issue for vxge. Signed-off-by:
Dean Nelson <dnelson@redhat.com> Signed-off-by:
-
Dean Nelson authored
PCI drivers that implement the struct pci_error_handlers' error_detected callback should return PCI_ERS_RESULT_DISCONNECT if the state passed in is pci_channel_io_perm_failure. This patch fixes the issue for s2io. Signed-off-by:
-
Dean Nelson authored
PCI drivers that implement the struct pci_error_handlers' error_detected callback should return PCI_ERS_RESULT_DISCONNECT if the state passed in is pci_channel_io_perm_failure. This patch fixes the issue for qlge. Signed-off-by:
-
Dean Nelson authored
PCI drivers that implement the struct pci_error_handlers' error_detected callback should return PCI_ERS_RESULT_DISCONNECT if the state passed in is pci_channel_io_perm_failure. This patch fixes the issue for ixgb. Signed-off-by:
-
Dean Nelson authored
PCI drivers that implement the struct pci_error_handlers' error_detected callback should return PCI_ERS_RESULT_DISCONNECT if the state passed in is pci_channel_io_perm_failure. This patch fixes the issue for igbvf. Signed-off-by:
-
Dean Nelson authored
PCI drivers that implement the struct pci_error_handlers' error_detected callback should return PCI_ERS_RESULT_DISCONNECT if the state passed in is pci_channel_io_perm_failure. This patch fixes the issue for bnx2x. Signed-off-by:
-
Dean Nelson authored
PCI drivers that implement the struct pci_error_handlers' error_detected callback should return PCI_ERS_RESULT_DISCONNECT if the state passed in is pci_channel_io_perm_failure. This patch fixes the issue for bnx2. Signed-off-by:
-
Dean Nelson authored
PCI drivers that implement the struct pci_error_handlers' error_detected callback should return PCI_ERS_RESULT_DISCONNECT if the state passed in is pci_channel_io_perm_failure. This patch fixes the issue for atl1e. Signed-off-by:
-
Dean Nelson authored
PCI drivers that implement the struct pci_error_handlers' error_detected callback should return PCI_ERS_RESULT_DISCONNECT if the state passed in is pci_channel_io_perm_failure. This patch fixes the issue for atl1c. Signed-off-by:
-
Sathya Perla authored
When the driver loads the POST stage of the card is expected to be POST_STAGE_ARMFW_RDY. Signed-off-by:
Sathya Perla <sathyap@serverengines.com> Signed-off-by:
-
Sathya Perla authored
be_mbox_db_ring() has been changed to be_mbox_notify() (to be consistent with be_mcc_notify()) and struct be_mcc_cq_entry changed to be_mcc_compl to be consistent with rx/tx_compl. Signed-off-by:
-
Sathya Perla authored
And get rid of some unnecessary printks. Signed-off-by:
-
Sathya Perla authored
pci function is available as PCI_FUNC(pdev->devfn); no need for a separate field. Signed-off-by:
-
