To control power to a power domain, the System Controller (SYSC) needs
the corresponding interrupt source to be enabled, but masked, to prevent
the CPU from receiving it.

Currently this is handled in the driver's probe() routine, and set up
for every domain present, even if it will not be controlled directly by
SYSC (CPU domains are powered through the APMU on R-Car Gen2 and later).

On R-Car Gen3, PSCI powers down the SoC during system suspend, thus
losing any configured interrupt state.  Hence after system resume, power
domains not controlled through the APMU (e.g. A3IR, A3VC, A3VP) fail to
power up.

Fix this by replacing the global interrupt setup in the probe() routine
by a domain-specific interrupt setup in rcar_sysc_power(), where the
domain's power is actually controlled.  This brings the code more in
line with the flowchart in the Hardware User's Manual.
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Simon Horman <horms+renesas@verge.net.au>