• Michael Scott's avatar
    pinctrl: qcom: Add msm8994 pinctrl driver · 465e4218
    Michael Scott authored
    Initial pinctrl driver for QCOM msm8994 platforms.
    
    In order to continue the initial board support for QCOM msm8994/msm8992
    presented in patches from Jeremy McNicoll <jeremymc@redhat.com>, let's put
    a proper pinctrl driver in place.
    
    Currently, the DT for these platforms uses the msm8x74 pinctrl driver to
    enable basic UART.  Beyond the first few pins the rest are different enough
    to justify it's own driver.
    
    Note: This driver is also used by QCOM's msm8992 platform as it's TLM block
    is the same.
    
    - Initial formatting and style was taken from the msm8x74 pinctrl driver
      added by Björn Andersson <bjorn.andersson@linaro.org>
    - Data was then adjusted per QCOM MSM8994v2 documentation for Top Level
      Multiplexing
    - Bindings documentation was based on qcom,msm8996-pinctrl.txt by
      Joonwoo Park <joonwoop@codeaurora.org> and then modified for msm8994
      content
    Signed-off-by: default avatarMichael Scott <michael.scott@linaro.org>
    Tested-by: default avatarJeremy McNicoll <jeremymc@redhat.com>
    Acked-by: default avatarBjorn Andersson <bjorn.andersson@linaro.org>
    Acked-by: default avatarRob Herring <robh@kernel.org>
    Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
    465e4218
Makefile 928 Bytes