Request and enable the "vio" regulator that represents the power supply
that is needed for the pull-up resistors of the interrupt and I2C lines
of AW2013. While this regulator is not wired directly to the AW2013
chip it is best managed as part of the AW2013 driver since it decides
when AW2013 is powered on and when the interrupt is enabled or
disabled.

This regulator should always be enabled in conjunction with the main
VCC power supply, so use the bulk regulator functions to enable both
at the same time.
Signed-off-by: Lin, Meng-Bo <linmengbo0689@protonmail.com>
[rewrite commit message based on discussion]
Signed-off-by: Stephan Gerhold <stephan@gerhold.net>
Reviewed-by: Nikita Travkin <nikita@trvn.ru>
Link: https://lore.kernel.org/r/20230815-aw2013-vio-v3-3-2505296b0856@gerhold.netSigned-off-by: Lee Jones <lee@kernel.org>