• Suman Anna's avatar
    iommu/omap: Enable bus-error back on supported iommus · b148d5fb
    Suman Anna authored
    The remoteproc MMUs in OMAP4+ SoCs have some additional debug
    registers that can give out the PC value in addition to the
    MMU fault address. The PC value can be extracted properly only
    on the DSP cores, and is not available on the ARM processors
    within the IPU sub-systems. Instead, the MMUs have been enhanced
    to throw a bus-error response back to the IPU processors.
    
    This functionality is programmable through the MMU_GP_REG register.
    The cores are simply stalled if the MMU_GP_REG.BUS_ERR_BACK_EN bit
    is not set. When set, a bus-error exception is raised allowing the
    processor to handle it as a bus fault and provide additional debug
    information. This feature is turned on by default by the driver on
    iommus supporting it.
    Signed-off-by: default avatarSubramaniam Chanderashekarapuram <subramaniam.ca@ti.com>
    Signed-off-by: default avatarSuman Anna <s-anna@ti.com>
    Signed-off-by: default avatarJoerg Roedel <joro@8bytes.org>
    b148d5fb
omap-iommu2.c 7.99 KB