• Thomas Gleixner's avatar
    x86/hotplug: Silence APIC and NMI when CPU is dead · 60dcaad5
    Thomas Gleixner authored
    In order to support IPI/NMI broadcasting via the shorthand mechanism side
    effects of shorthands need to be mitigated:
    
     Shorthand IPIs and NMIs hit all CPUs including unplugged CPUs
    
    Neither of those can be handled on unplugged CPUs for obvious reasons.
    
    It would be trivial to just fully disable the APIC via the enable bit in
    MSR_APICBASE. But that's not possible because clearing that bit on systems
    based on the 3 wire APIC bus would require a hardware reset to bring it
    back as the APIC would lose track of bus arbitration. On systems with FSB
    delivery APICBASE could be disabled, but it has to be guaranteed that no
    interrupt is sent to the APIC while in that state and it's not clear from
    the SDM whether it still responds to INIT/SIPI messages.
    
    Therefore stay on the safe side and switch the APIC into soft disabled mode
    so it won't deliver any regular vector to the CPU.
    
    NMIs are still propagated to the 'dead' CPUs. To mitigate that add a check
    for the CPU being offline on early nmi entry and if so bail.
    
    Note, this cannot use the stop/restart_nmi() magic which is used in the
    alternatives code. A dead CPU cannot invoke nmi_enter() or anything else
    due to RCU and other reasons.
    Signed-off-by: default avatarThomas Gleixner <tglx@linutronix.de>
    Acked-by: default avatarPeter Zijlstra (Intel) <peterz@infradead.org>
    Link: https://lkml.kernel.org/r/alpine.DEB.2.21.1907241723290.1791@nanos.tec.linutronix.de
    60dcaad5
apic.c 70.5 KB