Merge tag 'omap-for-v4.1/prcm-dts' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap into next/late

Pull "Clean-up for omap PRCM (Power Reset Clock Management) and interconnects" from Tony Lindgren
Patches originally from Tero Kristo <t-kristo@ti.com>.

This sets gets us into a better position for further clean-up:

- Gets PRCM code closer to being device drivers

- Allows to move the remainig clock code to drivers/clk for v4.2

- Starts enforcing interconnect hierarchy in the SoC specific .dts
  files to enforce device drivers are only accesing registers in
  the related hardware module

This patchset has seen quite a few revisions but did not come into
mergeable shape until recently. As other patchsets for clock specific
device drivers depend on this, it would be good to get this merged
although it's a bit late for the v4.1 merge window.

Note that as the device entries in the .dts files are moved around,
this is based on earlier non-urgent fixes to avoid a non-trivial
merge conflict.

* tag 'omap-for-v4.1/prcm-dts' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap: (44 commits)
  ARM: OMAP4+: control: add support for initializing control module via DT
  ARM: dts: dra7: add minimal l4 bus layout with control module support
  ARM: dts: omap5: add minimal l4 bus layout with control module support
  ARM: OMAP4+: control: remove support for legacy pad read/write
  ARM: OMAP4: display: convert display to use syscon for dsi muxing
  ARM: dts: omap4: add minimal l4 bus layout with control module support
  ARM: dts: am4372: add minimal l4 bus layout with control module support
  ARM: dts: am43xx-epos-evm: fix pinmux node layout
  ARM: dts: am33xx: add minimal l4 bus layout with control module support
  ARM: dts: omap3: add minimal l4 bus layout with control module support
  ARM: dts: omap24xx: add minimal l4 bus layout with control module support
  ARM: OMAP2+: control: add syscon support for register accesses
  ARM: OMAP2+: id: cache omap_type value
  ARM: OMAP2+: control: remove API for getting control module base address
  ARM: OMAP2+: clock: add low-level support for regmap
  ARM: OMAP4+: PRM: get rid of cpu_is_omap44xx calls from interrupt init
  ARM: OMAP4+: PRM: setup prm_features from the PRM init time flags
  ARM: OMAP2+: CM: move SoC specific init calls within a generic API
  ARM: OMAP4+: PRM: determine prm_device_inst based on DT compatibility
  ARM: OMAP2+: PRM: move SoC specific init calls within a generic API
  ...