• Priyanka Jain's avatar
    powerpc/fsl-booke: Add initial T1040/T1042 RDB board support · 0babcd1c
    Priyanka Jain authored
    T1040/T1042RDB is Freescale Reference Design Board.
    The board can support both T1040/T1042 QorIQ Power Architecture processor.
    
    T1040/T1042RDB board Overview
    -----------------------
    - SERDES Connections, 8 lanes supporting:
    	- PCI
    	- SGMII
        	- QSGMII
        	- SATA 2.0
    - DDR Controller
        	- Supports rates of up to 1600 MHz data-rate
        	- Supports one DDR3LP UDIMM
    -IFC/Local Bus
        	- NAND flash: 1GB 8-bit NAND flash
        	- NOR: 128MB 16-bit NOR Flash
    - Ethernet
        	- Two on-board RGMII 10/100/1G ethernet ports.
        	- PHY #0 remains powered up during deep-sleep
    - CPLD
    - Clocks
        	- System and DDR clock (SYSCLK, “DDRCLK”)
        	- SERDES clocks
    - Power Supplies
    - USB
        	- Supports two USB 2.0 ports with integrated PHYs
        	- Two type A ports with 5V@1.5A per port.
    - SDHC
        	- SDHC/SDXC connector
    - SPI
        	- On-board 64MB SPI flash
    - I2C
        	- Devices connected: EEPROM, thermal monitor, VID controller
    - Other IO
        	- Two Serial ports
        	- ProfiBus port
    
    Add support for T1040/T1042 RDB board:
        -add device tree
        -add entry in Kconfig to build
        -Add entry in corenet_generic.c, as it is similar to other corenet platforms
    Signed-off-by: default avatarPriyanka Jain <Priyanka.Jain@freescale.com>
    Signed-off-by: default avatarPoonam Aggrwal <poonam.aggrwal@freescale.com>
    Signed-off-by: default avatarPrabhakar Kushwaha <prabhakar@freescale.com>
    Signed-off-by: default avatarScott Wood <scottwood@freescale.com>
    0babcd1c
Kconfig 6.99 KB