• Markos Chandras's avatar
    MIPS: net: Add BPF JIT · c6610de3
    Markos Chandras authored
    This adds initial support for BPF-JIT on MIPS
    
    Tested on mips32 LE/BE and mips64 BE/n64 using
    dhcp, ping and various tcpdump filters.
    
    Benchmarking:
    
    Assuming the remote MIPS target uses 192.168.154.181
    as its IP address, and the local host uses 192.168.154.136,
    the following results can be obtained using the following
    tcpdump filter (catches no frames) and a simple
    'time ping -f -c 1000000' command.
    
    [root@(none) ~]# tcpdump -p -n -s 0 -i eth0 net 10.0.0.0/24 -d
    (000) ldh      [12]
    (001) jeq      #0x800           jt 2	jf 8
    (002) ld       [26]
    (003) and      #0xffffff00
    (004) jeq      #0xa000000       jt 16	jf 5
    (005) ld       [30]
    (006) and      #0xffffff00
    (007) jeq      #0xa000000       jt 16	jf 17
    (008) jeq      #0x806           jt 10	jf 9
    (009) jeq      #0x8035          jt 10	jf 17
    (010) ld       [28]
    (011) and      #0xffffff00
    (012) jeq      #0xa000000       jt 16	jf 13
    (013) ld       [38]
    (014) and      #0xffffff00
    (015) jeq      #0xa000000       jt 16	jf 17
    (016) ret      #65535
    
    - BPF-JIT Disabled
    
    real    1m38.005s
    user    0m1.510s
    sys     0m6.710s
    
    - BPF-JIT Enabled
    
    real    1m35.215s
    user    0m1.200s
    sys     0m4.140s
    
    [ralf@linux-mips.org: Resolved conflict.]
    Signed-off-by: default avatarMarkos Chandras <markos.chandras@imgtec.com>
    c6610de3
Makefile 59 Bytes