• Frank Rowand's avatar
    of: overlay: test case of two fragments adding same node · a68238a1
    Frank Rowand authored
    Multiple overlay fragments adding or deleting the same node is not
    supported.  An attempt to do so results in an incorrect devicetree.
    The node name will be munged for the second add.
    
    After adding this patch, the unittest messages will show:
    
       Duplicate name in motor-1, renamed to "controller#1"
       OF: overlay: of_overlay_apply() err=0
       ### dt-test ### of_overlay_fdt_apply() expected -22, ret=0, overlay_bad_add_dup_node
       ### dt-test ### FAIL of_unittest_overlay_high_level():2419 Adding overlay 'overlay_bad_add_dup_node' failed
    
       ...
    
       ### dt-test ### end of unittest - 210 passed, 1 failed
    
    The incorrect (munged) node name "controller#1" can be seen in the
    /proc filesystem:
    
       $ pwd
       /proc/device-tree/testcase-data-2/substation@100/motor-1
       $ ls
       compatible    controller    controller#1  name          phandle       spin
       $ ls controller
       power_bus
       $ ls controller#1
       power_bus_emergency
    Tested-by: default avatarAlan Tull <atull@kernel.org>
    Signed-off-by: default avatarFrank Rowand <frank.rowand@sony.com>
    a68238a1
Makefile 903 Bytes