• Emmanuel Grumbach's avatar
    iwlwifi: pcie: fix RF-Kill vs. firmware load race · a6bd005f
    Emmanuel Grumbach authored
    When we load the firmware, we hold trans_pcie->mutex to
    avoid nested flows. We also rely on the ISR to wake up the
    thread when the DMA has finished copying a chunk. During
    this flow, we enable the RF-Kill interrupt.
    
    The problem is that the RF-Kill interrupt handler can take
    the mutex and bring the device down. This means that if
    we load the firmware while the RF-Kill switch is enabled
    (which will happen when we load the INIT firmware to read
    the device's capabilities and register to mac80211), we
    may get an RF-Kill interrupt immediately and the ISR will
    be waiting for the mutex held by the thread that is
    currently loading the firmware. At this stage, the ISR
    won't be able to service the DMA's interrupt needed to
    wake up the thread that load the firmware. We are in a
    deadlock situation which ends when the thread that loads
    the firmware fails on timeout and releases the mutex.
    
    To fix this, take the mutex later in the flow, disable
    the interrupts and synchronize_irq() to give a chance to
    the RF-Kill interrupt to run and complete.
    After that, mask all the interrupts besides the DMA
    interrupt and proceed with firmware load. Make sure to
    check that there was no RF-Kill interrupt when the
    interrupts were disabled.
    
    This fixes https://bugzilla.kernel.org/show_bug.cgi?id=111361Signed-off-by: default avatarEmmanuel Grumbach <emmanuel.grumbach@intel.com>
    a6bd005f
rx.c 46.9 KB