-
dingtianhong authored
The "follow" fail_over_mac policy is useful for multiport devices that either become confused or incur a performance penalty when multiple ports are programmed with the same MAC address, but the same MAC address still may happened by this steps for this policy: 1) echo +eth0 > /sys/class/net/bond0/bonding/slaves bond0 has the same mac address with eth0, it is MAC1. 2) echo +eth1 > /sys/class/net/bond0/bonding/slaves eth1 is backup, eth1 has MAC2. 3) ifconfig eth0 down eth1 became active slave, bond will swap MAC for eth0 and eth1, so eth1 has MAC1, and eth0 has MAC2. 4) ifconfig eth1 down there is no active slave, and eth1 still has MAC1, eth2 has MAC2. 5) ifconfig eth0 up the eth0 became active slave again, the bond set eth0 to MAC1. Something wrong here, then if you set eth1 up, the eth0 and eth1 will have the same MAC address, it will break this policy for ACTIVE_BACKUP mode. This patch will fix this problem by finding the old active slave and swap them MAC address before change active slave. Signed-off-by:
Ding Tianhong <dingtianhong@huawei.com> Tested-by:
Nikolay Aleksandrov <nikolay@cumulusnetworks.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
a951bc1e