• Akinobu Mita's avatar
    iio: adc: add max1117/max1118/max1119 ADC driver · a9e9c715
    Akinobu Mita authored
    This adds max1117/max1118/max1119 8-bit, dual-channel ADC driver.
    
    This new driver uses the zero length spi_transfers with the cs_change
    flag set and/or the non-zero delay_usecs.
    
    1. The zero length transfer with the spi_transfer.cs_change set is
    required in order to select CH1.  The chip select line must be brought
    high and low again without transfer.
    
    2. The zero length transfer with the spi_transfer.delay_usecs > 0 is
    required for waiting the conversion to be complete.  The conversion
    begins with the falling edge of the chip select.  During the conversion
    process, SCLK is ignored.
    
    These two usages are unusual.  But the spi controller drivers that use
    a default implementation of transfer_one_message() are likely to work.
    (I've tested this adc driver with spi-omap2-mcspi and spi-xilinx)
    
    On the other hand, some spi controller drivers that have their own
    transfer_one_message() may not work.  But at least for the zero length
    transfer with delay_usecs > 0, I'm proposing a new testcase for the
    spi-loopback-test that can test whether the delay_usecs setting has
    taken effect.
    Acked-by: default avatarRob Herring <robh@kernel.org>
    Signed-off-by: default avatarAkinobu Mita <akinobu.mita@gmail.com>
    Cc: Jonathan Cameron <jic23@kernel.org>
    Cc: Hartmut Knaack <knaack.h@gmx.de>
    Cc: Lars-Peter Clausen <lars@metafoo.de>
    Cc: Peter Meerwald-Stadler <pmeerw@pmeerw.net>
    Cc: Rob Herring <robh+dt@kernel.org>
    Cc: Mark Rutland <mark.rutland@arm.com>
    Cc: Mark Brown <broonie@kernel.org>
    Signed-off-by: default avatarJonathan Cameron <jic23@kernel.org>
    a9e9c715
Makefile 3.01 KB