• Sarah Sharp's avatar
    xhci: Disable D3cold for buggy TI redrivers. · c3897aa5
    Sarah Sharp authored
    Some xHCI hosts contain a "redriver" from TI that silently drops port
    status connect changes if the port slips into Compliance Mode.  If the
    port slips into compliance mode while the host is in D0, there will not
    be a port status change event.  If the port slips into compliance mode
    while the host is in D3, the host will not send a PME.  This includes
    when the system is suspended (S3) or hibernated (S4).
    
    If this happens when the system is in S3/S4, there is nothing software
    can do.  Other port status change events that would normally cause the
    host to wake the system from S3/S4 may also be lost.  This includes
    remote wakeup, disconnects and connects on other ports, and overrcurrent
    events.  A decision was made to _NOT_ disable system suspend/hibernate
    on these systems, since users are unlikely to enable wakeup from S3/S4
    for the xHCI host.
    
    Software can deal with this issue when the system is in S0.  A work
    around was put in to poll the port status registers for Compliance Mode.
    The xHCI driver will continue to poll the registers while the host is
    runtime suspended.  Unfortunately, that means we can't allow the PCI
    device to go into D3cold, because power will be removed from the host,
    and the config space will read as all Fs.
    
    Disable D3cold in the xHCI PCI runtime suspend function.
    
    This patch should be backported to kernels as old as 3.2, that
    contain the commit 71c731a2 "usb: host:
    xhci: Fix Compliance Mode on SN65LVPE502CP Hardware"
    Signed-off-by: default avatarSarah Sharp <sarah.a.sharp@linux.intel.com>
    Cc: Huang Ying <ying.huang@intel.com>
    Cc: stable@vger.kernel.org
    c3897aa5
xhci.h 63.5 KB