pm_runtime_resume_and_get should be called when the s_frame_interval
is called.

The driver will try to access device registers to configure VMAX, coarse
time and exposure.

Currently if the runtime is not resumed, this fails:
 # media-ctl -d /dev/media0 --set-v4l2 '"IMX274 1-001a":0[fmt:SRGGB10_1X10/3840x2
160@1/10]'

IMX274 1-001a: imx274_binning_goodness: ask 3840x2160, size 3840x2160, goodness 0
IMX274 1-001a: imx274_binning_goodness: ask 3840x2160, size 1920x1080, goodness -3000
IMX274 1-001a: imx274_binning_goodness: ask 3840x2160, size 1280x720, goodness -4000
IMX274 1-001a: imx274_binning_goodness: ask 3840x2160, size 1280x540, goodness -4180
IMX274 1-001a: __imx274_change_compose: selected 1x1 binning
IMX274 1-001a: imx274_set_frame_interval: input frame interval = 1 / 10
IMX274 1-001a: imx274_read_mbreg : addr 0x300e, val=0x1 (2 bytes)
IMX274 1-001a: imx274_set_frame_interval : register SVR = 1
IMX274 1-001a: imx274_read_mbreg : addr 0x30f6, val=0x6a8 (2 bytes)
IMX274 1-001a: imx274_set_frame_interval : register HMAX = 1704
IMX274 1-001a: imx274_set_frame_length : input length = 2112
IMX274 1-001a: imx274_write_mbreg : i2c bulk write failed, 30f8 = 884 (3 bytes)
IMX274 1-001a: imx274_set_frame_length error = -121
IMX274 1-001a: imx274_set_frame_interval error = -121
Unable to setup formats: Remote I/O error (121)

The device is not resumed thus the remote I/O error.

Setting the frame interval works at streaming time, because
pm_runtime_resume_and_get is called at s_stream time before sensor setup.
The failure happens when only the s_frame_interval is called separately
independently on streaming time.

Fixes: ad97bc37 ("media: i2c: imx274: Add IMX274 power on and off sequence")
Signed-off-by: Eugen Hristev <eugen.hristev@microchip.com>
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>