-
Florian Westphal authored
When net.bridge.bridge-nf-filter-vlan-tagged is 0 (default), vlan packets arriving should not be sent to ip(6)tables by bridge netfilter. However, it turns out that we currently always send VLAN packets to netfilter, if .. a), CONFIG_VLAN_8021Q is enabled ; or b), CONFIG_VLAN_8021Q is not set but rx vlan offload is enabled on the bridge port. This is because bridge netfilter treats skb with skb->protocol == ETH_P_IP{V6} as "non-vlan packet". With rx vlan offload on or CONFIG_VLAN_8021Q=y, the vlan header has already been removed here, and we cannot rely on skb->protocol alone. Fix this by only using skb->protocol if the skb has no vlan tag, or if a vlan tag is present and filter-vlan-tagged bridge netfilter sysctl is enabled. We cannot remove the skb->protocol == htons(ETH_P_8021Q) test because the vlan tag is still around in the CONFIG_VLAN_8021Q=n && "ethtool -K $itf rxvlan off" case. reproducer: iptables -t raw -I PREROUTING -i br0 iptables -t raw -I PREROUTING -i br0.1 Then send packets to an ip address configured on br0.1 interface. Even with net.bridge.bridge-nf-filter-vlan-tagged=0, the 1st rule will match instead of the 2nd one. With this patch applied, the 2nd rule will match instead. In the non-local address case, netfilter won't be consulted after this patch unless the sysctl is switched on. Signed-off-by:
Florian Westphal <fw@strlen.de> Signed-off-by:
Pablo Neira Ayuso <pablo@netfilter.org> Signed-off-by:
David S. Miller <davem@davemloft.net>
739e4505