• Christian Lamparter's avatar
    ARM: dts: qcom: add and enable both wifi blocks on the IPQ4019 · 0d363594
    Christian Lamparter authored
    This patch adds and enables the device-tree definitions for
    both qcom,ipq4019-wifi blocks for the IPQ4019.
    
    Support for these have been added into the ath10k driver since:
    commit 280e762e ("ath10k: enable ipq4019 device probe in ahb module")
    
    The binding documentation was added in:
    commit a47aaa69 ("dt: bindings: add new dt entry for pre calibration in qcom, ath10k.txt")
    
    This has been tested on an ASUS RT-AC58U (IPQ4019),
    an AVM Fritz!Box 4040 (IPQ4018), a Compex WPJ428 (IPQ4028)
    and a Cisco Meraki MR33 (IPQ4029).
    
    | a000000.wifi: qca4019 hw1.0 target 0x01000000 chip_id 0x003b00ff [...]
    | a000000.wifi: kconfig debug 0 debugfs 1 tracing 0 dfs 1 testmode 1
    | a000000.wifi: firmware ver 10.4-3.4-00082 api 5 features no-p2p,mfp,[...]
    | a000000.wifi: board_file api 2 bmi_id 0:16 crc32 5773b188
    | a000000.wifi: htt-ver 2.2 wmi-op 6 htt-op 4 cal pre-cal-file [...]
    ...
    | a800000.wifi: qca4019 hw1.0 target 0x01000000 chip_id 0x003b00ff sub 0000:0000
    | a800000.wifi: kconfig debug 0 debugfs 1 tracing 0 dfs 1 testmode 1
    | a800000.wifi: firmware ver 10.4-3.4-00082 api 5 features no-p2p, [...]
    | a800000.wifi: board_file api 2 bmi_id 0:17 crc32 5773b188
    | a800000.wifi: htt-ver 2.2 wmi-op 6 htt-op 4 cal pre-cal-file [...]
    Signed-off-by: default avatarChristian Lamparter <chunkeey@googlemail.com>
    Signed-off-by: default avatarAndy Gross <andy.gross@linaro.org>
    0d363594
qcom-ipq4019-ap.dk01.1.dtsi 2.17 KB