scsi: hpsa: correct enclosure sas address

The original complaint was the lsscsi -t showed the same SAS address of the
two enclosures (SEP devices). In fact the SAS address was being set to the
Enclosure Logical Identifier (ELI).
Reviewed-by: Scott Teel <scott.teel@microsemi.com>
Reviewed-by: Kevin Barnett <kevin.barnett@microsemi.com>
Signed-off-by: Don Brace <don.brace@microsemi.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

drivers/scsi/hpsa.c

@@ -3440,11 +3440,11 @@ static void hpsa_get_enclosure_info(struct ctlr_info *h,
 	struct ext_report_lun_entry *rle = &rlep->LUN[rle_index];
 	u16 bmic_device_index = 0;
 
-	bmic_device_index = GET_BMIC_DRIVE_NUMBER(&rle->lunid[0]);
-
-	encl_dev->sas_address =
+	encl_dev->eli =
 		hpsa_get_enclosure_logical_identifier(h, scsi3addr);
 
+	bmic_device_index = GET_BMIC_DRIVE_NUMBER(&rle->lunid[0]);
+
 	if (encl_dev->target == -1 || encl_dev->lun == -1) {
 		rc = IO_OK;
 		goto out;
@@ -9697,7 +9697,24 @@ hpsa_sas_get_linkerrors(struct sas_phy *phy)
 static int
 hpsa_sas_get_enclosure_identifier(struct sas_rphy *rphy, u64 *identifier)
 {
-	*identifier = rphy->identify.sas_address;
+	struct Scsi_Host *shost = phy_to_shost(rphy);
+	struct ctlr_info *h;
+	struct hpsa_scsi_dev_t *sd;
+
+	if (!shost)
+		return -ENXIO;
+
+	h = shost_to_hba(shost);
+
+	if (!h)
+		return -ENXIO;
+
+	sd = hpsa_find_device_by_sas_rphy(h, rphy);
+	if (!sd)
+		return -ENXIO;
+
+	*identifier = sd->eli;
+
 	return 0;
 }
 

drivers/scsi/hpsa.h

@@ -68,6 +68,7 @@ struct hpsa_scsi_dev_t {
 #define RAID_CTLR_LUNID "\0\0\0\0\0\0\0\0"
 	unsigned char device_id[16];    /* from inquiry pg. 0x83 */
 	u64 sas_address;
+	u64 eli;			/* from report diags. */
 	unsigned char vendor[8];        /* bytes 8-15 of inquiry data */
 	unsigned char model[16];        /* bytes 16-31 of inquiry data */
 	unsigned char rev;		/* byte 2 of inquiry data */