Commit 032f85c9 authored by Marco Felsch's avatar Marco Felsch Committed by Shawn Guo

ARM: dts: pfla02: increase phy reset duration

Increase the reset duration to ensure correct phy functionality. The
reset duration is taken from barebox commit 52fdd510de ("ARM: dts:
pfla02: use long enough reset for ethernet phy"):

  Use a longer reset time for ethernet phy Micrel KSZ9031RNX. Otherwise a
  small percentage of modules have 'transmission timeouts' errors like

  barebox@Phytec phyFLEX-i.MX6 Quad Carrier-Board:/ ifup eth0
  warning: No MAC address set. Using random address 7e:94:4d:02:f8:f3
  eth0: 1000Mbps full duplex link detected
  eth0: transmission timeout
  T eth0: transmission timeout
  T eth0: transmission timeout
  T eth0: transmission timeout
  T eth0: transmission timeout

Cc: Stefan Christ <s.christ@phytec.de>
Cc: Christian Hemp <c.hemp@phytec.de>
Signed-off-by: default avatarMarco Felsch <m.felsch@pengutronix.de>
Fixes: 3180f956 ("ARM: dts: Phytec imx6q pfla02 and pbab01 support")
Signed-off-by: default avatarShawn Guo <shawnguo@kernel.org>
parent 91740fc8
...@@ -91,6 +91,7 @@ &fec { ...@@ -91,6 +91,7 @@ &fec {
pinctrl-0 = <&pinctrl_enet>; pinctrl-0 = <&pinctrl_enet>;
phy-handle = <&ethphy>; phy-handle = <&ethphy>;
phy-mode = "rgmii"; phy-mode = "rgmii";
phy-reset-duration = <10>; /* in msecs */
phy-reset-gpios = <&gpio3 23 GPIO_ACTIVE_LOW>; phy-reset-gpios = <&gpio3 23 GPIO_ACTIVE_LOW>;
phy-supply = <&vdd_eth_io_reg>; phy-supply = <&vdd_eth_io_reg>;
status = "disabled"; status = "disabled";
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment