Commit 06bb8358 authored by Wey-Yi Guy's avatar Wey-Yi Guy

iwlagn: use IWL_DEBUG_FW for firmware related debug msg

Instead use generic IWL_DEBUG_INFO, use IWL_DEBUG_FW for uCode related stuffs.
Signed-off-by: default avatarWey-Yi Guy <wey-yi.w.guy@intel.com>
parent f38f884b
......@@ -143,7 +143,7 @@ static int iwlagn_load_section(struct iwl_priv *priv, const char *name,
FH_TCSR_TX_CONFIG_REG_VAL_DMA_CREDIT_DISABLE |
FH_TCSR_TX_CONFIG_REG_VAL_CIRQ_HOST_ENDTFD);
IWL_DEBUG_INFO(priv, "%s uCode section being loaded...\n", name);
IWL_DEBUG_FW(priv, "%s uCode section being loaded...\n", name);
ret = wait_event_interruptible_timeout(priv->wait_command_queue,
priv->ucode_write_complete, 5 * HZ);
if (ret == -ERESTARTSYS) {
......@@ -508,7 +508,7 @@ static int iwlcore_verify_inst_sparse(struct iwl_priv *priv,
u32 val;
u32 i;
IWL_DEBUG_INFO(priv, "ucode inst image size is %u\n", len);
IWL_DEBUG_FW(priv, "ucode inst image size is %u\n", len);
for (i = 0; i < len; i += 100, image += 100/sizeof(u32)) {
/* read data comes through single port, auto-incr addr */
......@@ -533,7 +533,7 @@ static void iwl_print_mismatch_inst(struct iwl_priv *priv,
u32 offs;
int errors = 0;
IWL_DEBUG_INFO(priv, "ucode inst image size is %u\n", len);
IWL_DEBUG_FW(priv, "ucode inst image size is %u\n", len);
iwl_write_direct32(priv, HBUS_TARG_MEM_RADDR,
IWLAGN_RTC_INST_LOWER_BOUND);
......@@ -559,7 +559,7 @@ static void iwl_print_mismatch_inst(struct iwl_priv *priv,
static int iwl_verify_ucode(struct iwl_priv *priv, struct fw_img *img)
{
if (!iwlcore_verify_inst_sparse(priv, &img->code)) {
IWL_DEBUG_INFO(priv, "uCode is good in inst SRAM\n");
IWL_DEBUG_FW(priv, "uCode is good in inst SRAM\n");
return 0;
}
......@@ -583,7 +583,7 @@ static void iwlagn_alive_fn(struct iwl_priv *priv,
palive = &pkt->u.alive_frame;
IWL_DEBUG_INFO(priv, "Alive ucode status 0x%08X revision "
IWL_DEBUG_FW(priv, "Alive ucode status 0x%08X revision "
"0x%01X 0x%01X\n",
palive->is_valid, palive->ver_type,
palive->ver_subtype);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment