Commit 0719bc3a authored by Dmitry Torokhov's avatar Dmitry Torokhov Committed by Jakub Kicinski

net: fec: do not double-parse 'phy-reset-active-high' property

Conversion to gpiod API done in commit 468ba54b ("fec: convert
to gpio descriptor") clashed with gpiolib applying the same quirk to the
reset GPIO polarity (introduced in commit b02c85c9). This results in
the reset line being left active/device being left in reset state when
reset line is "active low".

Remove handling of 'phy-reset-active-high' property from the driver and
rely on gpiolib to apply needed adjustments to avoid ending up with the
double inversion/flipped logic.

Fixes: 468ba54b ("fec: convert to gpio descriptor")
Signed-off-by: default avatarDmitry Torokhov <dmitry.torokhov@gmail.com>
Reviewed-by: default avatarAndrew Lunn <andrew@lunn.ch>
Link: https://lore.kernel.org/r/20230201215320.528319-2-dmitry.torokhov@gmail.comSigned-off-by: default avatarJakub Kicinski <kuba@kernel.org>
parent d7b5e5dd
......@@ -4036,7 +4036,6 @@ static int fec_enet_init(struct net_device *ndev)
static int fec_reset_phy(struct platform_device *pdev)
{
struct gpio_desc *phy_reset;
bool active_high = false;
int msec = 1, phy_post_delay = 0;
struct device_node *np = pdev->dev.of_node;
int err;
......@@ -4054,10 +4053,8 @@ static int fec_reset_phy(struct platform_device *pdev)
if (!err && phy_post_delay > 1000)
return -EINVAL;
active_high = of_property_read_bool(np, "phy-reset-active-high");
phy_reset = devm_gpiod_get_optional(&pdev->dev, "phy-reset",
active_high ? GPIOD_OUT_HIGH : GPIOD_OUT_LOW);
GPIOD_OUT_HIGH);
if (IS_ERR(phy_reset))
return dev_err_probe(&pdev->dev, PTR_ERR(phy_reset),
"failed to get phy-reset-gpios\n");
......@@ -4070,7 +4067,7 @@ static int fec_reset_phy(struct platform_device *pdev)
else
usleep_range(msec * 1000, msec * 1000 + 1000);
gpiod_set_value_cansleep(phy_reset, !active_high);
gpiod_set_value_cansleep(phy_reset, 0);
if (!phy_post_delay)
return 0;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment